journal article·2020-10Open access

Powder incorporation and spatter formation in high deposition rate blown powder directed energy deposition

Himani Siva Prasad, Frank Brueckner, Alexander F.H. Kaplan

Abstract

A high deposition rate blown powder directed energy deposition process is presented. Clad tracks are deposited and the process is observed by high-speed imaging. An island of unmelted powder forms inside the melt pool, in the centre of the laser spot, which can be attributed to the highly focussed powder flow and the laser beam configuration used. On contact with the melt pool, the powder grains melt to join the melt pool, or they overcome surface tension and are engulfed by the melt. Powder grains can also incorporate into a mushy zone that may be present on the powder island. The powder island appears to rotate in the melt pool and incorporates relatively slowly. The speed of rotation is connected to the size of the island, which also depends on the energy density used. Spatter can form from the edges of the melt pool or from areas around the island when molten metal droplets burst. Frames from high-speed videos are presented and reasons for the various phenomena observed are discussed.
Source: openalex_inverted_index · Quality: baseline

Research context

OpenAlex topics: Additive Manufacturing Materials and Processes · Particle Dynamics in Fluid Flows · Laser-induced spectroscopy and plasma

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (21)

Show source-provided references
1. Additive manufacturing of functionally graded metallic materials using laser metal deposition
2. Laser cladding10.2351/1.521888 ↗
3. Laser cladding
4. Microstructure and porosity evaluation in laser-cladding deposited Ni-based coatings10.1016/j.surfcoat.2016.03.083 ↗
5. Laser powder micro-deposition of compositional gradient Ti–Cr alloy10.1016/j.matdes.2010.02.052 ↗
6. Process characteristics in high-precision laser metal deposition using wire and powder10.2351/1.4983237 ↗
7. Lin · 1997 · 517
8. Siva Prasad · 2019
9. Partitioning of laser energy during directed energy deposition
10. Powder catchment in laser metal deposition10.2351/1.5096130 ↗
11. Influence of fluid convection on weld pool formation in laser cladding
12. Keyhole welding: the solid and liquid phases
13. Spatter in laser welding10.2351/1.3597830 ↗
14. Characterization of laser spatter and condensate generated during the selective laser melting of 304L stainless steel powder
15. Laser welding of copper using multi mode fiber lasers at near infrared wavelength10.1016/j.phpro.2014.08.047 ↗
16. The effects of process parameters on spatter deposition in laser percussion drilling10.1016/S0030-3992(00)00079-7 ↗
17. Investigation into spatter behavior during selective laser melting of AISI 316L stainless steel powder10.1016/j.matdes.2015.08.086 ↗
18. A study on the laser spatter and the oxidation reactions during selective laser melting of 316L stainless steel, Al-Si10-Mg, and Ti-6Al-4V10.1007/s11661-015-2882-8 ↗
19. Observation of the mechanisms causing two kinds of undercut during laser hybrid arc welding10.1016/j.apsusc.2011.03.068 ↗
20. Modeling the influence of process parameters and additional heat sources on residual stresses in laser cladding10.1007/s11666-007-9026-7 ↗
21. Process analysis of laser beam cladding10.1115/1.1344899 ↗