ELUCIDATION OF INTERNAL FLOW AND ITS EFFECT ON THE JET OF A TWIN-FLUID ATOMIZER FOR GAS TURBINE CROSSFLOW COMBUSTORS
Source abstract
Abstract
Conventional liquid fuel jet injection into a crossflow is widely used for large-scale power generation in gas turbine combustors. The authors proposed a new twin-fluid injection technique as a potential alternative and conducted a series of studies on the internal flow of the atomizer and liquid jet/spray characteristics. In this study, experimental and numerical studies were first performed on internal flow behaviors and liquid and atomizing air interactions. The important behaviors of the internal flow of the atomizer, such as the dynamic change in the liquid film thickness, the rapidly changing velocity of the wave front, and the liquid impingement distance on the inner wall of the atomizer, were measured by both the experiment and numerical analysis. Atomizing air generates a high-speed oscillating annular liquid film flow that flows at the exit of a twin-fluid atomizer. This dynamic of the annular liquid film is considered fairly advantageous for achieving good atomization, which is investigated by analyzing only the liquid's behaviors in jet/spray and twin-fluid injection in a crossflow. High-speed photography and image processing were applied to observe the liquid jet/spray phenomena in the crossflow and reveal the atomization characteristics such as jet/spray trajectories and breakup length. Furthermore, the atomizing air can dominate the trajectory of the liquid jet/spray in the crossflow. The twin-fluid injection provides improved atomization properties compared to conventional liquid-only injection.
Source: crossref · Quality: baseline
Research context
OpenAlex topics: Fluid Dynamics and Heat Transfer · Combustion and flame dynamics · Particle Dynamics in Fluid Flows
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (32)
Show source-provided references
1. Aalburg, C., van Leer, B., Faeth, G.M., and Sallam, K.A., Properties of Nonturbulent Round Liquid Jets in Uniform Gaseous Cross Flows, Atomization Sprays, vol. 15, pp. 271-294, 2005. DOI: 10.1615/AtomizSpr.v15.i3.2010.1615/AtomizSpr.v15.i3.20 ↗
2. Adelberg, M., Breakup Rate and Penetration of a Liquid Jet in a Gas Stream, AIAA J, vol. 5, no. 8, pp. 1408-1415, 1967. DOI: 10.2514/3.421310.2514/3.4213 ↗
3. Azzopardi, B.J., Drops in Annular Two-Phase Flow, Int. J. Multiphase Flow, vol. 23, Suppl., pp. 1-53, 1997.10.1016/S0301-9322(97)00087-6 ↗
4. Barreras, F., Lozano, A., Barroso, J., and Lincheta, E., Experimental Characterization of Industrial Twin-Fluid Atomizers, Atomization Sprays, vol. 16, pp. 127-145, 2006. DOI: 10.1615/AtomizSpr.v16.i2.1010.1615/AtomizSpr.v16.i2.10 ↗
5. Barreras, F., Lozano, A., Ferreira, G., and Lincheta, E., The Effect of the Inner Flow on the Performance of a Twin-Fluid Nozzle with an Internal Mixing Chamber, Proc. of ILASS Europe Conf, Como, Italy, 2008.
6. Behzad, M., Ashgriz, N., and Karney, B.W., Surface Breakup of a Non-Turbulent Liquid Jet Injected into a High-Pressure Gaseous Crossflow, Int. J. Multiphase Flow, vol. 80, pp. 100-117, 2016. DOI: 10.1016/j.ijmultiphaseflow.2015.11.00710.1016/j.ijmultiphaseflow.2015.11.007 ↗
7. Bolszo, C.D., McDonell, V.G., Gomez, G.A., and Samuelsen, G.S., Injection of Water-In-Oil Emulsion Jets into a Subsonic Crossflow: An Experimental Study, Atomization Sprays, vol. 24, pp. 303-348, 2014. DOI: 10.1615/AtomizSpr.201400841510.1615/AtomizSpr.2014008415 ↗
8. Brackbill, J.U., Kothe, D.B., and Zemach, C., A Continuum Method for Modeling Surface Tension, J. Comput. Phys, vol. 100, pp. 335-354, 1992.10.1016/0021-9991(92)90240-Y ↗
9. Broumand, M. and Birouk, M., Effect of Nozzle-Exit Conditions on the Near-Field Characteristics of a Transverse Liquid Jet in a Subsonic Uniform Cross Airflow, Phys. Fluids, vol. 29, p. 113303, 2017. DOI: 10.1063/1.499497810.1063/1.4994978 ↗
10. Chin, J.S. andLefebvre, A.H., Flow Patterns in Internal-Mixing, Twin-Fluid Atomizer, Atomization Sprays, vol. 3, pp. 463-475, 1993. DOI: 10.1615/AtomizSpr.v3.i4.6010.1615/AtomizSpr.v3.i4.60 ↗
11. Hashiguchi, K., Yamane, F., Fujii, H., Sato, K., andNishida, K., Development of Internal Mixing Multi Exit Port Twin Fluid Atomizer for Heavy Oil-Fired Boilers (1st Report, Internal Flow Analysis and Spray Characteristics), Atomization: J. ILASS-Japan, vol. 27, no. 90, pp. 11-17, 2018. (in Japanese)
12. Hashiguchi, K., Yamane, F., Fujii, H., Sato, K., andNishida, K., Development of Internal-Mixing Twin-Fluid Atomizer with Multiple Exit Ports for Heavy Oil-Fired Boilers, Atomization Sprays, vol. 29, pp. 161-176,2019. DOI: 10.1615/AtomizSpr.201902945610.1615/AtomizSpr.2019029456 ↗
13. Inamura, T. andNagai, N., Trans. Jpn. Soc. Mech. Eng., vol. 51, no. 461, pp. 222-231, 1985. (in Japanese)10.1299/kikaib.51.222 ↗
14. Inamura, T. andNagai, N., Spray Characteristics of Liquid Jet Traversing Subsonic Airstreams, J. Propuls. Power, vol. 13, no. 2, pp. 250-256, 1997.10.2514/2.5156 ↗
15. Ishii, M. and Grolmes, M.A., Inception Criteria for Droplet Entrainment in Two-Phase Concurrent Film Flow, AIChEJ., vol. 21, no. 2, pp. 308-318, 1975.10.1002/aic.690210212 ↗
16. Liu, L., Fu, Q., and Yang, L., Linear Stability Analysis of Liquid Jets Exposed to Subsonic Crossflow with Aluminum Particles and Surfactant, Atomization Sprays, vol. 31, pp. 47-69,2021. DOI: 10.1615/AtomizSpr.202003550110.1615/AtomizSpr.2020035501 ↗
17. Mkvik, M., Smolar, M., and Olsiak, R., Numerical Investigation of the Twin-Fluid Atomizers Internal Flows, Proc. AIP Conf., vol. 1768, pp. 020035-1-020035-6, 2016.10.1063/1.4963057 ↗
18. Nagai, N. and Inamura, T., Trans. Jpn. Soc. Mech. Eng., vol. 49, no. 439, pp. 609-619, 1983. (in Japanese)10.1299/kikaib.49.609 ↗
19. Ng, C.-L., Sankarakrishnan, R., and Sallam, K.A., Bag Breakup of Nonturbulent Liquid Jets in Crossflow, Int. J. Multiphase Flow, vol. 34, no. 3, pp. 241-259,2008. DOI: 10.1016/j.ijmultiphaseflow.2007.07.00510.1016/j.ijmultiphaseflow.2007.07.005 ↗
20. Nigmatulin, R.I., Nigmatulin, B.I., Khodzhaev, Y.A.D., and Kroshilin, V.E., Entrainment and Deposition Rates in a Dispersed-Film Flow, Int. J. Multiphase Flow, vol. 22, no. 1, pp. 19-30, 1996.10.1016/0301-9322(95)00044-5 ↗
21. Noda, J., Miyazaki, K., Aoki, K., and Hashiguchi, K., Combustion Technology Supporting the Development of Oil-Fired Combustors for Dual Fuel-Fired Gas Turbines, Mitsubishi Heavy Indust. Tech. Rev., vol. 57, no. 1,pp. 1-6,2020.
22. Oda, T. and Hiroyasu, H., Characteristics of Spatial Distribution of a Bubbling Liquid Jet Across a High-Speed Airstream, J. Jpn. Soc. Aeronaut. Space Sci., vol. 45, no. 518, pp. 154-161,1997. (in Japanese)10.2322/jjsass1969.45.154 ↗
23. Oshima, I., Sou, A., and Matsuura, K., Numerical and Experimental Study on Liquid Sheet Deformation by Air Flow, in Proc. of 13th ICLASS Conf., Tainan, Taiwan, 2015.
24. Oshima, I., Sou, A., Kawabata, R., and Matsuura, K., Longitudinal Wavelength of Oscillating Liquid Sheet with Air Flow, in Proc. of the 55th AIAA Aerospace Science Meeting, Grapevine, TX, 2017.10.2514/6.2017-1464 ↗
25. Sato, K., Okiura, K., Baba, A., Shoji, K., and Akiyama, I., A Study on the Atomization of Coal Water Mixture (1st Report, Atomizing Characteristics), Trans. Jpn. Soc. Mech. Eng., Ser. B, vol. 53, no. 493, pp. 2890-2895, 1987a. (in Japanese)10.1299/kikaib.53.2890 ↗
26. Song, S.H. and Lee, S.Y., Study of Atomization Mechanism of Gas/Liquid Mixtures Flowing through Y-Jet Atomizer, Atomization Sprays, vol. 6, pp. 193-209, 1996. DOI: 10.1615/AtomizSpr.v6.i2.4010.1615/AtomizSpr.v6.i2.40 ↗
27. Wang, Q., Mondragon, U.M., Brown, C.T., and McDonell, V.G., Characterization of Trajectory, Break Point, and Break Point Dynamics of a Plain Liquid Jet in a Crossflow, Atomization Sprays, vol. 21, pp. 203-219,2011. DOI: 10.1615/AtomizSpr.201100284810.1615/AtomizSpr.2011002848 ↗
28. Wu, P.K., Kirkendall, K.A., Fuller, R.P., and Nejad, A.S., Breakup Processes of Liquid Jets in Subsonic Crossflow, J. Propuls. Power, vol. 13, no. 1, pp. 64-73,1997.10.2514/2.5151 ↗
29. Xing, W., Hashiguchi, K., Sato, K., Nishida, K., and Ogata, Y., Behaviors of Internal Flow and Liquid Jet of Twin-Fluid Atomizer, Atomization: J. ILASS-Japan, vol. 29, no. 98, pp. 84-94,2020. (in Japanese)10.1299/jsmemecj.2020.S05104 ↗
30. Xing, W., Sato, K., Nishida, K., Ogata, Y., and Hashiguchi, K., Breakup Behaviours and Spray Characteristics of Liquid Jets Injected from Twin-Fluid Atomizer into Crossflow, Trans. Jpn. Soc. Mech. Eng., vol. 87, no. 899, p. 21-00148, 2021a. (in Japanese)10.1299/transjsme.21-00148 ↗
31. Xing, W., Nishida, K., Ogata, Y., Sato, K., and Hashiguchi, K., Characterization of Liquid and Air Flow Behaviors in Twin Fluid Atomizer for Gas Turbine Combustor, Proc. of 15th ICLASS Conf., Edinburgh, UK, 2021b.10.2218/iclass.2021.5944 ↗
32. Zaremba, M., Weiss, L., Maly, M., Wensing, M., Jedelsky, J., and Jicha, M., Low-Pressure Twin-Fluid Atomization: Effect of Mixing Process on Spray Formation, Int. J. Multiphase Flow, vol. 89, pp. 277-289,2017. DOI: 10.1016/j.ijmultiphaseflow.2016.10.01510.1016/j.ijmultiphaseflow.2016.10.015 ↗