journal article·2017

Impact of surface roughness and contact pressure on wear behaviour of PEEK, POM, and PE-UHMW

Marcela Petrica, Bernadette Duscher, Thomas Koch, Vasiliki Maria Archodoulaki

Publisher page

Abstract

Three thermoplastics - PEEK, POM, and PE-UHMW - were investigated in order to highlight the influence of surface roughness, wear regime, and contact pressure on their wear performance and to understand the role each parameter plays in the development of the wear mechanisms. The surface roughness (Ra) was modified in order to reach a high roughness value and a low roughness value. The change in contact pressures was achieved by conducting measurements at the same applied load (30 N) and at the same exerted pressure (62 MPa). The wear regime was varied by increasing the number of testing cycles. The frictional behaviour of PEEK shows a threestage development which is strongly influenced by the increase of roughness and wear regime, whereas in case of PE-UHMW and POM the frictional behaviour does not seem to be affected by these parameters. A strong correlation was observed between material's mechanical properties, wear mechanisms and frictional behaviour.
Source: openalex_inverted_index · Quality: baseline

Research context

OpenAlex topics: Tribology and Wear Analysis · Mechanical stress and fatigue analysis · Lubricants and Their Additives

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References

Reference metadata was not supplied for this record.