Numerical Analysis of Cold Spray Process for Creation of Pin Fin Geometries

A numerical study was performed to analyze the particle deposition of a cold spray process for the preparation of nickel electrocatalysts used in the Hydrogen Evolution Reaction (HER). The study focused on the creation of fin-shaped geometries with an optimal porosity on the electrode surface using a mask located between the nozzle exit and the substrate. Computational Fluid Dynamics (CFD) was performed on a three-dimensional high-pressure nozzle, with nickel powder used as the injection feedstock. The behavior of particles was effectively modeled through a two-way coupled Eulerian–Lagrangian approach. As per the parametric study, four masks of varying wire thicknesses and opening sizes were investigated. The masks were placed at 4 mm increments from the nozzle exit, with the substrate placed at standoff distances (SODs) of 10 mm and 20 mm. To capture the effects of the gas inlet operating conditions, two different nozzle inlet conditions were analyzed (2 MPa and 400 °C, 4 MPa and 800 °C). It was found that the nozzle inlet operating condition had the most significant impact, as it relates to the particle velocity and powder deposition. The high-pressure operating condition resulted in a deposition efficiency (DE) greater than 99.9% for all the test cases, with nearly all the impacted particles depositing on the substrate. For the medium-pressure operating condition, the DE increased linearly as the mask SOD was increased, due to the increase in the particle velocity upon impact.