Design and Implementation of an Active Vibration Control Algorithm Using Servo Actuator Control Installed in Series with a Spring-Damper

The membrane-type air spring can be used to suppress lateral vibration of a vibration isolation table. However, compared to voice coil actuators, pneumatic actuators are difficult to use for precise vibration control, because servo valves have nonlinear dynamic characteristics. Therefore, actuators, such as voice coil actuators, can be placed in parallel with air springs, allowing force-type actuators to provide additional force to the system. These actuators generate force. In the case of a ball-screw mechanism device or a linear servomotor, it is an actuator that generates displacement. These actuators are represented as serial active systems. Serial active systems are structurally simpler than parallel active systems. However, there are very few studies on vibration isolation systems using serial active systems compared to parallel active systems. As the two are different types of systems, a new control algorithm suitable for the serial active system is needed. This study proposes a system in which an actuator capable of accurately controlling displacement is connected in series with a support spring-damper. A new active vibration control algorithm for the proposed control system is also developed, which is termed the position input and position output. The proposed control algorithm uses the displacement of the system as an input and outputs the desired displacement of the actuator installed in series with the damper and spring. The proposed control algorithm increases the damping at the target frequency and reduces the response of the system. Numerical studies and experiments were conducted on the single-degree-of-freedom and multi-degree-of-freedom systems. The results show the efficacy of the proposed control system and the novel control algorithm for the vibration suppression of the lateral vibration of a vibration isolation table.