Effects of Pb and Cu additives on microstructure and wear corrosion resistance behaviour of PM Al–Si alloys

AbstractAbstractThe wear and wear corrosion resistance behaviour of Al–20Si–XPb–YCu (X=0–10 wt-%, Y=0–3 wt-%) alloys fabricated by a powder metallurgy (PM) technique and subsequent heat treatments were evaluated by a block on ring tribotest. The microstructure of all aluminium alloys was observed by optical microscopy and scanning electron microscopy with X-ray energy dispersive spectroscopy. The effects of applied potentials and environments including dry air and 3.5 wt-%NaCl aqueous solution were studied. The results of microstructure analysis indicated that Pb exhibited a bimodal distribution in the Pb containing alloys, and Cu particles become to form the intermetallic phase CuAl2. Furthermore, the hardness rises significantly for both Pb and Cu containing alloys only after solid solution quenching treatment. The wear and corrosion results showed that the addition of both lead and copper would improve the wear resistance but lead to a higher corrosion rate whereas heat treatment had a beneficial effect of reducing the corrosion rate of most alloys with the exception of Al–Si alloy. Furthermore, by comparison of all alloys after heat treatment, the wear corrosion resistance of Al–Si alloy was inferior to the other alloys; consequent additions of Pb and Cu further improved its wear corrosion resistance. Moreover, at an anodic potential, the wear corrosion rate and current density of both Al–Si and Al–Si–Cu alloys containing particle Pb decrease significantly owing to a corrosion product layer composed of Al, O and Pb elements.Keywords: WEAR CORROSIONAL-20SI-XPB-YCU ALLOYPOWDER METALLURGYTRIBOTEST