Compositional Modification of Epitaxial Pb(Zr,Ti)O₃ Thin Films for High‐Performance Piezoelectric Energy Harvesters

Adv. Mater. Interfaces 2024, 11, 2300634 DOI: 10.1002/admi.202300634 Corrections: In the published article, a few misprints were identified in the units for output power density and acceleration. Specifically, all units for output power density should read µW cm−2 g−2, and all units for acceleration should read m s−2. 1. For “301.5 µW−1/(cm2 g2)” in line 16 in the Abstract (page 1) should be corrected as “301.5 µW cm−2 g−2”. 2. For “3 m−1 s−2” in line 16 in the Abstract (page 1) should be corrected as “3 m s−2”. 3. For “560 µW−1 (cm−2 g−2)” in line 15 of left column in the Introduction (page 2) should be corrected as “560 µW cm−2 g−2”. 4. For “1 g = 9.8 m−1 s−2” in line 16 of left column in the Introduction (page 2) should be corrected as “1 g = 9.8 m s−2”. 5. For “9 m−1 s−2” in line 22 of left column in the Results and Discussion (page 3) should be corrected as “9 m s−2”. 6. For “9.8 m−1 s−2” in line 18 of right column in the Results and Discussion (page 3) should be corrected as “9.8 m s−2”. 7. For “301.5 µW−1 (cm−2 g−2)” in line 36 of right column in the Results and Discussion (page 3) should be corrected as “301.5 µW cm−2 g−2”. 8. For “3 m−1 s−2” in line 38 of right column in the Results and Discussion (page 3) should be corrected as “3 m s−2”. 9. For a blank between “14.5” and “µW” in line 10 of right column in the Results and Discussion (page 3) should be ignored. 10. For “3 m−1 s−2” in the caption of Figure 4 (page 4) should be corrected as “3 m s−2”. 11. For “3 m−1 s−2” in line 2 of left column in the Conclusion (page 5) should be corrected as “3 m s−2”. 12. For “301.5 µW−1 (cm−2 g−2)” in line 3 of left column in the Conclusion (page 5) should be corrected as “301.5 µW cm−2 g−2”.