journal article·2017Open access

Comparison of the Economic Feasibility between Conventional and Vacuum Drying for 4/4 Red Oak

Oxana Brenes-Angulo, Brian Bond, Earl Kline, Henry Quesada-Pineda

Forest Products Journal· Volume 67· Issue 7-8

Abstract

Abstract Vacuum drying of wood is a method to reduce drying time and inventory; however, there is limited information regarding the economic feasibility for vacuum drying 4/4 red oak compared with traditional drying methods. The benefits of this technology, mainly dramatically reduced drying times and higher flexibility, must be weighed against the higher initial capital investment. The goal of this project was to compare the economic feasibility, using capital budgeting techniques, of conventional drying and vacuum drying for 4/4 red oak lumber. The analysis was conducted for two actual flooring manufacturers. Conventional drying for this analysis was considered to be air-drying plus kiln drying, which is commonly done with red oak. The vacuum technology considered used hot platens for heating the wood. Species, thickness, drying methods, and lumber demand compared, both drying methods (conventional and vacuum drying) were determined to be economically feasible. However, vacuum drying had a slightly higher net present value, cost–benefit ratio, and sensitivity analysis than conventional drying, making it a slightly better investment for drying 4/4 red oak. The initial tied-up inventory and its respective cost in the conventional drying scenario represents an opportunity cost that can be recovered using vacuum drying. This recovered cost can result in freed capital that can be invested elsewhere to increase competitiveness.
Source: crossref · Quality: baseline

Research context

OpenAlex topics: Forest ecology and management · Wood Treatment and Properties · Forest Biomass Utilization and Management

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (26)

Show source-provided references
1. Apel, W., J. Yong-Li, and V.Walton. 2007. Value stream mapping for lean manufacturing implementation. BSc thesis. Worcester Polytechnic Institute, Worcester, Massachusetts.
2. Arshad, A. 2012. Net present value is better than internal rate of return. Interdiscip. J. Contemp. Res. Bus. 4(8):211.
3. Brealey, R. A. and S. C.Myers. 2003. Capital Investment and Valuation. 7th ed. McGraw-Hill, New York. 558pp.
4. Brenes, O., B. Bond, E. Kline, and H.Quesada-Pineda. 2015. The impact of vacuum-drying on efficiency of hardwood products manufacturing. BioResources J. 10(3):4588–4598.
5. Brenes Angulo, O. M. 2014. The impact of vacuum-drying on efficiency of hardwood products manufacturing. Msc thesis. Virginia Polytechnic Institute and State University, Blacksburg.
6. Chen, Z. 1998. Primary driving force in wood vacuum drying. PhD dissertation. Virginia Polytechnic Institute and State University, Blacksburg.
7. Dreze, J. and H.Stern. 1987. Handbook of Public Economics. Vol. 2.A. J.Auerbachand M.Feldstein (Eds.). Elsevier Science Publishers, North-Holland. 1,106pp.
8. Engalichev, N. and W. E.Eddy. 1970. Economic analysis of low-temperature kiln in processing softwood lumber for market. Cooperative Extension Service, University of New Hampshire, Durham. 107pp.
9. Ercan, N. 2011. A decision support tool for feasibility assessment of hydro electrical power plant projects. MS thesis. Middle East Technical University, Ankara, Turkey.
10. Fortin, Y. 1998. Drying under vacuum. www.valuetowood.ca/imports/pdf/en/tech_profiles/TP-06-01E_VLavoie_Drying_English.pdf. Accessed August 25, 2012.
11. Gottlieb, I. 2010. Next Generation Excel: Modeling in Excel for Analysts and MBAs. Wiley, Singapore.
12. Goulet, M. and M.Ouimet. 1968. Determination of costs in wood seasoning. University of Laval Tech Note No. 5. University of Laval, Quebec. 52pp.
13. Govett, R., S. Bowe, R. Dramm, S. Bratkovitch, and T.Mace. 2006. DRYFEAS Lumber Kiln Drying Operation Financial Feasibility Analysis Spreadsheet: Program User's Manual. USDA Forest Service Wood Education and Research Center of Princeton, West Virginia. 49pp.
14. Holmes, S., G. B. Harpole, and E.Bilek. 1983. DEP: A computer program for evaluating lumber drying costs and investments. General Technical Report FPL-37. USDA Forest Service, Forest Products Laboratory, Madison, Wisconsin. 23pp.
15. Jia, D. 2006. Numerical and experimental study of heat and mass transfer in microwave drying of hardwood. MSc thesis. University of New Brunswick, Fredericton. 134pp.
16. Keown, A., J. Martin, W. Petty, and D.Scott. 2006. Foundations of Finance: The Logic and Practice of Financial Management. 5th ed. Pearson Prentice Hall, Upper Saddle River, New Jersey. 585pp.
17. MacMillen, J. and E.Wengert. 1978. Drying eastern hardwood lumber. www.fpl.fs.fed.us/documnts/usda/ah528.pdf. Accessed May 15, 2014.
18. Newnan, D. G. and J. P.Lavelle. 1998. Engineering Economic Analysis. 7th ed. Engineering Press, Austin, Texas. 756pp.
19. Redman A. 2011. Evaluation of super-heated steam vacuum drying viability and development of a predictive drying model for Australian hardwood species. www.fwpa.com.au. Accessed August 25, 2012.
20. Reeb, J. 2011. Compare costs of different fuels for drying lumber. http://ieeexplore.ieee.org/stamp/stamp.jsp?tp=&arnumber=6017907&isnumber=6017605. Accessed September 12, 2012.
21. Rice, B., J. Howe, R. S. Boone, and J. L.Tschernitz. 1994. Kiln drying lumber in the United States: A survey of volume, species, kiln capacity, equipment, and procedures. www.fpl.fs.fed.us. Accessed September 12, 2013.
22. Rust, K. 2008. Using Little's Law to estimate cycle time and cost. In:Proceedings of the 40th Conference on Winter Simulation, Miami, Florida. pp. 2223–2228. DOI:10.1109/WSC.2008.473632310.1109/WSC.2008.4736323 ↗
23. Savard, M., V. Lavoie, and C.Trembala. 2004. Technical and economical assessment of superheated steam vacuum drying of northern red oak. In:COST E15 Conference, April 22–24, 2004, Athens, Greece. 10pp.
24. Simpson, W. T. 1991. Dry Kiln Operator's Manual. Forest Products Laboratory, Madison, Wisconsin.
25. Yescombe, E. R. 2014. Principles of Project Finance. 2nd ed. Academic Press, Amsterdam. 560 pp. www.sciencedirect.com/science/book/9780123910585 Accessed November 1, 2015.
26. Zhang, Y. 2009. Sustainability oriented feasibility model for construction decision making: Water recycling cases in buildings. MS thesis. University of Toronto.