Show source-provided references
3. A cutting force predicting model in orthogonal machining of unidirectional CFRP for entire range of fiber orientation
10.1007/s00170-016-9059-5 ↗4. Development of a cutting force prediction model based on brittle fracture for carbon fiber reinforced polymers for rotary ultrasonic drilling
10.1007/s00170-015-7269-x ↗9. Factor analysis of machining parameters of fiber-reinforced polymer composites based on finite element simulation with experimental investigation
10.1007/s00170-015-7592-2 ↗14. Investigation of CFRP laser milling using a 30 W Q-switched Yb:YAG fiber laser: Effect of process parameters on removal mechanisms and HAZ formation
10.1016/j.compositesa.2013.08.004 ↗15. Machinability study of carbon fibre reinforced polymer (CFRP) composites using design of experiment technique
10.1108/PRT-12-2012-0088 ↗16. Mechanism for changes in cutting forces for down-milling of unidirectional carbon fiber reinforced polymer laminates: Modeling and experimentation
10.1016/j.ijmachtools.2015.10.003 ↗24. Machinability and surface quality during high speed trimming of multi directional CFRP
25. Influence of machining process and machining induced surface roughness on mechanical properties of continuous fiber composites
10.1007/s11340-014-9967-y ↗26. Study of the surface defects and dust generated during trimming of CFRP: Influence of tool geometry, machining parameters and cutting speed range
10.1016/j.compositesa.2014.07.005 ↗28. Development of novel tool for cutting of carbon-fiber-reinforced plastics (Positive use of abrasive wear at tool edge for reduction in cutting force)
10.1299/mej.15-00295 ↗30. Investigation of stresses in he orthogonal cutting of fiber-reinforced plastics
10.1007/BF02328695 ↗33. Study on tool wear and chip formation during drilling carbon fiber reinforced polymer (CFRP)/titanium alloy (Ti6Al4 V) stacks
10.1016/j.proeng.2013.09.133 ↗