Deformation conditions in conventional shearing dependent on geometrical parameters of tooling
Source abstract
Abstract
Shearing conditions in sheet metal blanking depend strongly on the geometry of the shearing dies applied. A study is reported here to reveal how tooling geometry affects the conditions in the shearing process. A FEM-analysis was performed to know about different geometrical conditions of the tooling which influence the conditions in the shearing process. An experiment has also been conducted to validate the results from the FEM-analysis. In the test, a visco-plastic technique was applied to map the real deformations.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Advanced machining processes and optimization · Engineering Technology and Methodologies · Metal Alloys Wear and Properties
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (6)
Show source-provided references
1. Miguel Vaz Jr. and José Divo Bressan. “A computational approach to blanking processes” Journal of Materials Processing Technology, Volumes 125–126, 9 September 2002, Pages 206–212
2. Zafer Tekiner, Muammer Nalbant and Hakan Gürün. “An experimental study for the effect of different clearances on burr, smooth-sheared and blanking force on aluminium sheet metal” Materials & Design, Volume 27, Issue 10, 2006, Pages 1134–113810.1016/j.matdes.2005.03.013 ↗
3. Manabu Gotoh, Minoru Yamashita. “A study of high-rate shearing of commercially pure aluminium sheet” Journal of Materials Processing Technology, Volume 110, Issue 3, 2 April 2001, Pages 253–264.10.1016/S0924-0136(00)00879-7 ↗
4. Z. H. Chen, L. C. Chan, T. C. Lee and C. Y. Tang. “An investigation on the formation and propagation of shear band in fine-blanking process” Journal of Materials Processing Technology, Volume 138, Issues 1–3, 20 July 2003, Pages 610–61410.1016/S0924-0136(03)00141-9 ↗
5. X. Teng, T. Wierzbicki And H. Couque “On the transition from adiabatic shear banding to fracture” Mechanics of Materials, Volume 39, Issue 2, February 2007, Pages 107–125.10.1016/j.mechmat.2006.03.001 ↗
6. S.M.Ganesan, Y.A. Khan, H.Valberg, P. T. Moe, A. Willa Hansen “Cutting applied as test method for acquisition of flow stress data at high strains and strain rates” ESAFORM 2008.10.1007/s12289-008-0193-y ↗