EXPERIMENTAL STUDY ON SPRAY MICROSCOPIC CHARACTERISTICS IN CROSS FLOW: DROPLET MORPHOLOGY, STATISTICS AND BREAKUP
Source abstract
Abstract
The spray microscopic characteristics in cross-flow were experimentally investigated by using a single-hole GDI (Gasoline Direct Injection) injector and an optical wind tunnel. A PIA (Particle Image Analysis) system with double pulse laser illumination was employed for droplet detecting at a series of measurement points in both windward region and leeward region. The droplet morphology, statistics and breakup process are sequentially examined. Large amounts of ligaments and large droplets were detected at the windward region while dispersed small droplets were observed at the leeward region. Qualitative analysis of the droplet images shows that the undesired large ligaments and droplets are less in number and smaller in size for higher cross-flow velocity condition. Quantitative analysis of local droplet size distributions shows that smaller droplets get more affected by the air flow and hence penetrate farther in the radial direction leading to an expanded dilute spray region. It is indicated that cross-flow improve the atomization quality. Along the air flow direction, the droplet SMD (Sauter Mean Diameter) is decreased, the horizontal mean velocity is increased, while fluctuations caused by the vortexes were also detected in some special locations. Statistical analysis of droplet Weber number shows that the droplet breakup is relatively active in the upstream region, and gradually weakened along the axial direction and also the air flow direction. In addition, the droplet vibrational breakup, bag breakup and sheet stripping breakup were identified in the spray.
Source: openalex_inverted_index · Quality: baseline
Research context
OpenAlex topics: Fluid Dynamics and Heat Transfer · Combustion and flame dynamics · Particle Dynamics in Fluid Flows
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (35)
Show source-provided references
1. Surface Breakup of a Non-Turbulent Liquid Jet Injected into a High Pressure Gaseous Crossflow10.1016/j.ijmultiphaseflow.2015.11.007 ↗
2. Comparison of Particle Size and Velocity Investigation in Sprays Carried Out by Means of Different Measurement Techniques
3. Time-Resolved Droplet Size and Velocity Distributions in a Dilute Region of a High-Pressure Pulsed Diesel Spray10.1016/j.ijheatmasstransfer.2018.12.147 ↗
4. Fujimoto, H.G., Hori, T., Senda, J., Nakagawa, H., Kamata, S., and Katsuta, K., Visualization of Micro Structure in a Diesel Spray by Use of Photography with High Spatial Resolution, SAE Tech. Paper No. 2008-01-2465,2008.10.4271/2008-01-2465 ↗
5. New Droplet Aero-Breakup Mechanism Associated to Unsteady Flow Loading10.1016/j.expthermflusci.2020.110290 ↗
6. Structural and Stability Characteristics of Jets in Crossflow10.1017/jfm.2014.605 ↗
7. Spray Jets in a Cross-Flow10.1017/S0022112098001190 ↗
8. Effects of Cross-Flow on Fuel Spray Injected by Hole-Type Injector Gasoline for Direct-Injection Gasoline Enging10.1615/AtomizSpr.2015012195 ↗
9. Effect of Flash Boiling on Microscopic and Macroscopic Spray Characteristics in Optical GDI Engine10.1016/j.fuel.2016.11.043 ↗
10. Experimental Study on Fuel Spray Characteristics under Atmospheric and Pressurized Cross-Flow Conditions, Second Report: Spray Distortion, Spray Area, and Spray Volume10.1016/j.fuel.2017.05.088 ↗
11. Experimental Study on Fuel Spray Characteristics under Atmospheric and Pressurized Cross-Flow Conditions10.1016/j.fuel.2016.07.083 ↗
12. Drop Deformation and Breakup Due to Shock Wave and Steady Disturbances10.1016/0301-9322(94)00095-2 ↗
13. Air-Liquid Interactions in a Pressure-Swirl Spray10.1016/j.ijheatmasstransfer.2018.01.003 ↗
14. A Digital Image Analysis Technique for Quantitative Characterisation of High-Speed Sprays10.1016/j.optlaseng.2006.03.006 ↗
15. Spatial Drop-Sizing in Airblast Atomization-An Experimental Study10.1615/AtomizSpr.2017021428 ↗
16. Experimental Study on Spray Break-Up and Atomization Processes from GDI Injector Using High Injection Pressure Up to 30MPa10.1016/j.ijheatfluidflow.2013.11.005 ↗
17. Multiscale Descriptions of Particle-Droplet Interactions in Multiphase Spray Processing10.1016/j.ijmultiphaseflow.2015.10.013 ↗
18. Experimental Study on Fusion and Break-Up Motion after Droplet Collision10.1016/j.cjche.2019.09.002 ↗
19. Spray Development and Droplet Characteristics of High Temperature Single-Hole Gasoline Spray10.1016/j.fuel.2016.11.068 ↗
20. Microscopic Behavior of Spray Droplets under Flat-Wall Impinging Condition10.1016/j.fuel.2018.01.059 ↗
21. Mitroglou, N., Nouri, J.M., Yan, Y., Gavaises, M., and Arcoumanis, C., Spray Structure Generated by Multi-Hole Injectors for Gasoline Direct-Injection Engines, SAE Tech. Paper No. 2007-01-1417, 2007.10.4271/2007-01-1417 ↗
22. Breakup and Atomization Characteristics of Mono-Dispersed Diesel Droplets in a Cross-Flow Air Stream10.1016/j.ijmultiphaseflow.2006.02.019 ↗
23. Atomization and Spray Characteristics of Bioethanol and Bioethanol Blended Gasoline Fuel Injected through a Direct Injection Gasoline Injector10.1016/j.ijheatfluidflow.2009.07.002 ↗
24. Simulation of Liquid Jet Primary Breakup: Dynamics ofLigament and Droplet Formation10.1016/j.ijmultiphaseflow.2010.03.008 ↗
25. Effect of Cross-Flow on Spray Structure, Droplet Diameter and Velocity of Impinging Spray10.1016/j.fuel.2018.07.061 ↗
26. Experimental Study on Impingement Spray and Near-Field Spray Characteristics under High-Pressure Cross-Flow Conditions10.1016/j.fuel.2018.01.011 ↗
27. Airblast Spray in Crossflow-Structure, Trajectory and Droplet Sizing10.1016/j.ijmultiphaseflow.2015.02.008 ↗
28. Determination of Erosion Rate Characteristic for Particles with Size Distributions in the Low Stokes Number Range10.1016/j.wear.2013.06.009 ↗
29. Experimental Statistics of Micrometer-Sized Water Droplet Deformation and Breakup Behavior in Continuous Air Jet Flow10.1016/j.ijmultiphaseflow.2020.103529 ↗
30. Comparison of Secondary Breakup Models for Droplet-Laden Compressor Flows10.1016/j.ijmultiphaseflow.2019.04.005 ↗
31. Numerical Analysis of Deposit Effect on Nozzle Flow and Spray Characteristics of GDI Injectors, Appl. Energy
32. An Experimental Investigation of the Breakup Characteristics of Secondary Atomization of Emulsified Fuel Droplet10.1016/j.energy.2009.08.021 ↗
33. Deformation and Breakup of Liquid Drops in a Gas Stream at Nearly Critical Weber Numbers10.1007/BF00575336 ↗
34. Droplet Dispersion Characteristics of the Hollow Cone Sprays in Crossflow10.1016/j.expthermflusci.2012.09.021 ↗
35. Transition Weber Number between Surfactant-Laden Drop Bag Breakup and Shear Breakup of Secondary Atomization10.1016/j.fuel.2018.02.119 ↗