Experimental Studies to Investigate Efficacies of Granite Porphyry Powder as Homologous Manufactured Sand Substitute
Source abstract
Abstract
Stone powder and others waste powder causes serious harm to the environment, society, ecosystem and human well-being, applying it to concrete is a path of green and effective. In this study, a series of tests was carried out on manufactured sand concrete with different granite porphyry powder contents. The results showed that when the stone powder content was lower than 8%, the cracking resistance, compressive strength, chloride ion permeability resistance, and sulfate attack resistance of the concrete were significantly improved with an increase in the stone powder content. Although the early shrinkage rate of the concrete also increased with the increase in the stone powder content, the increase rate was slow. At the microstructure level, an appropriate amount of stone powder exhibited the ‶filling effect" and "nucleation effect," which were conducive to the improvement of the concrete mechanical properties and durability. However, with an increase in the stone powder content, the early shrinkage of the concrete increased sharply when the stone powder content exceeded 8%, and the crack resistance, compressive strength, and chloride ion permeability resistance of the concrete decreased. At this time, the stone powder had a "diversified effect" on the microstructure of the concrete, and the existence of a large amount of stone powder was not conducive to the development of certain properties of the concrete. It is feasible to prepare concrete by replacing manufactured sand with an appropriate amount of stone powder and others waste powder, which can not only improve the performance of concrete, but also save cost, energy, avoid manpower and material consumption in waste powder disposal. The research conclusion shows that the allowable value of the stone powder content can be appropriately increased according to the actual application in concrete, which is an efficient, green disposal path for stone powder and other waste powder.
Source: openalex_inverted_index · Quality: baseline
Research context
OpenAlex topics: Concrete and Cement Materials Research · Innovative concrete reinforcement materials · Recycled Aggregate Concrete Performance
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
Affiliations
School of Civil Engineering, Xi'an University of Architecture & Technology, China.
School of Civil Engineering, Lanzhou Jiaotong University, China.
The 2nd Engineering Co., Ltd. of China Railway 22nd Bureau Group, China.
References (39)
Show source-provided references
1. 1) Aqel, M. and Panesar, D. K., (2016). “Hydration kinetics and compressive strength of steam-cured cement pastes and mortars containing limestone filler.” Construction and Building Materials, 113(15), 359-368.10.1016/j.conbuildmat.2016.03.031 ↗
2. 2) Campos, H. F., Klein, N. S., Marques Filho, J. and Bianchini, M., (2020). “Low-cement high-strength concrete with partial replacement of Portland cement with stone powder and silica fume designed by particle packing optimization.” Journal of Cleaner Production, 261, 121228.10.1016/j.jclepro.2020.121228 ↗
3. 3) Cantero, B., Bravo, M., Brito, J. D., Bosque, I. F. S. D. and Medina, C., (2021). “Water transport and shrinkage in concrete made with ground recycled concrete-additioned cement and mixed recycled aggregate.” Cement and Concrete Composites, 118, 103957.10.1016/j.cemconcomp.2021.103957 ↗
4. 4) Chen, B., Wang, J. L., Yang, Y. H. and Zhou, M. K., (2007). “Effects of stone-dust on resistance to chlorine ion permeating and volume stability of C80 manufactured-sand concrete.” Journal of Wuhan University of Technology, 29(8), 41-43. (in Chinese)
5. 5) Chouhan, H. S., Kall, P., Nagar, R. and Gautam, P. K., (2019). “Influence of dimensional stone waste on mechanical and durability properties of mortar: A review.” Construction and Building Materials, 227, 116662.10.1016/j.conbuildmat.2019.08.043 ↗
6. 6) Deng, D. H., Liu, Z. Q., Geert, D. S. and Liu, Y. H., (2012). “Research progress on theory of sulfate salt weathering on concrete.” Journal of the Chinese Ceramic Society, 40(2),175-785. (in Chinese)
7. 7) Ding, X., Li, C., Xu, Y., Li, F. and Zhao, S., (2016). “Experimental study on long-term compressive strength of concrete with manufactured sand.” Construction and Building Materials, 108, 67-73.10.1016/j.conbuildmat.2016.01.028 ↗
8. 8) Elmoaty, A. and Mohamed, A. E., (2013). “Mechanical properties and corrosion resistance of concrete modified with granite dust.” Construction and Building Materials, 47, 743-752.10.1016/j.conbuildmat.2013.05.054 ↗
9. 9) Guo, Z. H. and Shi, X. D., (2003). “Principle and analysis of reinforced concrete.” Beijing: Qinghua University Press. (in Chinese)
10. 10) Gupta, T., Kothari, S., Siddique, S., Sharma, R. K. and Chaudhary, S., (2019). “Influence of stone processing dust on mechanical, durability and sustainability of concrete.” Construction and Building Materials, 223, 918-927.10.1016/j.conbuildmat.2019.07.188 ↗
11. 11) Li, H. J., Wang, Z., Sun, R. R., Huang, F. L., Yi, Z. L., Yuan, Z. C., Wen, J. X., Lu, L. and Yang, Z. X., (2021). “Effect of different lithological stone powders on properties of cementitious materials.” Journal of Cleaner Production, 289, 125820.10.1016/j.jclepro.2021.125820 ↗
12. 12) Liu, S. H. and Wang, J., (2011). “Influence of limestone powder on pore structure of mortar.” Journal of Building Materials, 14(4), 532-535.
13. 13) Matschei, T., Lothenbach, B. and Glasser, F. P., (2007). “The role of calcium carbonate in cement hydration.” Cement and Concrete Research, 37(4), 551-558.10.1016/j.cemconres.2006.10.013 ↗
14. 14) Nanthagopalan, P. and Santhanam, M., (2011). “Fresh and hardened properties of self-compacting concrete produced with manufactured sand.” Cement and Concrete Composites, 33(3), 353-358.10.1016/j.cemconcomp.2010.11.005 ↗
15. 15) Ramezanianpour, A. A. Ghiasvand, E., Nickseresht, I., Mahdikhani, M. and Moodi, F., (2009). “Influence of various amounts of limestone powder on performance of portland limestone cement concretes.” Cement and Concrete Composites, 31, 715-720.10.1016/j.cemconcomp.2009.08.003 ↗
16. 16) SAC, (2007). “Common Portland cement (GB 175-2007).” The Standardization Administration of the People’s Republic of China, Beijing: China Architecture & Building Press.
17. 17) SAC, (2008). “Pore size distribution and porosity of solid materials by mercury porosimetry and gas adsorption - Part 1: Mercury porosimetry (GB/T 21650.2-2008).” The Standardization Administration of the People’s Republic of China, Beijing: China Architecture & Building Press.
18. 18) SAC, (2009). “Standard for test method for long-term performance and durability of ordinary concrete (GB/T 50082).” The Standardization Administration of the People’s Republic of China, Beijing: China Architecture & Building Press.
19. 19) SAC, (2011). “Sand for construction (GB/T 14684).” The Standardization Administration of the People’s Republic of China, Beijing: China Architecture & Building Press.
20. 20) SAC, (2017a). “Fly ash used for cement and concrete (GB/T 18046).” The Standardization Administration of the People’s Republic of China, Beijing: China Architecture & Building Press.
21. 21) SAC, (2017b). “Ground granulated blast furnace slag used for cement, mortar and concrete (GB/T 1596).” The Standardization Administration of the People’s Republic of China, Beijing: China Architecture & Building Press.
22. 22) SAC, (2019). “Standard for test method of concrete physical and mechanical properties (GB/T 50081).” The Standardization Administration of the People’s Republic of China, Beijing: China Architecture & Building Press.
23. 23) Sato, T. and Beaudoin, J. J., (2011). “Effect of nano-CaCO3 on hydration of cement containing supplementary cementitious materials.” Advances in Cement Research, 23(1), 33-43.10.1680/adcr.9.00016 ↗
24. 24) Shen, W. G., Liu, Y., Wang, Z. W., Cao, L. H., Wu, D. L., Wang, Y. J. and Ji, X. L., (2018). “Influence of manufactured sand's characteristics on its concrete performance.” Construction and Building Materials, 172, 574-583.10.1016/j.conbuildmat.2018.03.139 ↗
25. 25) Sua-iam, G. and Chatveera, B., (2021). “A study on workability and mechanical properties of eco-sustainable self-compacting concrete incorporating PCB waste and fly ash.” Journal of Cleaner Production, 329, 129523.10.1016/j.jclepro.2021.129523 ↗
26. 26) Sua-Iam, G. and Makul, N., (2013). “Utilization of limestone powder to improve the properties of self-compacting concrete incorporating high volumes of untreated rice husk ash as fine aggregate.” Construction and Building Materials, 38(156), 455-464.10.1016/j.conbuildmat.2012.08.016 ↗
27. 27) Vance, K., Aguayo, M., Oey, T., Sant, G. and Neithalath, N., (2013). “Hydration and strength development in ternary portland cement blends containing limestone and fly ash or metakaolin.” Cement and Concrete Composites, 39(5), 93-103.10.1016/j.cemconcomp.2013.03.028 ↗
28. 28) Wang, D. H., Shi, C. J., Farzadnia, N., Shi, Z. G. and Jia, H. F., (2018a). “A review on effects of limestone powder on the properties of concrete.” Construction and Building Materials, 192, 153-166.10.1016/j.conbuildmat.2018.10.119 ↗
29. 29) Wang, D. H., Shi, C. J., Farzadnia, N., Shi, Z. G., Jia, H. F. and Ou, Z. H., (2018b). “A review on use of limestone powder in cement-based materials: Mechanism, hydration and micro-structures.” Construction and Building Materials, 181, 659-672.10.1016/j.conbuildmat.2018.06.075 ↗
30. 30) Wang, J. L., Zhou, M. K., Zhu, L. D. and He, T. S., (2007). “Effects of manufactured-fine aggregates on volume stability of high-strength concrete.” Journal of Wuhan University of Technology, 29(10),20-24. (in Chinese)
31. 31) Wang, X. P., Yu, R., Shui, Z. H., Zhao, Z. M., Song, Q. L., Yang, B. and Fan, D. Q., (2018). “Development of a novel cleaner construction product: Ultra-high performance concrete incorporating lead-zinc tailings.” Journal of Cleaner Production, 196, 172-182.10.1016/j.jclepro.2018.06.058 ↗
32. 32) Wu, K., Shi, H. S., Xu, L. L., Gao, Y. and Ye, G., (2017). “Effect of mineral admixture on mechanical properties of concrete by adjusting interfacial transition zone microstructure.” Journal of the Chinese Ceramic Society, 45(5), 623-630. (in Chinese)
33. 33) Wu, Z. W. and Lian, H. Z., (1999). “High performance concrete.” Beijing: China Railway Publishing House Co., Ltd. (in Chinese)
34. 34) Yang, H. F., Liang, D. Y., Deng, Z. H. and Qin, Y. H., (2018). “Effect of limestone powder in manufactured sand on the hydration products and microstructure of recycled aggregate concrete.” Construction and Building Materials, 188, 1045-1049.10.1016/j.conbuildmat.2018.08.147 ↗
35. 35) Yang, R., Yu, R., Shui, Z. G., Gao, X., Han, J. L., Lin, G., Qian, D., Liu, Z. J. and He, Y. J., (2020). “Environmental and economical friendly ultra-high performance of concrete incorporating appropriate quarry-stone powders.” Journal of Cleaner Production, 260, 121112.10.1016/j.jclepro.2020.121112 ↗
36. 36) Yang, R., Yu, R., Shui, Z. H., Guo, C., Wu, S., Gao, X. and Peng, S., (2019). “The physical and chemical impact of manufactured sand as a partial replacement material in ultra-high performance concrete (UHPC).” Cement and Concrete Composites, 99, 203-213.10.1016/j.cemconcomp.2019.03.020 ↗
37. 37) Zajac, M., Rossberg, A., Saout, G. L. and Lothenbach, B., (2014). “Influence of limestone and anhydrite on the hydration of portland cements.” Cement and Concrete Composites, 46(4), 99-108.10.1016/j.cemconcomp.2013.11.007 ↗
38. 38) Zhang, S. M., (2013). “Basic inorganic chemistry.” Lanzhou: Lanzhou University Press. (in Chinese)
39. 39) Zhang, T. S., (2012). “Optimized matching cement clinker and supplementary cementitious materials.” Thesis (PhD). South China University of Technology. (in Chinese)