Mechanical Behaviour and Flow Characteristics of Reservoir Sandstone Under Deep Triaxial Stress Conditions
Source abstract
Abstract
The development of deep oil and gas reservoirs has become a key focus in the exploration and exploitation of hydrocarbon resources. To elucidate the mechanisms governing the flow evolution of reservoir sandstone under deep, high-triaxial stress conditions, this study takes the deep reservoir sandstone of a specific block as its subject. Using a true triaxial rock mechanics–seepage coupled testing system to simulate the in situ high-triaxial stress environment. Synchronous testing of the sandstone’s mechanical and seepage properties was conducted, and a staged permeability model for the elastic and damaged zones of the sandstone was developed and experimentally validated. The results indicate that, under deep, high-triaxial stress conditions, the total stress–strain behaviour of sandstone is divided into compaction, elastic deformation, yield and post-failure stages. The mechanical behaviour exhibits a ‘compression–unloading–failure’ pattern, whilst permeability follows a U-shaped evolution characterised by an ‘exponential decline–sudden increase–stabilisation’ trend; furthermore, the influence of damage on flow properties is irreversible. The intermediate principal stress exerts a significant strengthening effect on the mechanical properties of sandstone; as it increases, the peak strength and residual strength of the sandstone rise, whilst post-peak brittleness decreases and ductility increases. The intermediate principal stress is a key factor regulating the evolution of permeability. During the elastic stage, the initial permeability of the sandstone decreases as the stress increases, and the rate of exponential decay accelerates; during the damage stage, the post-peak permeability decreases as the stress increases, and the irreversible closure of pores caused by true triaxial stress makes it difficult for the post-peak permeability to recover to its initial value. The coefficient of determination for the permeability model fitted to the elastic stage is greater than 0.9, whilst that for the damage stage ranges from 0.76 to 0.85. These models effectively characterise the quantitative relationship between permeability and strain under different stress conditions, demonstrating good reliability and applicability. The research findings provide experimental evidence for elucidating the coupled relationship between mechanics and flow in sandstone under deep, high-triaxial stress conditions, as well as for predicting flow behaviour in deep reservoirs and designing development schemes.
Source: crossref · Quality: baseline
Research context
OpenAlex topics: Rock Mechanics and Modeling · Hydrocarbon exploration and reservoir analysis · Hydraulic Fracturing and Reservoir Analysis
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
Affiliations
China National Petroleum Corporation Daqing Oilfield Exploration and Development Research Institute, Daqing 163453, China
State Key Laboratory of Intelligent Deep Metal Mining and Equipment, Northeastern University, Shenyang 110819, China
Funding
National Natural Science Foundation of China
References (38)
Show source-provided references
1. True triaxial strength and failure characteristics of cubic coal and sandstone under different loading paths10.1016/j.ijrmms.2020.104439 ↗
2. Experimental study of permeability change of organic-rich gas shales under high effective stress10.1016/j.jngse.2019.01.014 ↗
3. ISRM Suggested Method for In Situ Microseismic Monitoring of the Fracturing Process in Rock Masses10.1007/s00603-015-0859-y ↗
4. Effects of loading rate on the compound dynamic disaster in deep underground coal mine under true triaxial stress10.1016/j.ijrmms.2020.104453 ↗
5. An analytical coal permeability model for tri-axial strain and stress conditions10.1016/j.coal.2010.08.011 ↗
6. Experimental Study on Influence of Intermediate Principal Stress on the Permeability of Sandstone10.1007/s11242-020-01500-2 ↗
7. Experimental investigation of permeability evolution in deep reservoirs under true triaxial stress: A review10.1016/j.jgsce.2025.205739 ↗
8. A Three-Dimensional Failure Criterion for Hard Rocks Under True Triaxial Compression10.1007/s00603-019-01903-8 ↗
9. Effect of high-pressure deformation on permeability of Ottawa Sand10.1306/C1EA3893-16C9-11D7-8645000102C1865D ↗
10. Experimental measurements of permeability evolution during triaxial compression of initially intact crystalline rocks and implications for fluid flow in fault zones10.1029/2008JB005588 ↗
11. Characterization of damage evolution in granite under compressive stress condition and its effect on permeability10.1016/j.ijrmms.2014.07.020 ↗
12. A new triaxial apparatus to study the mechanical and fluid flow aspects of carbon dioxide sequestration in geological formations10.1016/j.fuel.2011.04.004 ↗
13. Numerical assessment of the effect of equilibration time on coal permeability evolution characteristics10.1016/j.fuel.2014.09.099 ↗
14. Unraveling the dependency of anisotropic permeability of sandstone on total stress and pore pressure with coupled true triaxial compression-flow tests10.1007/s00603-024-04336-0 ↗
15. Liu, Y., Zhang, T., Wu, J., Song, Z., and Wang, F. (2022). Experimental Study on Deformation Behavior and Permeability Evolution of Sandstone Responding to Mining Stress. Energies, 15.10.3390/en15197030 ↗
16. Experimental study on the mechanical and failure behaviors of deep rock subjected to true triaxial stress: A review10.1016/j.ijmst.2022.05.006 ↗
17. Gas Permeability and Porosity Evolution of a Porous Sandstone Under Repeated Loading and Unloading Conditions10.1007/s00603-017-1215-1 ↗
18. Effect of the Intermediate Principal Stress on Rock Failure
19. Development of the permeability anisotropy of submarine sedimentary rocks under true triaxial stresses10.1016/j.ijrmms.2018.06.010 ↗
20. A Novel True Triaxial Apparatus to Study the Geomechanical and Fluid Flow Aspects of Energy Exploitations in Geological Formations10.1007/s00603-016-1060-7 ↗
21. Influence of loading and unloading stress paths on the deformation and failure features of Jinping marble under true triaxial compression10.1007/s00603-020-02104-4 ↗
22. Characteristics and precursor of static and dynamic triggered rockburst: Insight from multifractal10.1007/s00603-022-03173-3 ↗
23. Micromechanics-based three-dimensional nonlinear strength criterion of rocks subjected to true triaxial compression10.1007/s00603-025-04797-x ↗
24. True Triaxial Shear Strength and Failure Mechanism of Sandstone Under Real-Time High-Temperature Conditions10.1007/s00603-025-04471-2 ↗
25. Experimental study of fluid transport processes in the matrix system of the European organic-rich shales: II. Posidonia Shale (Lower Toarcian, northern Germany)10.1016/j.coal.2013.06.009 ↗
26. True-triaxial characterisation of the cement-based grout for application in underground space construction10.1016/j.conbuildmat.2025.141887 ↗
27. Hydromechanical behaviour of columnar jointed rock masses under true triaxial conditions: An experimental and theoretical investigation10.1016/j.geoen.2023.211623 ↗
28. Laboratory measurement of compaction-induced permeability change in porous rocks: Implications for the generation and maintenance of pore pressure excess in the crust10.1007/BF00874337 ↗
29. Elastic wave propagation in and permeability for rocks with multiple parallel fractures10.1016/S1365-1609(02)00095-3 ↗
30. Model development and analysis of the evolution of coal permeability under different boundary conditions10.1016/j.jngse.2016.02.049 ↗
31. A conceptual three-dimensional frictional model to predict the effect of the intermediate principal stress based on the Mohr-Coulomb and Hoek-Brown failure criteria10.1016/j.ijrmms.2023.105605 ↗
32. From Distributed Damage to Strain Localization in Rocks during Brittle Creep10.1103/rtvp-wnfd ↗
33. DP-Optimality in Terms of Multiple Criteria and Its Application to the Split-Plot Design10.1080/00224065.2017.11918183 ↗
34. Crack tensor-based evaluation of inada granite behavior due to damage under true-triaxial testing condition10.1016/j.ijrmms.2018.04.005 ↗
35. Effects of confining pressure on the permeability of three rock types under compression10.1016/j.ijrmms.2013.11.006 ↗
36. Development and application of coal rock permeability test system10.1063/5.0266478 ↗
37. Experimental investigation on the failure mechanism of water-bearing sedimentary rocks under true-triaxial stress10.1016/j.engfailanal.2025.109605 ↗
38. Experimental Study of Failure Differences in Hard Rock Under True Triaxial Compression10.1007/s00603-018-1700-1 ↗