Color Stability of Nanoparticles-Modified Dental Resin-Based Composites

To evaluate the effect of beverages (coffee, tea, Cola-Cola, and mineral water) on the color stability of resin-based composite (RBC) materials modified with different nanoparticles (NPs). The specimens (70/beverage) were fabricated from light-cured RBCs and divided according to NPs into four groups: one control, unmodified (N0); and three experimental—ZrO2 (Zr), TiO2 (Ti), and SiO2 (Si) groups. Each experimental group was further subdivided into two subgroups according to NP concentrations: 3 wt.% and 7 wt.% (n = 10). A spectrophotometer was used to assess the color change (∆E) before and after six months of immersion. Data were analyzed and compared using one-way-ANOVA followed by Bonferroni’s post-hoc test (α = 0.05) and subsequently ∆E value conversion to National Bureau of Standards (NBS) units. The modified light-cured RBCs with ZrO2, TiO2, and SiO2 demonstrated smaller color changes after immersion in the beverages than the unmodified group (p < 0.001). Zr groups showed the lowest ΔE, followed by Ti and Si groups; a 3% concentration resulted in a lower mean ΔE than the 7% concentration. NBS findings showed that coffee and tea produced marked unacceptable color changes (NBS units were >3), and Coca-Cola resulted in noticeable color changes (NBS units between 1.5 and 3), while water produced slight color changes (NBS ≤ 1). Modification of RBCs with both concentrations of ZrO2, as well as 3% of TiO2 and SiO2, may improve its color stability. Based on NBS results, RBCs immersed in mineral water and Coca-Cola showed clinically acceptable color changes, while those immersed in coffee and tea were clinically unacceptable.