Modeling of Electrohydrodynamic (EHD) Plasma Thrusters: Optimization of Physical and Geometrical Parameters
Source abstract
Abstract
This work aims to optimize a previous self-consistent model of a single stage electrohydrodynamic (EHD) thruster for space applications. The investigated parameters were the thruster performance (propulsion force T, the thrust to power ratio T/P, the electric potential distribution, the spatial distribution for the electrons and ions, and the laminar flow velocity) under several conditions, such as the design features related to the cathode’s cylindrical geometry (height and radius) and some electric parameters such as the ballast resistor, and the applied potential voltage. In addition, we examined the influence of the secondary electron emission coefficient on the plasma propellant parameters. The anode to cathode potential voltage ranges between 0.9 and 40 kV, and the ballast resistance varies between 500 and 2500 M. Argon and xenon are the working gases. We assumed the gas temperature and pressure constant, 300 K and 1.3 kPa (10 Torr), respectively. The optimal matching for Xe brings off a thrust of 3.80 μN and an efficiency T/P = 434 mN/kW, while for Ar, T = 2.75 μN, and thruster to the power of 295 mN/kW. To our knowledge, the missing data in technical literature does not allow the verification and validation (V&V) of our numerical model.
Source: crossref · Quality: baseline
Research context
OpenAlex topics: Plasma Diagnostics and Applications · Electrohydrodynamics and Fluid Dynamics · Aerosol Filtration and Electrostatic Precipitation
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
Affiliations
Transport Phenomena Research Center, Department of Physical Engineering, Faculty of Engineering, University of Porto, Rua Dr. Roberto Frias s/n, 4200-465 Porto, Portugal
Department of Physics, Instituto Superior Técnico, University of Lisbon, Avenida Rovisco Pais, 1049-001 Lisbon, Portugal
References (38)
Show source-provided references
1. Advanced Materials for Next-Generation Spacecraft10.1002/adma.201802201 ↗
2. On the performance of electrohydrodynamic propulsion
3. Review on the History, Research, and Applications of Electrohydrodynamics10.1109/TPS.2013.2297173 ↗
4. EHD flow produced by electric corona discharges in gases: From fundamental studies to applications (a review)10.1080/02726351.2015.1043677 ↗
5. The corona discharge, its properties and specific uses10.1351/pac198557091353 ↗
6. Volume forces in weakly ionized plasmas10.1063/1.862722 ↗
7. Volume Forces in Plasma10.1063/1.1762397 ↗
8. Pressure gradients and flow patterns in the direct current positive column10.1063/1.860799 ↗
9. A model of an ideal elctrohydrodynamic thruster10.2514/1.B34097 ↗
10. Aerodynamic flow acceleration using paraelectric and peristaltic elec-trohydrodynamic effects of a One Atmosphere Uniform Glow Discharge Plasma10.1063/1.1564823 ↗
11. Numerical Modeling of body force induced by corona discharge
12. Modeling of the Electrostatic Corona Discharge Reactor10.1109/27.16554 ↗
13. Electrical and kinetic model of an atmospheric rf device for plasma aerodynamic applications10.1063/1.3383056 ↗
14. Modeling of an EHD corona flow in nitrogen gas using an asymmetric capacitor for propulsion10.1016/j.elstat.2011.02.002 ↗
15. Ion-neutral propulsion in atmospheric media10.2514/3.4302 ↗
16. An investigation of ionic wind propulsion
17. Flight of an aeroplane with solid-state propulsion10.1038/s41586-018-0707-9 ↗
18. Altitude dependence of electrohydrodynamic flow in an electrostatic lifter10.1016/j.elstat.2017.03.003 ↗
19. The creation of electric wind due to the electrohydrodynamic force10.1038/s41467-017-02766-9 ↗
20. Electrohydrodynamic force produced by a corona discharge between a wire active electrode and several cylinder electrodes—Application to electric propulsion10.1016/j.elstat.2015.05.025 ↗
21. Electrohydrodynamic force produced by a wire-to-cylinder dc corona discharge in air at atmospheric pressure10.1088/0022-3727/46/47/475204 ↗
22. Electrohydrodynamic force and aerodynamic flow acceleration in surface dielectric barrier discharge10.1063/1.1901841 ↗
23. Electrohidrodynamic force in dielectric barrier discharge plasma actuators10.1088/0022-3727/40/3/S03 ↗
24. Electrostatic propulsion device for aerodynamic applications10.1063/1.4958815 ↗
25. Study of the design and efficiency of a single-stage EHD thruster at the sub-atmospheric pressure of 1.3kPa10.1063/1.5018424 ↗
26. Single-stage EHD thruster response to several simulation conditions on nitrogen gas10.1063/1.4986219 ↗
27. (2019, October 29). COMSOL Multiphysics Website. Available online: http://www.comsol.com.
28. (2015, January 25). Morgan. 2015. Database. Available online: https://nl.lxcat.net/cache/6203dc64ecb3d/.
29. Dissociative recombination at elevated temperatures. II. Comparison between theory and experiment in neon and argon afterglows10.1088/0022-3700/5/11/019 ↗
30. Modeling of metastable argon atoms in a direct-current glow discharge10.1103/PhysRevA.52.3743 ↗
31. Positive ion ratio measurements in ar, kr, and xe glow discharges10.1063/1.1662153 ↗
32. (2019, October 10). Biagi. 2019. Database. Available online: https://nl.lxcat.net/cache/6203dba390c2c/.
33. Moss, R. (2002). Breakdown Measurements in Argon and Xenon Applicable to Metal Halide High Intensity Discharge Lamps. [Master’s Thesis, University of Illinois at Urbana-Champaign].
34. A comprehensive kinetic model of the electron beam excited xenon chloride laser10.1063/1.343639 ↗
35. Electron kinetics in atomic and molecular plasmas10.1088/0963-0252/9/4/308 ↗
36. Bittencourt, J. (2004). Fundamentals of Plasma Physics, Springer.10.1007/978-1-4757-4030-1 ↗
37. Reece Roth, J. (2001). Industrial Plasma Engineering, Volume 2: Applications to Nonthermal Plasma Processing, IOP Publishing.10.1201/9781420034127 ↗
38. Experimental study of the effective secondary electron emission coefficient for rare gases and copper electrodes