Numerical Study of Internal Flow Field in a Disc Stack Centrifuge Based on Mixture-PBM Model
Source abstract
Abstract
Disc stack centrifuge belongs to one kind of sedimentation centrifuge, widely used in the environmental protection, pharmacy, and chemical industries, etc. The flow process inside the disc stack centrifuge seriously affects the separation efficiency. However, the flow process inside the disc stack centrifuge and its influence on the separation efficiency have not yet been detailed. We plan to study the flow process of oil and water phases inside the disc stack centrifuge and to explore the process of fragmentation and accumulation of water droplets. In this study, the Mixture-PBM (Population Balance Model) model is used to numerically simulate the two-phase flow of oil and water in the disc stack centrifuge and compare it with the tests. The research found that with the increase in rotational speed, the separation efficiency rises in both the test and numerical simulation results, and the difference between the test and simulation results is below 1%. The effect of ribs on the flow is considered, and the results show that the hysteresis of the liquid flow in the disc stack centrifuge is significantly reduced after considering the ribs, and the numerical simulation results can reach 98% of the theoretical results. Fluid entering the separation channel from the neutral pore creates a vortex, and as the dimensionless number λ increases, the degree of deviation of the fluid’s trajectory from the generatrix increases. The circumferential and radial velocities in the separation channel appear large in the center and small near the wall. The water content in the rising channel gradually decreases, and 90% of the water finishes settling in the distributor. The processing volume of the separation channel in each layer shows a small bottom layer, a large top layer, and a uniform law in the middle. The coalescence of water droplets occurs mainly in the separation channel, as found by analyzing the laws of the internal flow of the disc stack centrifuge, which provides the basis for improving the structure of the disc stack centrifuge, increasing the separation efficiency and reducing the floor space.
Source: crossref · Quality: baseline
Research context
OpenAlex topics: Cyclone Separators and Fluid Dynamics · Fluid Dynamics and Mixing · Granular flow and fluidized beds
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
Affiliations
Systems Engineering Research Institute, China State Shipbuilding Corporation Limited, Beijing 100194, China
School of Energy and Power Engineering, Beijing University of Aeronautics and Astronautics, Beijing 101191, China
References (31)
Show source-provided references
1. The use of disc stack centrifuge in the virgin olive oil industry10.4081/jae.2018.784 ↗
2. Liu, S., Dong, H., Li, S., and Song, X. (2024). Study on the Influence of Working Characteristics of Centripetal Pump Based on VOF/Mixture Model. Processes, 12.10.3390/pr12071376 ↗
3. Yuan, H. (2002). Separation Engineering, China Petrochemical Press.
4. White-flesh guava juice clarification by a fixed-angle conical rotor centrifuge laboratory and characterization of continuous disk stack centrifuges10.1016/j.heliyon.2022.e11606 ↗
5. Optimization of mechanical harvesting of microalgae by centrifugation for biofuels production10.1016/j.biombioe.2020.105877 ↗
6. Rheological Characterization of Solids Phase in Biomass Processes of Disc-Stack Centrifuges10.1002/ceat.201800288 ↗
7. Numerical simulation of oil dewatering in a disc centrifuge based on PBM model10.1007/s42757-022-0137-7 ↗
8. Application of CFD in Bioprocessing: Separation of mammalian cells using disc stack centrifuge during production of biotherapeutics10.1016/j.jbiotec.2017.12.016 ↗
9. Optimization of industrial-scale centrifugal separation of biological products: Comparing the performance of tubular and disc stack centrifuges10.1016/j.bej.2021.108281 ↗
10. ANSYS Stress Analysis and Measuring Verification on Disc Separator’s High Speed Bowl
11. Study on influence of rotor systems structural parameters on dynamic characteristics of the disc separator
12. Influence of Structural Parameters on Critical Speed of Vertical Shaft System of a Dish Centrifuge
13. Field Dynamic Balance Test System Based on LabVIEW for Disc Separator10.3901/JME.2015.21.165 ↗
14. Design and Analysis of Health Management Based on Logical Control of Disc Centrifugal Separator
15. Analysis and estimation/prediction of the disk stack centrifuge separation performance—Scaling from benchtop fixed rotor type to disk stack centrifuges10.1080/01496395.2019.1636820 ↗
16. The symmetries and invariant solutions for laminar boundary layer of disc centrifuge
17. Centrifugal separation efficiency in the treatment of waste emulsified oils10.1205/cherd.05130 ↗
18. Hydrodynamic investigations on the separation behavior of suspensions in a gap of a disk stack centrifuge with caulks10.1002/1521-4125(200010)23:10<850::AID-CEAT850>3.0.CO;2-E ↗
19. Numerical Analysis on Flow-field Characteristics of High-Speed Bowl of Latex Disc-separator
20. Numerical Simulation Analysis of Oil Water Solid Three-phase Separation in Disc Separator
21. Numerical Simulation of Inner Flow Field in the Drum
22. Separation Law of Thin Layer Two-phase Flow between Disc in Disc Centrifuge
23. Zhao, Z., and Shi, B. (2011, January 24–26). Numerical simulation of oil-water separation process in disc separator. Proceedings of the International Conference on Remote Sensing, Environment and Transportation Engineering, Nanjing, China.
24. Numerical Simulation of Oil Droplets Coalescence and Breakup in Oil-Water Separating Disc Centrifuge
25. (2024, August 26). Available online: https://ansyshelp.ansys.com/account/secured?returnurl=/Views/Secured/corp/v211/en/flu_th/flu_th_sec_turb_rng.html.
26. On the collision of drops in turbulent clouds10.1017/S0022112056000020 ↗
27. Theoretical model for drop and bubble breakup in turbulent dispersions10.1002/aic.690420505 ↗
28. Sun, Q., and Jin, D. (1987). Centrifuge Principle Structure and Design Calculation, China Machine Press.
29. Research for the Problem of Disc in the Separators Processing
30. Analysis of Internal Flow Field of Kaolin Disc Separator
31. Research progress on quantitative exploration of the interaction mechanism between droplets