Flow Field Simulation of a Hydrogeological Exploration Drill Bit for Switching between Coring Drilling and Non-Coring Drilling

Drilling is one of the most commonly used techniques in hydrogeological exploration and is employed to obtain rock samples and create boreholes. During conventional drilling, it is necessary to raise all the drilling tools in the borehole when switching between coring drilling and non-coring drilling, which causes large auxiliary operation time consumption and poor drilling efficiency. Based on the structure of wireline coring tools, a large diameter modular drill bit was designed to switch between coring drilling and non-coring drilling without lifting the whole set of drilling tools. In the COMSOL simulation environment, a simulation model of the modular bit was constructed. Drilling fluid velocity and pressure characteristics flowing through the modular bit were studied. According to the analysis results, with the same input flow rate, similar velocities and lower pressure loss can be obtained in non-coring drilling as with the coring bit, and thus drilling cuttings can be removed effectively even if there are more cuttings produced in non-coring drilling than in coring drilling for a borehole drilled at the same diameter. When the outside diameter of the modular bit is 216 mm, the recommended clearance value is 9 mm or 10 mm in order to obtain lower pressure loss and larger diameter core. To generate low pressure loss and ensure bit strength, a layout with four nozzles on the internal non-coring bit is recommended. The modular bit enables fast switching between coring drilling and non-coring drilling without raising the drilling tools. The simulation model can be used for drilling parameter selection and drill bit optimization.