DataVXAdvanced Engineering MaterialsPaper
journal article·2005-02

Infiltration and Coating of Rapid Prototyping Parts

I. Taha, M. H. Abdellatif, P. Dietz

Advanced Engineering Materials· Volume 7· Issue 1-2
Publisher page
Source abstract

Abstract

EDM tools produced by Rapid Tooling (see Figure) were Cu coated and/or infiltrated with conducting particles to improve their EDM performance. Different machining procedures were tested to optimize the manufacturing process.
Only a short abstract or summary was supplied by the source.
Source: crossref · Quality: short

Research context

OpenAlex topics: Advanced Machining and Optimization Techniques · Advanced Surface Polishing Techniques · Additive Manufacturing and 3D Printing Technologies

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (12)

Show source-provided references
1. M. Griffith J. S. Lamancusa Rapid Prototyping Technologies 1998 http://www.me.psu.edu/lamancusa/me415/rpintro2.pdf
2. W. Palm Rapid Prototyping Primer The Learning Factory 1998 http://www.me.psu.edu/lamancusa/rapidpro/primer/chapter2.htm
3. L. E. Weiss JTEC/ WTEC Panel Report on Rapid Prototyping in Europe and Japan SFF Processes 1996 http://itri.loyola.edu/rp/02_02.htm
4. Capus J. M. · Adv. Mater. & Proc. · 1999 · 156 · 33
5. Adv. Mater. & Proc.2001 31.
6. C. Reineking Studienarbeit: Beschichtung und Infiltration von Lasergesinterten Bauteilen Fritz Suechting Institut fuer Maschinenwesen TU‐Clausthal Germany 2000.
7. D. Trenke Studienarbeit: Verwendung von Rapid Tooling Produkten beim Funkerosiven Abtragen Fritz Suechting Institut fuer Maschinenwesen TU‐Clausthal Germany 1998.
8. D. Trenke Internal Report : Untersuchung des Erodierverhaltens von Rapid Steel II Fritz Suechting Institut fuer Maschinenwesen TU‐Clausthal Germany 2000.
9. 10.1016/S0924-0136(99)00054-010.1016/S0924-0136(99)00054-0 ↗
10. K. L. Jensen R. Hovtun Danish Technological Institute and SINTEF Production Engineering Joint Report2000.
11. B. Gaida Lehr‐ und Handbuch: Praktische Galvanotechnik Vol. 3 Eugen G. Lenze Verlag1975 p. 336.
12. Concurrent Technologies Corporation (CTC) Publication 1995 Electroless Plating http://www.dppr.ctc.com/plating/rellspl.htm