Bionic Structure on Complex Surface with Belt Grinding for Electron Beam Welding Seam of Titanium Alloy

Electron beam welding (EBW) is widely used to weld titanium alloy parts such as aero-engine casing and blades. The surface quality after EBW has a significant influence on the aero-engine performance of those parts. We propose a surface treatment method with grinding on a titanium alloy electron beam weld. We analyze the influence of grinding parameters on the characteristics of the grinding surface. The experiment shows the applicability of ground surface by belt grinding on EBW and its impact on aero-engine performance. After belt grinding, both the welded surface and the surface connected with the substrate are smooth. The extra height of the seam was less than 0.2 mm, and the surface roughness (Ra) of the weld after grinding can be less than 0.98 μm. The microstructure of the weld after grinding was analyzed. Two types of bionic shapes were obtained, a sawtooth shape with a width of 40 μm and a height of 10 μm and a wavy shape with a width of 20 μm and a height of 3 μm. From the analysis above, the bionic surface can be obtained by grinding on the weld with an abrasive belt.