article·2017-07-15

New forming possibilities in cross wedge rolling processes

Z. Pater, J. Tomczak, Tomasz Bulzak

Publisher page

Abstract

Abstract The paper describes limitations in the process of cross wedge rolling (CWR). The problem of necking (rupture) of a shaft step is discussed in detail. In addition, the paper also overviews the state of the art of modelling the cross wedge rolling process by the finite element method-based software, Deform-3D. Next, the paper presents methods for increasing effectiveness in two types of CWR: cross wedge rolling where axial flow of metal is blocked and cross wedge rolling with upsetting. The proposed rolling methods are then verified numerically by Deform-3D. Finally, the presented solutions are verified in experimental tests of a rolling process for producing a lever (with blocked axial flow of metal) and for an upset rolling process for producing a driving shaft.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Metallurgy and Material Forming · Metal Forming Simulation Techniques · Metal Alloys Wear and Properties

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References

Reference metadata was not supplied for this record.