Experimental Investigation of Multiphysics Responses of Pouch Lithium-Ion Batteries Under Quasi-Static Compression and Dynamic Impact
Source abstract
Abstract
Lithium-ion batteries are prone to internal short-circuits and subsequent thermal runaway under compression and impact loads during electric vehicle crashes, posing a critical safety challenge for the industry. However, existing studies lack systematic comparative analysis between quasi-static and dynamic loading conditions. In this study, ternary pouch lithium-ion batteries were used as research objects. A test platform for the synchronous acquisition of mechanical load, electrical voltage and thermal temperature was established. Quasi-static compression and drop-weight impact tests were conducted to investigate the effects of indenter diameter, impact velocity and state of charge (SOC) on the multiphysics responses of batteries. The results show significant differences in failure modes between the two loading conditions: quasi-static loading causes progressive plastic deformation and stable short-circuit voltage decay, while dynamic loading is likely to induce brittle shear fracture and soft short-circuit voltage rebound. Dynamic loading reduces peak load by 61.5% and raises peak temperature by up to 46.7%, while also decreasing failure displacement and advancing time-to-peak. Additionally, a high SOC (50% and 100%) alters the heat-release pathway during thermal runaway, leading to deviations in surface temperature measurements. These findings provide critical experimental support for the crash safety design of power batteries and the formulation of thermal runaway prevention and control strategies.
Source: crossref · Quality: baseline
Research context
OpenAlex topics: Advanced Battery Technologies Research · Electronic Packaging and Soldering Technologies · Electric Vehicles and Infrastructure
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
Affiliations
School of Mechanical and Electrical Engineering, Fujian Agriculture and Forestry University, Fuzhou 350108, China
Xiamen Products Quality Supervision & Inspection Institute, Xiamen 361000, China
Key Laboratory of Safety Detection and Evaluation Technology of New Energy Batteries with High Specific Energy, State Administration for Market Regulation, Xiamen 361000, China
Funding
Natural Science Foundation of Fujian Province
References (27)
Show source-provided references
1. (2026, April 17). Central Committee of the Communist Party of China State Council Opinions on Fully, Accurately and Comprehensively Implementing the New Development Concept to Achieve Carbon Peaking and Carbon Neutrality, Available online: https://www.gov.cn/zhengce/2021-10/24/content_5644613.htm.
2. Quantitative Analysis of Policy Texts on New Energy Vehicle Batteries in China
3. Research on the Optimization of Integrated Energy Systems Considering the Interaction between Electric Vehicle Swap Stations and Multi-Energy Regulation
4. Innovation-Driven Developments in Automotive Lithium-Ion Battery Technologies: A Patent-Based Comparison of China and the United States
5. Modelling of Cracks Developed in Lithium-Ion Cells under Mechanical Loading10.1039/C5RA17865G ↗
6. Characterizing and Modeling Mechanical Properties and Onset of Short Circuit for Three Types of Lithium-Ion Pouch Cells10.1016/j.jpowsour.2013.08.056 ↗
7. Comparative Study of Mechanical-Electrical-Thermal Responses of Pouch, Cylindrical, and Prismatic Lithium-Ion Cells under Mechanical Abuse10.1007/s11431-017-9296-0 ↗
8. Mechanical Damage in a Lithium-Ion Pouch Cell under Indentation Loads10.1016/j.jpowsour.2017.04.101 ↗
9. Strain Rate Dependent Plasticity of Lithium-Ion Pouch Cells: Experiments and Simulations10.1016/j.ijimpeng.2021.104048 ↗
10. Dynamic Multi-Physics Behaviors and Performance Loss of Cylindrical Batteries upon Low-Velocity Impact Loading10.1002/eem2.12771 ↗
11. Effects of Impact Mass on Dynamic Mechanical Responses and Failure Modes of Square Lithium-Ion Batteries under Impact Loading
12. Li, Z.J. (2021). Load Deformation Failure Test and Simulation Analysis for Internal Configuration of Prismatic Lithium-Ion Batteries on New Energy Vehicle. [Ph.D. Thesis, South China University of Technology].
13. Safety Issues Caused by Internal Short Circuits in Lithium-Ion Batteries10.1039/C8TA08997C ↗
14. Different Mechanical-Electrochemical Coupled Failure Mechanism and Safety Evaluation of Lithium-Ion Pouch Cells under Dynamic and Quasi-Static Mechanical Abuse10.1016/j.jpowsour.2021.229897 ↗
15. Modeling of Dynamic Mechanical Response of Li-Ion Cells with Homogenized Electrolyte-Solid Interactions10.1016/j.est.2022.104069 ↗
16. Mechanical Modeling and Testing of Pouch Cells under Various Loading Conditions10.1149/1945-7111/abbce0 ↗
17. Mechanical-Electrical-Thermal Responses of Lithium-Ion Pouch Cells under Dynamic Loading: A Comparative Study between Fresh Cells and Aged Ones10.1016/j.ijimpeng.2022.104237 ↗
18. (2025). Standardization Administration of China. Safety Requirements for Traction Batteries for Electric Vehicles (Standard No. GB/T 38031-2025).
19. Failure in Lithium-Ion Batteries under Transverse Indentation Loading10.1016/j.jpowsour.2018.04.003 ↗
20. (2017). Secondary Cells and Batteries Containing Alkaline or Other Non-Acid Electrolytes—Safety Requirements for Portable Sealed Secondary Lithium Cells, and for Batteries Made from Them, for Use in Portable Applications—Part 2: Lithium Systems (Standard No. IEC 62133-2:2017).
21. (2022). Lithium Ion Cells and Batteries Used in Portable Electronic Equipments—Safety Requirements (Standard No. GB 31241-2022).
22. Temperature Dependence in Responses of Lithium-ion Pouch Cells under Mechanical Abuse10.1149/1945-7111/ace001 ↗
23. A Comprehensive Review on Thermal Runaway Model of a Lithium-ion Battery: Mechanism, Thermal, Mechanical, Propagation, Gas Venting and Combustion10.1016/j.renene.2024.120762 ↗
24. Predicting Thermal Runaway Propagation in Lithium-ion Batteries: An Experimental and Theoretical Study10.1016/j.applthermaleng.2025.127780 ↗
25. Study on Expansion Internal Stress of LFP Battery during Charging or Discharging
26. Luo, H.L. (2018). Structural Failure Mechanism and Modelling of Lithium-Ion Battery Pouch Cell Under Mechanical Abuse. [Ph.D. Thesis, Tsinghua University].
27. Dynamic Response Characteristics of Soft-Pack Lithium Batteries for Light Weight Consumer Drones under Mechanical Strong Impact Loads