Fatigue Bearing Capacity of Anchors exposed to Shear Loading
Source abstract
Abstract
Tests on M12 chemical anchors were conducted to determine the effect of concrete properties on the fatigue bearing capacity of anchors under shear loading. The properties of the concrete analysed included compression strength and a crack of 0.3 mm width compared with the non-cracked concrete. The results obtained produced a Wöhler curve for each of the four test series. Furthermore, a function was developed for cracked and non-cracked concrete, which allows the estimation of the fatigue bearing capacity of bonded anchors in concrete of any compression strength. In the technical approvals issued so far, only worst-case values of fatigue bearing capacity have been given. It was also possible to recognise many characteristics of the fracture and recorded parameters, which allow conclusions about the type of failure. This makes the planning of future tests easier.
Source: openalex_inverted_index · Quality: baseline
Research context
OpenAlex topics: Structural Behavior of Reinforced Concrete · Concrete Corrosion and Durability · Fire effects on concrete materials
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (10)
Show source-provided references
1. DIBt: Allgemeine bauaufsichtliche Zulassung (General building type approval) Z-21.3-1662 für den Upat multicone Verbundanker (chemical anchor) dynamic. 19. September 1999.
2. DIBt: Allgemeine bauaufsichtliche Zulassung (General building type approval) Z-21.1-1693 für den Hilti Hinterschnittdübel (undercut anchor) HDA dynamic. 4. September 2001.
3. DIBt: Allgemeine bauaufsichtliche Zulassung (General building type approval) Z-21.3-1692 für den Hilti Verbundanker (chemical anchor) HVZ dynamic. 16. Oktober 1999.
4. DIBt: Allgemeine bauaufsichtliche Zulassung (General building type approval) Z-21.3-1748 für den Fischer Verbundanker (chemical anchor) FHB-dynamic. 20. Mai 2003.
5. Barsom, J. M. und Rolfe, S. T.: Fracture and fatigue control in structures, 3. Edition. Philadelphia, PA, November 1999.
6. Block, K. und Dreier, F.: Das Ermüdungstragverhalten von Dübelbefestigungen (The fatigue bearing behaviour of anchor fastenings). Deutscher Ausschuss für Stahlbeton, Heft 541, 2003.
7. Block · Materialprüfung · 1998 · 40 · 73
8. Altstädt, V.: Hysteresismessung zur Charakterisierung der mechanischen Eigenschaften von R-SMC (Measurement of hysteresis to characterise the mechanical properties of R-SMC). Gesamthochschule Kassel: Dissertation 1987.
9. Ehrenstein · Bauingenieur · 1995
10. ETAG Nr. 001: Leitlinie für die europäische technische Zulassung für Metalldübel zur Verankerung im Beton (Guideline for the European technical approval of metal anchors for fastening in concrete) (Teile 1 bis 5, Anhang A, B, C). 1997–2002.