Study on Deep Hole Blasting for Roof Cutting, Pressure Relief and Roadway Protection in Deep Multi-Coal Seam Mining

Deep multi-coal seam mining is plagued by intense mining pressure, significant impacts of multi-working face mining on system roadways, and difficult surrounding rock deformation control—these issues severely threaten the safe and normal operation of roadways, creating an urgent need for effective dynamic disaster control technologies. Taking the 131,105 working face of Liuzhuang Mine (burial depth up to 740 m) as an example, this study addresses a critical research gap; existing roof cutting pressure relief technologies mostly focus on shallow/thin-coal-seam mining and fail to tackle secondary dynamic pressure induced by repeated mining in deep multi-coal seams—where the superposition of mining stress, ground stress, and goaf stress severely threatens system roadways. To fill this gap, three novel contributions are made. (1) A hierarchical “upper break and middle cut” deep-hole blasting design is proposed, distinct from single-mode roof cutting in existing studies. It achieves directional roof failure by “upper break” (damaging overlying hard rock) and “middle cut” (creating fissures between goaf and protective coal pillars), blocking stress transmission to roadways. (2) Numerical simulations specifically for deep strata (740 m) optimize key parameters: 25 m as the optimal cutting height and 35° as the optimal cutting angle, quantifying their effects on pressure relief (a gap in existing parameter optimization for deep mining). (3) A rapid sealing scheme combining AB material grouting with high-strength detonator pins is developed, solving the problem of slow hardening and poor sealing in traditional deep-hole processes (e.g., cement-only sealing), enabling blasting within 10 min after sealing. This cut off the integrity of the roof, blocked the pressure transmission of the roof stress to the existing system roadway, and achieved a 43.7% reduction in roadway surrounding rock stress (from 32 MPa to 18 MPa) and a 46.7% reduction in maximum roadway deformation (from the pre-blasting 15 cm to 8 cm). This study provides a reference for similar deep multi-coal seam projects. Field monitoring and numerical simulation results show the following. (1) The maximum deformation of the protected East Third Concentrated main roadway is only 8 cm, fully meeting normal operation requirements. (2) The “upper break and middle cut” technology effectively reduces the mining influence range (from 156 m without roof cutting to 125 m with 25 m roof cutting) and weakens roof stress transfer to roadways. This study verifies the feasibility and effectiveness of deep hole blasting for roof cutting, pressure relief, and roadway protection in deep multi-coal seam mining. It provides direct technical references and engineering application templates for similar projects facing roadway protection and dynamic disaster control challenges, contributing to the safe and efficient mining of deep coal resources.