Waste Glass Powder as Cement Replacement in Concrete
Source abstract
Abstract
The pozzolanic reactivity of waste glass powder was experimentally studied at cement replacement levels of 0, 15, 30, 45 and 60% by weight. Results revealed that the concrete compressive strength was not decreased by the cement substi-tution after 28 days because of the pozzolanic reaction between glass powders and cement hydration products, if the replacement is below 30%. Also, the resistance to chloride ion and water penetration continuously increases with in-creasing glass powder content up to 60% cement replacement. At 60% replacement level, the electrical resistivity and water penetration depth were reduced by 95% and 80%, respectively, while the compressive strength was maintained as 85%. These improvements in durability properties are due to the refined microstructures, particularly at the interfacial transition zone. Pore size distribution was measured to confirm the refinement in the capillary pores, which partially block the pathways for water and chloride ions. This study also demonstrates that high performance concrete (improved strength and impermeability against chloride and water) could be achieved by using glass powder as 15% additive, which contributes to the pozzolanic reaction instead of being inert fines for compact packing.
Source: openalex_inverted_index · Quality: baseline
Research context
OpenAlex topics: Concrete and Cement Materials Research · Innovative concrete reinforcement materials · Recycling and utilization of industrial and municipal waste in materials production
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
Affiliations
Department of Civil and Environmental Engineering, National University of Singapore, Singapore.
References (34)
Show source-provided references
1. 1) Ali, E. E. and Al-Tersawy, S. H., (2012). “Recycled glass as a partial replacement for fine aggregate in self compacting concrete.” Construction and Building Materials, 35, 785-791.10.1016/j.conbuildmat.2012.04.117 ↗
2. 2) ASTM C 39/C 39M, (2005). “Standard test method for compressive strength of cylindrical concrete specimens.” Philadelphia: American Society of Testing and Materials.
3. 3) ASTM C 109/C 109M, (2005). “Standard test method for compressive strength of hydraulic cement mortars (using 2-in. or [50-mm] cube specimens).” Philadelphia: American Society of Testing and Materials.
4. 4) ASTM C 1202, (2005). “Standard test method for electrical indication of concrete’s ability to resist chloride ion penetration.” Philadelphia: American Society of Testing and Materials.
5. 5) BS EN 12390-8, (2009). “Testing hardened concrete part 8: depth of penetration of water under pressure.” London: British Standards Institution, London.
6. 6) BS EN 12390-3, (2009). “Testing hardened concrete Part 3: compressive strength of test specimens.” London: British Standard Institution.
7. 7) Carsana, M., Frassoni, M. and Bertolini, L., (2014). “Comparison of ground waste glass with other supplementary cementitious materials.” Cement and Concrete Composites, 45, 39-45.10.1016/j.cemconcomp.2013.09.005 ↗
8. 8) Du, H. and Tan, K. H., (2013). “Use of waste glass as sand in mortar: Part II - alkali-silica reaction and mitigation methods.” Cement and Concrete Composites, 35(1), 118-126.10.1016/j.cemconcomp.2012.08.029 ↗
9. 9) Du, H. and Tan, K. H., (2014a). “Concrete with recycled glass as fine aggregates.” ACI Materials Journal, 111(1), 47-58.10.14359/51686446 ↗
10. 10) Du, H. and Tan, K. H., (2014b). “Effect of particle size on alkali-silica reaction in recycled glass mortars.” Construction and Building Materials, 66, 275-285.10.1016/j.conbuildmat.2014.05.092 ↗
11. 11) Du, H. and Tan, K. H., (2014c). “Transport properties of concrete with glass powder as supplementary cementitious material.” ACI Materials Journal, accepted for publication.10.14359/51687363 ↗
12. 12) Dyer, T. D. and Dhir, R. K. (2001). “Chemical reactions of glass cullet used as cement component.” Journal of Materials in Civil Engineering, 13(6), 412-417.10.1061/(ASCE)0899-1561(2001)13:6(412) ↗
13. 13) Helmuth, R., (1987). “Fly ash in cement and concrete.” Illinois: Portland Cement Association.
14. 14) Jain, J. A. and Neithalath, N., (2010). “Chloride transport in fly ash and glass powder modified concretes-influence of test methods on microstructure.” Cement and Concrete Composites, 32(2), 148-156.10.1016/j.cemconcomp.2009.11.010 ↗
15. 15) Jawed, I. and Skalny, J., (1978). “Alkalis in cement: a review II. Effects of alkalis on hydration and performance of Portland cement.” Cement and Concrete Research, 8, 37-51.
16. 16) Jin, W., Meyer, C. and Baxter, S., (2000) “Glascrete-concrete with glass aggregate.” ACI Materials Journal, 97(2), 208-213.
17. 17) Khmiri, A., Chaabouni, M. and Samet B., (2013). “Chemical behavior of ground waste glass when used as partial cement replacement in mortars.” Construction and Building Materials, 44, 74-80.10.1016/j.conbuildmat.2013.02.040 ↗
18. 18) Kim, J., Moon, J. H., Shim, J.W., Sim, J., Lee, H.G. and Zi, G., (2014). “Durability properties of a concrete with waste glass sludge exposed to freeze-and-thaw condition and de-icing salt.” Construction and Building Materials, 66, 398-402.10.1016/j.conbuildmat.2014.05.081 ↗
19. 19) Kocaba, V., (2009). “Development and evaluation of methods to follow microstructural development of cementitious systems including slags.” PhD thesis. Ecole Polytechnique Federale de Lausanne.
20. 20) Ling, T. C., Poon, C. S. and Kou, S. C., (2011). “Feasibility of using recycled glass in architectural cement mortars.” Cement and Concrete Composites, 33(8), 848-854.10.1016/j.cemconcomp.2011.05.006 ↗
21. 21) Matos, A. M. and Sousa-Coutinho, J., (2012). “Durability of mortar using waste glass powder as cement replacement.” Construction and Building Materials, 36, 205-215.10.1016/j.conbuildmat.2012.04.027 ↗
22. 22) McGrath, P. F. and Hooton, R. D., (1999). “Re-evaluation of the AASHTO T259 90-day salt ponding test.” Cement and Concrete Research, 29(8), 1239-1248.10.1016/S0008-8846(99)00058-7 ↗
23. 23) Mindess, S., Young, J. F. and Darwin, D., (2003). “Concrete.” 2nd ed. New Jersey: Prentice Hall.
24. 24) Mirzahosseini, M. and Riding, K. A., (2014). “Effect of curing temperature and glass type on the pozzolanic reactivity of glass powder.” Cement and Concrete Research, 58, 103-111.10.1016/j.cemconres.2014.01.015 ↗
25. 25) Neithalath, N., (2008) “Quantifying the effects of hydration enhancement and dilution in cement pastes containing coarse glass powder.” Advanced Concrete Technology, 6(3), 397-408.10.3151/jact.6.397 ↗
26. 26) Rajabipour, F., Maraghechi, H. and Fischer, G., (2010). “Investigating the alkali-silica reaction of recycled glass aggregates in concrete materials.” Journal of Materials in Civil Engineering, 22(12), 1201-1208.10.1061/(ASCE)MT.1943-5533.0000126 ↗
27. 27) Shayan, A. and Xu, A., (2004). “Value-added utilization of waste glass in concrete.” Cement and Concrete Research, 34(1), 81-89.10.1016/S0008-8846(03)00251-5 ↗
28. 28) Schwarz, N., Cam, H. and Neithalath, N., (2008). “Influence of a fine glass powder on the durability characteristics of concrete and its comparison to fly ash.” Cement and Concrete Composites, 30(6), 486-496.10.1016/j.cemconcomp.2008.02.001 ↗
29. 29) Shao, Y., Lefort, T., Moras, S. and Rodriguez, D., (2000). “Studies on concrete containing ground waste glass.” Cement and Concrete Research, 30(1), 91-100.10.1016/S0008-8846(99)00213-6 ↗
30. 30) Shi, C., Wu, Y., Riefler, C. and Wang, H., (2005). “Characteristics and pozzolanic reactivity of glass powders.” Cement and Concrete Research, 35(5), 987-993.10.1016/j.cemconres.2004.05.015 ↗
31. 31) Shi, C., Stegemann, J. A. and Caldwell, R. J., (1998). “Effect of supplementary cementing materials on the specific conductivity of pore solution and its implications on the rapid chloride permeability test (AASHTO T277 and ASTM C1202) results.” ACI Materials Journal, 95(4), 389-393.
32. 32) Taha, B. and Nounu, G., (2009). “Utilizing waste recycled glass as sand/cement replacement in concrete.” Journal of Materials in Civil Engineering, 21(12): 709-721.10.1061/(ASCE)0899-1561(2009)21:12(709) ↗
33. 33) Tan, K. H. and Du, H., (2013). “Use of waste glass as sand in mortar: Part I - fresh, mechanical and durability properties.” Cement and Concrete Composites, 35(1), 109-117.10.1016/j.cemconcomp.2012.08.028 ↗
34. 34) Wright, J. R., Cartwright, C., Fura, D. and Rajabipour, F., (2014). “Fresh and hardened properties of concrete incorporating recycled glass as 100% sand replacement.” Journal of Materials in Civil Engineering, 26(10), 04014073.10.1061/(ASCE)MT.1943-5533.0000979 ↗