Physicochemical and Antimicrobial Properties of Lactic Acid-Based Natural Deep Eutectic Solvents as a Function of Water Content

The interest in natural deep eutectic solvents (NADESs) in green technology as an alternative to organic solvents has grown over the past decades. In this work, for the first time, the effect of dilution with water on the physicochemical and antimicrobial properties of lactic acid-based NADES with choline chloride (NADES1), sorbitol (NADES2), and glucose (NADES3) was systematically studied. According to FTIR data, after the dilution of NADESs with water, the strong hydrogen bonds weakened, however, were not destroyed after dilution of up to 40% water. The dilution of NADES with water resulted in a linear decrease in density and refractive index and in a linear increase in pH. The equations for the prediction of NADES density, pH, and refractive index as a function of water content were calculated. The viscosity decreased by half after adding approximately 10% water. The initial viscosity of NADES2 and NADES3 was significantly different. However, after adding 20% of the water, the viscosity was almost the same. The most pronounced decrease in surface tension (by 46.7%) was found for NADES1. The water activity was decreased in the following order: NADES3 > NADES1 > NADES2. The dilution of NADES with water caused a gradual increase in water activity. NADES1 showed the lowest minimal inhibitory concentrations (MIC) (7.8, 3.9, and 0.98 mg/mL) and minimum bactericidal concentrations (MBC) (15.6, 7.8, and 1.95 mg/mL) for Escherichia coli, Pseudomonas aeruginosa, and Staphylococcus aureus, respectively. The antimicrobial activity was decreased by 2–8 times after the addition of 40% water. The water activity for all tested NADES together with low pH could explain the antimicrobial effect. The revealed regularity can be useful for the prediction of NADES properties and for the selection of green solvents on a laboratory and industrial scale.