journal article·2025-01-10Open access

Optimization of Key Parameters for Coal Seam L-CO2 Phase Transition Blasting Based on Response Surface Methodology

Xuanping Gong, Xiaoyu Cheng, Cheng Cheng, Quangui Li, Jizhao Xu, Yu Wang

Applied Sciences· Volume 15· Issue 2

Abstract

Liquid carbon dioxide (L-CO2) phase transition blasting technology, known for its high efficiency, environmental friendliness, and controllable energy output, has been widely applied in mine safety fields such as coal roadway pressure relief and coal seam permeability enhancement. However, the synergistic control mechanism between L-CO2 blasting loads and in situ stress conditions on coal seam fracturing and permeability enhancement remains unclear. This study systematically investigates the key process parameters of L-CO2 phase transition blasting in deep coal seams using response surface methodology and numerical simulation. First, three commonly used L-CO2 blasting tubes with the overpressure of 150 MPa, 210 MPa, and 270 MPa were selected, and the corresponding material parameters and state equations were established. A dynamic mechanical constitutive model for a typical low-permeability, high-gas coal seam was then developed. A numerical model of L-CO2 phase transition blasting, considering fluid–solid coupling effects, was then constructed. Multiple experiments were designed based on response surface methodology to evaluate the effects of blasting pressure, in situ stress, and stress difference on L-CO2 fracturing performance. The results indicate that the overpressures of the three simulated blasting loads were 156 MPa, 215 MPa, and 279 MPa, respectively, and the load model closely matches the actual phase blasting load. L-CO2 blasting creates a plastic deformation zone and a pulverized zone around the borehole within 500 μs to 800 μs after detonation, with a tensile fracture zone appearing at 2000 μs. By analyzing radial and tangential stresses at different distances from the explosion center, the mechanical mechanisms of fracture formation in different blast zones were revealed. Under the in situ stress conditions of this study, the number of primary fractures generated by the explosion ranged from 0 to 12, the size of the pulverized zone varied from 1170 cm2 to 2875 cm2, and the total fracture length ranged from 44.4 cm to 1730.2 cm. In cases of unequal stress, the stresses display axial symmetry, and the differential stress drives the fractures to expand along the direction of the maximum principal stress. This caused the aspect ratio of the external ellipse of the explosion fracture zone to range between 1.00 and 1.72. The study establishes and validates a response model for the effects of blasting load, in situ stress, and stress difference on fracturing performance. A single-factor analysis reveals that the blasting load positively impacts fracture generation, while in situ stress and differential stress have negative effects. The three-factor interaction model shows that as the in situ stress and stress difference increase, their inhibitory effects become stronger, while the enhancement effect of the blasting load continues to grow. This research provides a theoretical basis for blasting design and fracture propagation prediction using L-CO2 phase transition blasting in the coal seam under varying in situ stress conditions, offering valuable data support for optimizing the process of L-CO2 phase transition fracturing technology.
Source: crossref · Quality: baseline

Research context

OpenAlex topics: Coal Properties and Utilization · Geoscience and Mining Technology · Mining and Gasification Technologies

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

Affiliations

China Coal Energy Research Institute Co., Ltd., Xi’an 710054, China

State Key Laboratory of Coal Mine Disaster Dynamics and Control, Chongqing University, Chongqing 400044, China

School of Safety Engineering, China University of Mining and Technology, Xuzhou 221116, China

References (31)

Show source-provided references
1. The effect of pulse frequency on the fracture extension during hydraulic fracturing10.1016/j.jngse.2014.08.019 ↗
2. Coal-gas compound dynamic disasters in China: A review10.1016/j.psep.2019.10.006 ↗
3. Enhancement of gas drainage efficiency in a special thick coal seam through hydraulic flushing10.1016/j.ijrmms.2019.104085 ↗
4. A new method of drilling long boreholes in low permeability coal by improving its permeability10.1016/j.coal.2010.08.009 ↗
5. Relationship between pore structure and mechanical properties of shale on supercritical carbon dioxide saturation10.1016/j.energy.2019.01.063 ↗
6. Yang, J., Lian, H., and Li, L. (2020). Fracturing in coals with different fluids: An experimental comparison between water, liquid CO2, and supercritical CO2. Sci. Rep., 10.10.1038/s41598-020-75787-y ↗
7. The experimental study on multiple mechanisms of enhanced CBM recovery by autogenous nitrogen fracturing fluid10.1016/j.geoen.2024.213178 ↗
8. Enhancing coal seam gas using liquid CO2 phase-transition blasting with cross-measure borehole10.1016/j.jngse.2018.10.013 ↗
9. Increasing permeability of coal seams using the phase energy of liquid carbon dioxide10.1016/j.jcou.2017.03.010 ↗
10. CO2 gas fracturing: A novel reservoir stimulation technology in low permeability gassy coal seams10.1016/j.fuel.2017.04.053 ↗
11. Mechanical loading and Cardox revolutionize an old mine
12. Improvement of coal seam gas drainage by under-panel cross-strata stimulation using highly pressurized gas10.1016/j.ijrmms.2015.03.034 ↗
13. Application of liquid CO2 fracturing technique in rock burst control
14. Elimination of coal and gas outburst risk of an outburst-prone coal seam using controllable liquid CO2 phase transition fracturing10.1016/j.fuel.2020.119091 ↗
15. Micro-fractures in coal induced by high pressure CO2 gas fracturing10.1016/j.fuel.2021.122148 ↗
16. Numerical Investigation of Fracturing of Coal with Cleats Caused by Supercritical CO2 Explosion10.1021/acsomega.1c01450 ↗
17. The effect of leakage characteristics of liquid CO2 phase transition on fracturing coal seam: Applications for enhancing coalbed methane recovery10.1016/j.fuel.2021.122044 ↗
18. Evaluation of gas drainage and coal permeability improvement with liquid CO2 gasification blasting10.1177/1687814018768578 ↗
19. Jia, J., Wang, D., Li, B., and Tian, X. (2021). Study of the influencing factors of the liquid CO2 phase change fracturing effect in coal seams. PLoS ONE, 16.10.1371/journal.pone.0254996 ↗
20. Mechanism and application of carbon dioxide phase change blasting fracturing
21. Parameters determination of coal-rock HJC model and research on blasting characteristics by liquid CO2
22. Numerical assessment for impact strength measurements in concrete materials10.1016/j.ijimpeng.2007.12.012 ↗
23. Sensitivty Analysis Determination and Optimization of Rock RHT Paramterts
24. Numerical study on the behavior of blasting in deep rock masses10.1016/j.tust.2021.103968 ↗
25. Research on numerical simulation of coal dynamic RHT constitutive model
26. Peridynamics simulation of rock fracturing under liquid carbon dioxide blasting10.1177/1056789518807532 ↗
27. Finite element analyses of constitutive models performance in the simulation of blast-induced rock cracks10.1016/j.compgeo.2021.104172 ↗
28. Ma, S., Li, G., Zhang, Y., and Liu, H. (2024). Propagation behavior of coal crack induced by liquid CO2 phase change blasting considering blasting pressure effects. PLoS ONE, 19.10.1371/journal.pone.0313360 ↗
29. Comparative experimental study of fracture mechanisms and characteristics of coal-like materials under quasi-static and high-pressure air blasting fracturing10.1021/acs.energyfuels.3c00662 ↗
30. Analysis of fracture network formation mechanisms and main controlling factors of methane explosion fracturing in deep shale reservoir10.1007/s00603-024-03908-4 ↗
31. Fracture propagation characteristics driven by liquid CO2 BLEVE for coalbed methane recovery10.1016/j.fuel.2024.133162 ↗