Lateral Structure of Multi-Layer Thick Hard Roofs and Hydraulic Roof-Cutting Pressure Relief in Xiao Jihan Mine
Source abstract
Abstract
This study aims to address the pronounced stress concentration in roadway-surrounding rock under conditions of multiple thick and hard roof strata at Xiao jihan coal mine, China. The work was carried out on the 13216 working mining face as the engineering background. A systematic investigation was conducted using a combination of theoretical analysis, numerical simulation, and field experiments. Under double mining disturbance, the lower thick hard roof behaves as a cantilever beam and the upper hard roof strata form a masonry beam structure, producing strong stress transfer to the roadway. The mechanical model indicates a peak stress of 28.90 MPa, 18.34 MPa higher than the in situ stress. Hydraulic roof cutting was designed at the upper thick hard roof horizon. UDEC simulations show that the vertical stress decreases from 26.10 MPa to 13.20 MPa. Field monitoring confirms pressure relief: the non-cutting zone shows a peak of 30.75 MPa, while the roof-cutting zone drops to 22.51 MPa, a 24.62% reduction. The findings of this study provide practical guidance for lateral structure regulation under similar geological and mining conditions.
Source: crossref · Quality: baseline
Research context
OpenAlex topics: Rock Mechanics and Modeling · Geomechanics and Mining Engineering · Tunneling and Rock Mechanics
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
Affiliations
Shanxi Huadian Yuheng Coal and Electricity Co., Ltd., Yulin 719000, China
School of Mines, China University of Mining and Technology, Xuzhou 221116, China
Jiangsu Mine Seismic Monitoring Engineering Laboratory, Xuzhou 221116, China
References (28)
Show source-provided references
1. Study on disaster mechanism of thick and hard overhanging roof and top cutting control technology
2. Collaborative prevention and control technology of “fracture-injection-discharge-support” for thick and hard roof working face crossing faults
3. Yang, F. (2025). Research on the Breaking Law and Hydraulic Fracturing Weakening Technology of Multi-layer Hard Roof in Thick Coal Seam. [Master’s Thesis, Coal Science Research Institute].
4. Research on hydraulic fracturing pressure relief technology in the deep high-stress roadway for surrounding rock control10.1155/2021/1217895 ↗
5. Mechanism of rockburst in stopes with typical thick roof and wide coal pillars in Ordos mining area
6. Investigation on the near-far field effect of rock burst subject to the breakage of thick and hard overburden
7. Catastrophe mechanism and prevention and control technology on soft coal mining with large inclination angle under thick and hard roof
8. Application of pre-splitting blasting roof-cutting pressure relief technology for roadway protection under hard roof10.1038/s41598-025-10964-5 ↗
9. Lateral fracture mode and mining stress response characteristics of overlying and thick-hard roof in deep mining well
10. Migration fracture quantitative and control of thick-hard roof in full-width working face with large mining height
11. Rock bursts induced by thick-hard roof with compound key strata: Mechanisms and technical modes for prevention
12. Experimental study on fracture mode of lateral high and low thick and hard roof in mining roadway
13. Mechanism and control technology of rock burst induced by thick and hard roof breaking in simultaneous mining face
14. He, J. (2025). Mechanism and Application of Hydraulic Fracturing Pressure Relief in Near and Far Field of Thick and Hard Roof of Coal Pillar Entry Retained. [Ph.D. Dissertation, Coal Science Research Institute].
15. Comprehensive pressure relief technology of small coal-pillar roadway protection in double-roadway excavation and its application
16. Research on hydraulic fracturing treatment technology for large-area suspended roofofreuse roadway in working face with gob-side entry retaining
17. Guo, Z.B., Wang, H.H., Ma, Z.M., Wang, P.F., Kuai, X.H., and Zhang, X.Z. (2021). Research on the transmission of stresses by roof cutting near gob rocks. Energies, 14.10.3390/en14051237 ↗
18. Stress transfer mechanism and engineering practice of hydraulic fracturing roof cutting in roadway
19. Wang, T., Xu, G.Y., Liu, L.Y., Bai, C.Q., Ye, W.W., and Sun, L.H. (2024). Principle and practice of hydraulic softening top-cutting and pressure relief technology in weakly cemented strata. Front. Earth Sci., 12.10.3389/feart.2024.1367933 ↗
20. A new method of mining pressure control for roof cutting in advance working face10.1016/j.engfailanal.2024.108302 ↗
21. Ren, Z.Y., and Wang, M.X. (2025). Study on Deep Hole Blasting for Roof Cutting, Pressure Relief and Roadway Protection in Deep Multi-Coal Seam Mining. Appl. Sci., 15.10.3390/app151810138 ↗
22. Structural characteristics of key strata and strata behaviour of a fully mechanized longwall face with 7.0m height chocks10.1016/j.ijrmms.2012.09.006 ↗
23. Field experiment on directional roof presplitting for pressure relief of retained roadways10.1016/j.ijrmms.2020.104436 ↗
24. Development of a Roof-to-floor convergence index for longwall face using combined finite element modelling and statistical Approach10.1016/j.ijrmms.2020.104221 ↗
25. Rock mechanical investigations of seismic events in a deep longwall coal Mine10.1016/j.ijrmms.2008.07.014 ↗
26. Deformation mechanism and roof pre-splitting control technology of gob-side entry in thick hard main roof full-mechanized longwall caving-panel10.1007/s11771-024-5719-z ↗
27. Controlled reconstruction and application research of lateral overlying strata structure in high-gas mines with thick-hard roofs for a fully-mechanized top-caving face10.1016/j.heliyon.2024.e30705 ↗
28. Stress transfer mechanism and strong rock pressure control in the roof composite structure with a large mining height