Comparison of methods for distinguishing sodium carbonate activated from natural sodium bentonites
Source abstract
Abstract
Abstract A lot of natural Ca/Mg-bentonites are turned into Na-bentonites. By adding sodium carbonate to a Ca/Mg-bentonite in the presence of some water Na+ enters the interlayer and Ca/Mg-carbonates precipitate outside. Natural Na-bentonites and activated Na-bentonites are rather similar. Therefore, in the present study methods are tested to distinguish both. This is relevant not only for customs but also for research and development. For activation different amounts of sodium carbonate are added. The dosage ranges from a few % of the CEC to slightly above the CEC corresponding to 1–5 mass% Na2CO3. Also the water content may vary from the dried state at which the actual activation (cation exchange) does not take place up to the presence of excess water leading to a complete reaction. Altogether four cases had to be considered separately (Na2CO3 above CEC + excess water or dry and Na2CO3 much below the CEC + excess water or dry). If water was absent (cation exchange was not complete) the sodium carbonate phases could be detected by XRD, IR, or with STA–MS measurements. This result was expected but surprisingly, STA–MS–CO2 measurements were found to be applicable even in the most difficult case (sodium carbonate addition below CEC and excess of water = reaction complete). In the case of some samples activated with 2 mass% sodium carbonate only, a weak STA–MS–CO2-peak was observed at about 100 °C. Unprocessed materials are free of any carbonates which decompose around 100 °C. Therefore, this 100 °C peak indicates alkaline activation. This method was applied to five real products with unknown activation and two of which were found to be activated. The pH of the activated materials was only slightly higher than that of a natural Na-bentonite. The measured difference of 0.3 pH units is not considered to be sufficient to unambiguously conclude alkaline activation.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Clay minerals and soil interactions · Concrete and Cement Materials Research · Soil and Unsaturated Flow
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (26)
Show source-provided references
1. The effect of the exchangeable cations on the physico-chemical properties of Wyoming bentonites10.1016/0169-1317(86)90004-9 ↗
2. The role of thermal analysis in the evaluation of impure clay deposits as mineral raw materials10.1180/claymin.1969.008.2.06 ↗
3. Differential thermal analysis curves of carbonate minerals
4. Rapid method for the simultaneous determination of the exchange capacity and content of exchangeable cations in solonetzic soils
5. Three new, quick CEC methods for determining the amounts of exchangeable cations in calcareous clays10.1346/CCMN.2009.0570306 ↗
6. Determination of exchangeable calcium of calcareous and gypsiferous bentonites10.1346/CCMN.2010.0580108 ↗
7. Interlaboratory CEC and ex-changeable cation study of bentonite buffer materials: II. Alternative methods10.1346/CCMN.2012.0600207 ↗
8. Möglichkeiten und Methoden zur Unterscheidung industriell erzaugter Aktivbentonite von natürlichen Natriumbentoniten
9. Bentonites, Geology, Mineralogy, Properties and Uses
10. Hofmann, U., and Endell, K., 1936. British Patent 458240.
11. Beyond the methylene blue method: determination of the smectite content using the Cu-trien method
12. Detachment of colloidal particles from bentonites in water10.1016/j.clay.2007.04.008 ↗
13. Stability of bentonites in salt solutions I sodium chloride10.1016/j.clay.2009.04.011 ↗
14. Effect of extensive drying on the cation exchange capacity of bentonites10.1180/claymin.2010.045.4.441 ↗
15. Stability of bentonites in salt solutions II. Potassium chloride solution — initial step of illitization?10.1016/j.clay.2010.04.009 ↗
16. The pH of aqueous bentonite suspensions10.1346/CCMN.2008.0560304 ↗
17. Water redistribution between bentonite and halite at elevated temperature10.1016/j.clay.2009.08.011 ↗
18. Water uptake capacity of bentonites10.1346/CCMN.2010.0580103 ↗
19. Klinkenberg, M., 2008. Einfluss des Mikrogefüges auf ausgewählte petrophysikalische Eigenschaften von Tongesteinen und Bentoniten. - PhD thesis of the Georg-August-Universität Göttingen, 144 S., online available at: http://webdoc.sub.gwdg.de/diss/2008/klinkenberg/klinkenberg.pdf.
20. Reaktionen der Tonminerale
21. Vorgänge bei der Sodaaktivierung von Bentoniten am Beispiel eines Bentonits von Neuseeland
22. An interpretation of cation selectivity variations in M+–M+ exchange on clays10.1346/CCMN.1979.0270604 ↗
23. Determination of the cation exchange capacity (CEC) of clay minerals using the complexes of copper(II) ion with triethylenetetramine and tetraethylenepentamine10.1346/CCMN.1999.0470315 ↗
24. Simultaneous thermal analysis of different bentonite–sodium carbonate systems: an attempt to distinguish alkali-activated bentonites from raw materials10.1180/claymin.2013.048.4.08 ↗
25. Über Systeme Sodium carbonate-NaHCO3-H2O und das Existenzgebiet der Trona10.1007/BF01518402 ↗
26. Differential thermal analysis, differential thermogravimetric analysis, and high temperature microscopy of reactions between the major components of a sheet glass batch