Barkhausen Noise Emission as a Function of Tensile Stress in Low-Alloyed Steels: Influence of Corrosion and Steel Strength

Components of civil buildings are frequently made of low-alloyed steel, which can suffer from corrosion damage. This damage reduces their bearing capacity and/or redistributes the load to neighboring regions with the potential risk of their collapse. For this reason, this study deals with the non-destructive monitoring of bodies made of these steels based on Barkhausen noise emission. The superimposing contribution of corrosion extent and exerted tensile load is investigated on samples of variable yield strength in the range from 235 to 1100 MPa. It is found that the presence of a corroded layer attenuates Barkhausen noise and makes the body harder from a magnetic point of view. The reduced effective thickness of the samples as a result of corrosion damage increases the true stress. Barkhausen noise grows along with the tensile stress in the direction of exerted stress at the expense of decreasing Barkhausen noise in the perpendicular direction. The evolution of Barkhausen noise versus tensile stress is mostly shifted to the lower values of Barkhausen noise, along with the increasing degree of corrosion damage. The evolution of Barkhausen noise versus tensile stress is also affected by the initial microstructure and the corresponding yield strength of the low-alloyed steel. Corrosion attack results in the growth of FWHM, which is compensated by the decreasing evolution along with the tensile stresses. The effective values drop down with the higher extent of corrosion damage. However, the response with respect to the tensile stress is asymmetric in RD and TD due to the realignment of DWs into RD. Finally, PP tends to increase with the corrosion attack as well as the tensile stress and this parameter only exhibits the systematic behavior in RD as well as TD. On the other hand, MBN-extracted parameters as well as their combination provide no exclusive values on which the pure contribution of corrosion and tensile stress can be distinguished.