journal article·1992

BOUNDARY-LAYER CHARACTERISTICS OF A SWIRL ATOMIZER

Christophe Dumouchel, M. I. G. Bloor, N. Dombrowski, Derek B. Ingham, M. Ledoux

Atomization and Sprays· Volume 2· Issue 3
Publisher page

Abstract

The Bloor and Ingham analysis for the boundary-layer flow above aflat disk has been used for the case of a swirling flow in a conical nozzle, and the proportion of the fluid that enters the orifice through the boundary layer has been estimated. Comparisons of these results with measured flow rates indicate that the flow through the boundary layer represents almost all the outflow from a swirl atomizer over a wide range of injection pressures when the radius of the orifice and the radius of the inlet groove are relatively small compared to the radius of the swirl chamber, but that it may be neglected for small injection pressures and large radii of the orifice and the inlet groove.
Source: openalex_inverted_index · Quality: baseline

Research context

OpenAlex topics: Fluid Dynamics and Heat Transfer · Particle Dynamics in Fluid Flows · Plasma and Flow Control in Aerodynamics

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References

Reference metadata was not supplied for this record.