Numerical Assessment of Thermal Effects in Bundled Overhead Conductors for Dynamic Line Rating
Source abstract
Abstract
Dynamic Line Rating (DLR) is increasingly important for maximizing capacity of existing overhead transmission lines. Conventional thermal rating methods, such as IEEE 738 and model conductors as single, isothermal cylinders and offer limited guidance for multi-conductor bundles, not fully capturing the complex aerodynamic and thermal interactions present in high-voltage networks. This study addresses these limitations by presenting a high-fidelity, two-dimensional coupled thermal-fluid model developed in COMSOL Multiphysics 4.3b. Single and bundled configurations (two-conductor, three-conductor and four-conductor) are analyzed under steady-state conditions using the Shear Stress Transport (SST) turbulence model, accounting for sub-conductor spacing, wind speed, and interactions between temperature distribution and airflow. Simulation results are compared with ampacity calculations from relevant standards to evaluate limitations of simplified models. Results show that leeward conductors reach temperatures up to ~4 °C higher than windward conductors, forming the thermal bottleneck, with peak temperatures of ~103.3 °C versus ~99 °C for single conductors. For bundled conductors, the current required to keep the maximum temperature at 100 °C was calculated, and this value was found to be approximately 3% lower than the current predicted by IEEE 738. The study emphasizes the importance of multiphysics, position-aware simulations to prevent overloading and optimize transmission line utilization.
Source: crossref · Quality: baseline
Research context
OpenAlex topics: Thermal Analysis in Power Transmission · Lightning and Electromagnetic Phenomena · Electrical Contact Performance and Analysis
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
Affiliations
Electrical-Electronics Engineering Department, Faculty of Engineering and Natural Sciences, Suleyman Demirel University, 32260 Isparta, Turkey
Funding
Scientific and Technological Research Council of Turkey
References (34)
Show source-provided references
1. Overhead lines dynamic line rating based on probabilistic day-ahead forecasting and risk assessment10.1016/j.ijepes.2019.03.043 ↗
2. Riba, J.-R. (2024). The role of AC resistance of bare stranded conductors for developing dynamic line rating approaches. Appl. Sci., 14.10.3390/app14198982 ↗
3. A review of dynamic thermal line rating methods with forecasting10.1109/TPWRD.2019.2932054 ↗
4. Optimizing grid with dynamic line rating of conductors: A comprehensive review10.1109/ACCESS.2024.3352595 ↗
5. Massaro, F., Collura, N., Paradiso, S., Di Gloria, P., and Vergine, C. (2025). Dynamic Thermal Rating and Development of Renewable Energy Zones in Sicily. Appl. Sci., 15.10.3390/app15041987 ↗
6. A two-layer framework for mitigating the congestion of urban power grids based on flexible topology with dynamic thermal rating10.23919/PCMP.2023.000139 ↗
7. Li, Y., Xie, K., Xiao, R., Hu, B., Chao, H., and Kong, D. (2018, January 20–22). Network-constrained unit commitment incorporating dynamic thermal rating and transmission line switching. Proceedings of the 2018 2nd IEEE Conference on Energy Internet and Energy System Integration (EI2), Beijing, China.10.1109/EI2.2018.8582182 ↗
8. The role of optimal transmission switching in enhancing grid flexibility: A review10.1109/ACCESS.2023.3261459 ↗
9. Liu, Y., Riba, J.-R., Moreno-Eguilaz, M., and Sanllehí, J. (2021). Analysis of a smart sensor based solution for smart grids real-time dynamic thermal line rating. Sensors, 21.10.3390/s21217388 ↗
10. Constantin, M., Ionita, I., Popescu, D., Iacobici, L., Brezoianu, V., Florea, V., Schiopu, V., and Stamatescu, I. (2022, January 20–22). Dynamic rating technology approach for real-time monitoring of overhead transmission lines. Proceedings of the 2022 International Conference and Exposition on Electrical And Power Engineering (EPE), Iasi, Romania.10.1109/EPE56121.2022.9959858 ↗
11. Rácz, L., and Németh, B. (2021). Dynamic line rating—An effective method to increase the safety of power lines. Appl. Sci., 11.10.3390/app11020492 ↗
12. Peña, R., Colmenar-Santos, A., and Rosales-Asensio, E. (2025). Dynamic Line Rating: Technology and Future Perspectives. Electronics, 14.10.3390/electronics14142828 ↗
13. (2012). IEEE Standard for Calculating the Current-Temperature Relationship of Bare Overhead Conductors (Standard No. IEEE std 738TM–2012).
14. Iglesias, J., Watt, G., Douglass, D., Morgan, V., Stephen, R., Bertinat, M., Muftic, D., Puffer, R., Guery, D., and Ueda, S. (2014). Guide for Thermal Rating Calculations of Overhead Lines, CIGRE.
15. Temperature profile of progressive damaged overhead electrical conductors10.1016/j.ijepes.2012.12.015 ↗
16. Thermal analysis for multi-conductor bundle in high voltage overhead transmission lines under the effect of strong wind10.1016/j.epsr.2024.110308 ↗
17. Solving the overhead transmission conductor heat balance equation using the newton raphson algorithm10.1109/TPWRD.2020.3048831 ↗
18. Cooling of overhead power lines due to the natural convection10.1016/j.ijepes.2019.05.005 ↗
19. Day-ahead dispatch optimization with dynamic thermal rating of transformers and overhead lines10.1016/j.epsr.2019.02.026 ↗
20. Vejo, L., Castro, P., Manana, M., Laso, A., Lecuna, R., Bustamante, S., and Sainz, E. (2025). Experimental Study of Dynamic Line Rating Applied to High-Temperature Low-Sag Conductors. Energies, 18.10.3390/en18040929 ↗
21. Comparison between IEEE and CIGRE thermal behaviour standards and measured temperature on a 132-kV overhead power line10.3390/en81212391 ↗
22. Margita, F., Beňa, Ľ., Malska, W., and Pijarski, P. (2024). Possibilities of Increasing the Ampacity of Overhead Lines Using High-Temperature Low-Sag Conductors in the Electric Power System of the Slovak Republic. Appl. Sci., 14.10.20944/preprints202405.2077.v1 ↗
23. Influence of geometric parameters on the corona loss of 220 and 400 kV overhead transmission lines
24. Two-equation eddy-viscosity turbulence models for engineering applications10.2514/3.12149 ↗
25. A novel robust aerodynamic optimization technique coupled with adjoint solvers and polynomial chaos expansion10.1016/j.cja.2022.06.003 ↗
26. Turbulence modeling and simulation advances in CFD during the past 50 years10.5802/crmeca.114 ↗
27. Gürses, D., and Pulat, E. (2025). Effect of Pressure Gradient on Flow and Heat Transfer over Surface-Mounted Heated Blocks in a Narrow Channel. Appl. Sci., 15.10.3390/app15169099 ↗
28. Numerical study of different Pr number medium turbulent cross flow in staggered tube bundle10.1016/j.ijthermalsci.2023.108206 ↗
29. Shi, J., Hui, Z., Zhou, L., Wang, Z., and Liu, Y. (2024). A numerical investigation of film cooling under the effects of different adverse pressure gradients. Aerospace, 11.10.3390/aerospace11050365 ↗
30. A comparative study of RANS-based turbulence models for an upscale wind turbine blade10.1007/s42452-019-0254-5 ↗
31. The evaluation of k-ε and k-ω turbulence models in modelling flows and performance of s-shaped diffuser10.15282/ijame.15.2.2018.2.0399 ↗
32. Comparison of standard k-epsilon and sst k-omega turbulence model for breastshot waterwheel simulation10.36706/jmse.v7i2.44 ↗
33. Review of the shear-stress transport turbulence model experience from an industrial perspective10.1080/10618560902773387 ↗
34. Anisotropic SST turbulence model for shock-boundary layer interaction10.1016/j.compfluid.2021.105072 ↗