journal article·2021-07-22Open access

Behavior of Quarry Rock Dust, Fly Ash and Slag Based Geopolymer Concrete Columns Reinforced with Steel Fibers under Eccentric Loading

Rana Muhammad Waqas, Faheem Butt

Applied Sciences· Volume 11· Issue 15

Abstract

Geopolymer concrete, also known as an earth-friendly concrete, has been under continuous study due to its environmental benefits and a sustainable alternative to conventional concrete construction. The supplies of many source materials, such as fly ash (FA) or slag (SG), to produce geopolymer concrete (GPC) may be limited; however, quarry rock dust (QRD) wastes (limestone, dolomite, or silica powders) formed by crushing rocks appear virtually endless. Although significant experimental research has been carried out on GPC, with a major focus on the mix design development, rheological, durability, and mechanical properties of the GPC mixes; still the information available on the structural behavior of GPC is rather limited. This has implications in extending GPC application from a laboratory-based technology to an at-site product. This study investigates the structural behavior of quarry-rock-dust-incorporated fiber-reinforced GPC columns under concentric and eccentric loading. In this study, a total of 20 columns with 200 mm square cross-section and 1000 mm height were tested. The FA and SG were used as source materials to produce GPC mixtures. The QRD was incorporated as a partial replacement (20%) of SG. The conventional concrete (CC) columns were prepared as the reference specimens. The effect of incorporating quarry rock dust as a replacement of SG, steel fibers, and loading conditions (concentric and eccentric loading) on the structural behavior of GPC columns were studied. The test results revealed that quarry rock dust is an adequate material that can be used as a source material in GPC to manufacture structural concrete members with satisfactory performance. The general performance of the GPC columns incorporating QRD (20%) is observed to be similar to that of GPC columns (without QRD) and CC columns. The addition of steel fibers considerably improves the loading capacity, ductility, and axial load–displacement behavior of the tested columns. The load capacities of fiber-reinforced GPC columns were about 5–7% greater in comparison to the CC columns. The spalling of concrete cover at failure was detected in all plain GPC columns, whereas the failure mode of all fiber-reinforced GPC columns is characterized with surface cracking leading to disintegration of concrete cover.
Source: crossref · Quality: baseline

Research context

OpenAlex topics: Concrete and Cement Materials Research · Innovative concrete reinforcement materials · Concrete Properties and Behavior

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

Affiliations

Department of Civil Engineering, University of Engineering and Technology, Taxila 47080, Pakistan

References (52)

Show source-provided references
1. Effects of nano-TiO2 on strength, shrinkage and microstructure of alkali activated slag pastes10.1016/j.cemconcomp.2014.11.009 ↗
2. Carbon dioxide equivalent (CO2-e) emissions: A comparison between geopolymer and OPC cement concrete10.1016/j.conbuildmat.2013.01.023 ↗
3. Compressive strength prediction of eco-efficient GGBS-based geopolymer concrete using GEP method10.1016/j.jobe.2020.101326 ↗
4. Statistical modeling and mix design optimization of fly ash based engineered geopolymer composite using response surface methodology10.1016/j.jclepro.2018.05.158 ↗
5. Mix design development of fly ash and ground granulated blast furnace slag based geopolymer concrete10.1016/j.jobe.2018.09.010 ↗
6. Flexural behaviour of geopolymer concrete beams exposed to elevated temperatures10.1016/j.jobe.2017.09.009 ↗
7. Costs and carbon emissions for geopolymer pastes in comparison to ordinary portland cement10.1016/j.jclepro.2011.02.010 ↗
8. Assessment of CO2 reduction of alkali-activated concrete10.1016/j.jclepro.2012.08.001 ↗
9. Dolomite-based quarry-dust as a substitute for fly-ash geopolymers and cement pastes10.1016/j.jclepro.2019.06.261 ↗
10. Compressive stress-strain model for low-calcium fly ash-based geopolymer and heat-cured Portland cement concrete10.1016/j.cemconcomp.2016.07.004 ↗
11. Mechanical properties of alkali activated flyash/Kaolin based geopolymer concrete10.1016/j.conbuildmat.2015.08.009 ↗
12. Improvement of the early and final compressive strength of fly ash-based geopolymer concrete at ambient conditions10.1016/j.conbuildmat.2016.07.069 ↗
13. A mix design procedure for geopolymer concrete with fly ash10.1016/j.jclepro.2016.05.041 ↗
14. Parveen, A.S., and Singhal, D. (2013, January 13). Mechanical properties of geopolymer concrete: A state of the art report. Proceedings of the 5th Asia And Pacific Young Researchers and Graduate Symposium, Jaipur, India.
15. The coexistence of geopolymeric gel and calcium silicate hydrate at the early stage of alkaline activation10.1016/j.cemconres.2004.10.042 ↗
16. Effect of GGBFS on setting, workability and early strength properties of fly ash geopolymer concrete cured in ambient condition10.1016/j.conbuildmat.2014.05.080 ↗
17. Fly ash-based geopolymer: Clean production, properties and applications10.1016/j.jclepro.2016.03.019 ↗
18. Rangan, B.V., Sumajouw, D., Wallah, S., and Hardjito, D. (2006, January 16–17). Reinforced low-calcium fly ash-based geopolymer concrete beams and columns. Proceedings of the 31st Conference on Our World in Concrete & Structures, Singapore.
19. Limestone and silica powder replacements for cement: Early-age performance10.1016/j.cemconcomp.2017.01.001 ↗
20. Investigation of usability of quarry dust waste in fly ash-based geopolymer adhesive mortar production10.1016/j.conbuildmat.2019.05.104 ↗
21. Utilisation of aggregate materials in road construction and bulk fill10.1016/S0921-3449(01)00067-2 ↗
22. Carbonate mineral addition to metakaolin-based geopolymers10.1016/j.cemconcomp.2008.07.004 ↗
23. High volume limestone alkali-activated cement developed by design of experiment10.1016/j.cemconcomp.2011.11.004 ↗
24. The effect of limestone on sodium hydroxide-activated metakaolin-based geopolymers10.1016/j.conbuildmat.2014.05.022 ↗
25. Novel fiber-reinforced composite materials based on sustainable geopolymer matrix10.1016/j.proeng.2011.11.2120 ↗
26. Review of mechanical properties of short fibre reinforced geopolymer composites10.1016/j.conbuildmat.2013.01.026 ↗
27. Geopolymers: Inorganic polymeric new materials10.1007/BF01912193 ↗
28. Synthesis and mechanical properties of cotton fabric reinforced geopolymer composites10.1016/j.compositesb.2013.12.036 ↗
29. A comprehensive study of the polypropylene fiber reinforced fly ash based geopolymer10.1371/journal.pone.0147546 ↗
30. Impact properties of geopolymer based extrudates incorporated with fly ash and PVA short fiber10.1016/j.conbuildmat.2006.08.006 ↗
31. Engineering Properties of Ambient Cured Alkali-Activated Fly Ash—Slag Concrete Reinforced with Different Types of Steel Fiber10.1061/(ASCE)MT.1943-5533.0002333 ↗
32. Deflection hardening behaviour of short fibre reinforced fly ash based geopolymer composites10.1016/j.matdes.2013.03.063 ↗
33. Behaviour of ambient cured steel fibre reinforced geopolymer concrete columns under axial and flexural loads10.1016/j.istruc.2018.07.001 ↗
34. Experimental study on fly ash and lead smelter slag-based geopolymer concrete columns10.1016/j.conbuildmat.2017.03.014 ↗
35. Sumajouw, M., and Rangan, B.V. (2006). Low-Calcium Fly Ash-Based Geopolymer Concrete: Reinforced Beams and Columns, Curtin University of Technology. Research Report.10.1007/s10853-006-0523-8 ↗
36. Chang, E.H. (2009). Shear and Bond Behaviour of Reinforced Fly Ash-Based Geopolymer Concrete Beams, Curtin University.
37. Bond performance of reinforcing bars in inorganic polymer concrete (IPC)10.1007/s10853-006-0534-5 ↗
38. Fly ash-based geopolymer concrete: Study of slender reinforced columns10.1007/s10853-006-0523-8 ↗
39. Tie-confined fibre-reinforced high-strength concrete short columns10.1680/macr.2007.59.10.757 ↗
40. Effect of fibres on the strength and behaviour of GPC columns10.1680/jmacr.15.00049 ↗
41. Mechanical properties of steel fibre reinforced geopolymer concretes at elevated temperatures10.1016/j.conbuildmat.2016.03.158 ↗
42. ASTM, C. (2012). 150/C150M-12. Standard Specification for Portland Cement, ASTM International.
43. Workability and mechanical properties of alkali-activated fly ash-slag concrete cured at ambient temperature10.1016/j.conbuildmat.2018.04.008 ↗
44. ASTM, C. (2015). 127–15. Standard Test. Method for Relative Density (Specific Gravity) and Absorption of Coarse Aggregate, ASTM International.
45. ASTM, C. (2015). 128–15. Standard Test. Method for Relative Density (Specific Gravity) and Absorption of Fine Aggregate, ASTM International.
46. The effects of ground granulated blast-furnace slag blending with fly ash and activator content on the workability and strength properties of geopolymer concrete cured at ambient temperature10.1016/j.matdes.2014.05.001 ↗
47. BSI, BS EN 12390-3:2009 (2009). Testing of Hardened Concrete, Part. 3: Compressive Strength of Test Specimens, British Standard Institution.
48. Cracking localization and reduced ductility in fiber-reinforced concrete beams with low reinforcement ratios10.1016/j.engstruct.2015.11.046 ↗
49. Flexural ductility design of confined high-strength concrete columns: Theoretical modelling10.1016/j.measurement.2015.09.039 ↗
50. Experimental investigation of fire effects on ductility and stiffness of reinforced reactive powder concrete columns under axial compression10.1016/j.jobe.2018.07.028 ↗
51. Behaviour of GGBS-dolomite geopolymer concrete short column under axial loading10.1016/j.jobe.2020.101232 ↗
52. Experimental investigation on the flexural behavior of hybrid steel-PVA fiber reinforced concrete containing fly ash and slag powder10.1016/j.conbuildmat.2019.116706 ↗