Influence of freeze–thaw on the polishing resistance of coarse aggregates on road surface
Source abstract
Abstract
Abstract The aggregates used for surface layers are of central importance for the skid resistance of a road as they are subjected to a combined load due to traffic and weather conditions. In this paper, different aggregates are selected and two plate specimens are produced using each aggregate. One of the test plates is subjected to solely polishing load and the other one was treated with a combined load of polishing and freeze–thaw cycles. By comparing the texture changes and the skid resistance development, a statement is derived on the impact of a freeze–thaw effect for the short-term and long-term development of skid resistance.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Smart Materials for Construction · Geotechnical Engineering and Underground Structures · Geotechnical Engineering and Soil Stabilization
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (19)
Show source-provided references
1. Mayer G, Van der Sluis S, Steinauer B. Griffigkeit von Fahrbahnoberflächen, Teil 2: Signifikante Griffigkeitskennwerte aus Verkehrssicherheitssicht, Forschung Straßenbau und Straßenverkehrstechnik, 841, Bundesministerium für Verkehr, Bau und Stadtentwicklung, Wirtschaftsverlag NW – Verlag für neue Wissenschaft GmbH, Bremerhaven; 2002.
2. Study of the skid resistance of blends of coarse aggregates with different polish resistances10.1016/j.conbuildmat.2013.07.040 ↗
3. Qualification of wearing course material surface evolution after durability test10.1016/j.conbuildmat.2012.02.081 ↗
4. Huschek S, Merzoug DP. Zusammenhang zwischen Rauheit und Griffigkeit, Forschung Straßenbau und Straßenverkehrstechnik, Heft 735; 1996.
5. Wilson DJ. An analysis of the seasonal and short-term variation of road pavement skid resistance. Department of Civil and Environmental Engineering, A Thesis submitted in Fulfillment of the Requirements for the Degree of Doctor of Philosophy in Engineering, The University of Auckland; 2006.
6. Forschungsgesellschaft für Straßen- und Verkehrswesen (FGSV), Merkblatt zur Bewertung der Straßengriffigkeit bei Nässe, Ausgabe 2012 (M BGriff). FGSV Verlag, Köln; 2012.
7. MacLean DJ, Shergold FA. The polishing of roadstone in relation to the resistance to skidding of bituminous road surfacing. Road research technical paper no. 43. Department of Scientific and Industrial Research, Road Research Laboratory, London; 1958.
8. Bald S, Rosauer V. Modelling the ups and downs of the skid resistance of road surfaces. 6th Symposium on pavement surface characteristics (SURF 2008), Darmstadt; 2008.
9. Zieger M. Polishing test, Part III. Road engineering research no. 385. Federal Ministry of Economical Affairs of Austria, Vienna; 1980 [in German].
10. Simultaneous effects of salted water and water flow on asphalt concrete pavement deterioration under freeze–thaw cycles
11. A new method to determine the influence of water on mechanical properties of asphalt concrete10.1080/14680629.2004.9689995 ↗
12. Cohesive fracture and probabilistic damage analysis of freezing–thawing degradation of concrete10.1016/j.conbuildmat.2013.05.046 ↗
13. A new TDR sensor for accurate freeze–thaw measurement10.1080/10298436.2011.626412 ↗
14. Non-linear decay of building stones during freeze–thaw weathering processes10.1016/j.conbuildmat.2012.07.059 ↗
15. Steinauer B, Wang DW, Stanje H, Stanje C. Erhöhung der Verkehrssicherheit durch gute Griffigkeitswerte während der gesamten Gebrauchsdauer von hochbelasteten Straßen, Forschung Straßenbau und Straßenverkehrstechnik Heft 1070, Bundesministerium für Verkehr, Bau und Stadtentwicklung, Wirtschaftsverlag NW – Verlag für neue Wissenschaft GmbH, Bonn; 2012.
16. Pavement polishing – development of a dedicated laboratory test and its correlation with road results10.1016/j.wear.2006.12.086 ↗
17. Physical model for the prediction of pavement polishing10.1016/j.wear.2008.11.012 ↗
18. Fractal and spectral analysis of aggregate surface profile in polishing process10.1016/j.wear.2011.05.024 ↗
19. Woodward D, Woodside A, Ellis R, Phillips P, Walsh I, Sinhal R. The effect of aggregate type and size on the performance of thin surfacing materials. In: International conference managing road and runway surfaces to improve safety, Cheltenham, England; 2008. 13 pp. [conference contribution]. .