Crystallization of synthetic hydrotalcite under hydrothermal conditions
Source abstract
Abstract
Abstract The synthetic Mg–Al hydrotalcite with Mg/Al molar ratio of 2 was hydrothermally treated in autoclaves under autogenous water vapour pressure at 120–200 °C for 2–18 h. The obtained samples were characterized by powder X-ray diffraction (XRD), scanning electron microscopy (SEM) and surface area measurements. A well-crystallized hydrotalcite-like phase was present in the coprecipitated product. No other crystalline phases were detected in the powder XRD patterns of both coprecipitated and hydrothermally treated samples. The integral intensity and full width in half maximum (FWHM) of the (003) and (006) hydrotalcite diffraction lines were evaluated in order to compare the crystallinity of samples hydrothermally treated under various conditions. The hydrothermal treatment increased the hydrotalcite content in the samples and improved significantly the hydrotalcite crystallinity. In general, the higher temperature and longer time of hydrothermal treatment, the higher hydrotalcite enrichment, as well as an increasing growth of crystallites, were observed. After the first 2–4 h, the time dependence was less evident, whereas temperature seemed to be a crucial parameter affecting the hydrothermal crystallization. The temperature of 120 °C was too low to increase significantly the sample crystallinity during several hours. According to XRD results, the marked crystallinity improvement was observed at 160 °C and higher temperatures. The hydrothermal treatment resulted in a marked decrease of surface area and a growth of hydrotalcite crystals. SEM micrographs of coprecipitated samples showed the aggregates composed of small thin crystals of ca. 0.1 μm in diameter, which were gradually transformed into thin plates with hexagonal morphology and particle size of several tenths of micrometers. Both a decrease of surface area and the crystallinity improvement of hydrothermally treated samples can be explained by the increase of hydrotalcite crystal size.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Layered Double Hydroxides Synthesis and Applications · Magnesium Oxide Properties and Applications
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (16)
Show source-provided references
1. Synthesis and characterization of polyoxovanadate-pillared Zn–Al layered double hydroxides: an X-ray absorption and diffraction study10.1021/ic9709133 ↗
2. A reexamination of hydrotalcite crystal chemistry10.1021/jp960039j ↗
3. Hydrotalcite-type anionic clays: preparation, properties and application10.1016/0920-5861(91)80068-K ↗
4. Preparation and thermal reactivity of nickel/chromium and nickel/aluminium hydrotalcite-type precursors10.1016/0166-9834(91)85138-L ↗
5. Synthesis and characterization of hydrotalcites containing Ni(II) and Fe(III) and their calcination products10.1021/cm9804923 ↗
6. The effects of various hydrothermal treatments on magnesium–aluminium hydrotalcites10.1023/A:1004800822319 ↗
7. Microwave assisted rapid crystallization of Mg–M(III) hydrotalcite where M(III)=Al, Fe or Cr10.1039/b004219f ↗
8. New Ni–Al–Cr and Ni–Al–Fe carbonate hydrotalcite-like compounds: synthesis and characterization10.1006/jssc.1995.1346 ↗
9. Synthesis and characterization of hydrotalcite-like compounds containing V3+ in the layers and of their calcination products10.1021/ic950835o ↗
10. Polymer interleaved layered double hydroxide: a new emerging class of nanocomposites10.1021/cm0110268 ↗
11. Physico-chemical properties of synthetic hydrotalcites in relation to composition10.1346/CCMN.1980.0280107 ↗
12. The effect of synthetic conditions on tailoring the size of hydrotalcite particles10.1016/S0167-2738(02)00725-7 ↗
13. Synthesis and characterization of the layered double hydroxides of Mg with Cr10.1016/S0025-5408(00)00419-0 ↗
14. 2001 · 251
15. A new hydrotalcite-like compound containing V3+ ions in the layers10.1021/ic00075a008 ↗
16. Hydrotalcite-like anionic clays (layered double hydroxides)