Metallurgical analysis of ASME SA213 T12 boiler vertical water-wall tubes failure
Bibliographic record
Abstract
No abstract is available for this record. The assistant can identify its topic from the title, but cannot infer the study’s results.
Source: Not provided · Quality: missing
Research context
OpenAlex topics: High Temperature Alloys and Creep · Microstructure and Mechanical Properties of Steels · Fatigue and fracture mechanics
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (40)
Show source-provided references
1. Power station boiler furnace water-cooling wall tube leak locating method based on acoustic theory10.1016/j.applthermaleng.2014.12.015 ↗
2. Root cause failure investigation of a boiler waterwall tube employed in a 325 MW thermal power plant: caustic corrosion phenomenon and its effects10.1016/j.engfailanal.2021.105974 ↗
3. Failure analysis of a superheater tube ruptured in a power plant boiler: main causes and preventive strategies10.1016/j.engfailanal.2019.01.016 ↗
4. Failure analysis of the wall tubes of a water-tube boiler10.1016/j.engfailanal.2017.05.032 ↗
5. S. Suwarno, A. Jabar I'jazurrohman, F. Dwi Yudanto, V.S. Djanali, Failure analysis of waste heat boiler tubing caused by a high local heat flux, Eng. Failure Anal. 136 (2022) 106147, doi: 10.1016/j.engfailanal.2022.106147.10.1016/j.engfailanal.2022.106147 ↗
6. Limitations on the computational analysis of creep failure models: a review10.1016/j.engfailanal.2021.105968 ↗
7. Analysis of the causes of leakages and preventive strategies of boiler water-wall tubes in a thermal power plant10.1016/j.engfailanal.2020.104381 ↗
8. Failure analysis of the water-wall tube in KIVCET waste heat boiler10.1016/j.engfailanal.2020.105155 ↗
9. Failure analysis on the economisers of a biomass fuel boiler10.1016/j.engfailanal.2013.01.024 ↗
10. Creep failures of overheated boiler, superheater and reformer tubes10.1016/j.engfailanal.2004.03.001 ↗
11. Failure analysis of an aqua tubular boiler tube10.1007/s11668-012-9602-0 ↗
12. Thermal fatigue and corrosion fatigue in heat recovery area wall side tubes10.1016/j.engfailanal.2009.06.014 ↗
13. Failure analysis of stress corrosion cracking in heat exchanger tubes during start-up operation10.1016/j.engfailanal.2015.02.005 ↗
14. Root cause failure analysis of a division wall superheater tube of a coal-fired power station10.1016/j.engfailanal.2010.05.005 ↗
15. A superheater creep-fatigue interaction failure and its stress assessment10.1016/j.engfailanal.2020.105004 ↗
16. Failure investigation of boiler water wall tubes of a thermal power station10.1007/s11668-015-0055-0 ↗
17. Failure assessment of ASTM A213–T12 superheater boiler tubes in a natural gas liquid plant10.1016/j.engfailanal.2018.03.005 ↗
18. Creep failure of a steam pipe girth weld and NDT strategy on creep damage10.1016/j.engfailanal.2019.06.048 ↗
19. Failure analysis of bank front boiler tubes10.1016/j.engfailanal.2005.10.017 ↗
20. Combating hot corrosion of boiler tubes – a study10.1016/j.engfailanal.2018.08.004 ↗
21. Special report-Refinery boiler feedwater systems: corrosion and control
22. Role of oxide scale thickness measurements in boiler conditions assessment
23. High temperature corrosion influence on deformation and damage mechanisms in turbine blades made of IN-792 during service10.1016/j.engfailanal.2020.104388 ↗
24. Creep failure analysis of tie rod used in lifting steel vessels10.1016/j.engfailanal.2019.06.011 ↗
25. Investigation of exhaust valve failure in a marine diesel engine10.1016/j.engfailanal.2020.104574 ↗
26. Analysis of structural changes in a gas turbine blade as a result of high temperature and stress10.1016/j.engfailanal.2021.105554 ↗
27. ASME, BPVC Section II, part A, Boilers and heat exchangers, 2021. Available from: .
28. Failure analysis of the boiler water-wall tube
29. Heat transfer characteristics of spiral water wall tube in a 1000 MW ultra-supercritical boiler with wide operating load mode10.1016/j.applthermaleng.2017.10.114 ↗
30. C.G. Vassileva, D.F. Daher, S.V. Vassilev, Chemical and phase-mineral composition of mazut fly ash and slag generated from a Syrian power plant, 68 (2015) 1277–1286.
31. M. Jafari, A.H. Garakani, A. Larimi, Simulation and sensitivity analysis of the mazut hydro cracking unit of Iranian power plants to remove sulfur compounds and naphtha production, in: Proceedings of 11th International Chemical Engineering Congress & Exhibition (2021) Fouman, Iran, 15-17 April, 2020.
32. Analysis of the possibility of creep damage detection in T24 heat resistant steel with the help of magnetic nondestestructive testing methods10.1016/j.engfailanal.2019.04.054 ↗
33. Interaction of hot corrosion and creep in Alloy 61710.1016/j.engfailanal.2016.03.012 ↗
34. On the origin of the stress decrease for nickel polycrystals with few grains across the thickness10.1016/j.msea.2008.09.054 ↗
35. Water wall tube cracking in an ultra-supercritical boiler caused by deep peaking10.1007/s12666-021-02243-4 ↗
36. Evaluation of a failed water wall boiler tube10.1007/s11668-011-9522-4 ↗
37. ASM Handbook Volume 13B, Corrosion: Materials (2005). Available from: .
38. Hot corrosion influence on deformation and damage mechanisms in turbine blades made of IN-792 during service10.1016/j.engfailanal.2018.10.004 ↗
39. Impact of boiler load and limestone addition on SO3 and corrosive cold-end deposits in a coal-fired CFB boiler10.1016/j.fuel.2021.121313 ↗
40. W. Abd-Elaziem, M. Khedr, M. Newishy, H. Abdel-Aleem (2022). Metallurgical characterization of a failed A106 Gr-B carbon steel welded condensate pipeline in a petroleum refinery. International Journal of Pressure Vessels and Piping, 200, 104843. https://doi.org/10.1016/j.ijpvp.2022.104843.10.1016/j.ijpvp.2022.104843 ↗