Study on the Stability of Mining Walls During the Recovery of Flank Pillars Adjacent to Massive Backfill

To address the difficulty of determining the safe reserved thickness of the mining wall in the test block of the panel pillar at Tongkeng Mine, The stress of mining wall is comprehensively analyzed. Combined with numerical simulation method and field monitoring, the optimal wall thickness is determined. By differentiating each stress component, the mathematical equations governing the locations where extreme values of the stress components occur are derived, and the mathematical expressions for the extreme value positions of each stress component are further determined accordingly. Considering the geological characteristics and mining conditions of the experimental stope with panel pillars, the eastern mining wall of the test block is selected as the research object. A mining wall thickness range of 3 m to 8 m is designed, and the optimal safe reserved thickness of the mining wall is determined through numerical simulation. Based on the optimal mining wall retention thickness, stopping operations are carried out on the orebody of the experimental stope. Meanwhile, monitoring points are reasonably arranged from the upper-middle section to the middle of the mining wall, and real-time monitoring is performed on the stress variation data at each monitoring point during the entire stopping process of the test block. Theoretical analysis results show that the exact locations of the extreme values of each stress component can be accurately determined within the two-dimensional plane of the mining wall, among which the extreme value of the horizontal stress component appears at the midpoint of the mining wall thickness. Numerical simulation results indicate that both the stress and displacement of the mining wall exhibit a gradual decreasing trend with an increase in mining wall thickness. However, when the mining wall thickness exceeds 5 m, the reduction rate of stress and displacement slows down significantly, and the mining wall tends to become stable. Maintaining a mining wall thickness of 5 m in the experimental stope can generally ensure the safe recovery of the orebody. However, pronounced stress concentrations occur at the geometric corners of the mining wall, which result from stress retention caused by changes in the mining wall geometry. Meanwhile, the stress concentration in the mining wall is synchronized with that in the drilling galleries of the experimental stope, and varying degrees of failure occur in the drilling galleries at locations where stress concentration appears in the mining wall. Monitoring results show that the maximum stress borne by the drilling gallery is approximately 26 MPa, beyond which rock mass collapse and fragmentation are prone to occur.