Yield stress for zeolite-cement grouted sand
Source abstract
Abstract
Abstract Permeation grouting with cementitious materials is a widely used soil behavior improvement technique. Since the Portland cement production leads to environmental pollution and is also an energy-intensive process, replacing a part of the cement with cheaper and more environmentally friendly materials, such as zeolite, is very important. In the present study, a series of consolidated undrained triaxial tests were carried out on zeolite-cement grouted sand specimens to investigate the effect of cementation on the yield stress (q(y)) through shear loading. The results showed that the axial yield strain (e(y)) in all zeolite-cement grouted sand specimens is less than 1%. Beyond the yield point (YP), a sudden increase in the strain occurs, and the stress–strain curve continues with a slight gradient. The effect of cementitious bonds is significant up to the YP and then gradually decreases. The effective stress path (ESP) of the grouted specimens rises approximately vertically up to the YP. Beyond the YP, the abrupt change of the curvature occurs and the ESP turns to the right. The q(y) and cohesion corresponding to the YP (c′y) increase by increasing the amount of cement replacement with zeolite (Z) in the grouted specimens up to 30%. An increase of more than 30% in Z leads to a decrease in q(y) and c′y. Therefore, the optimum Z to achieve the maximum q(y) and c′y is 30%. With increasing Z content, the effective internal friction angle corresponding to yield (φ′y) always increases with a slight slope.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Grouting, Rheology, and Soil Mechanics · Geotechnical Engineering and Soil Stabilization · Geotechnical Engineering and Analysis
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (79)
Show source-provided references
1. Performance of fine-grained soil treated with industrial wastewater sludge10.1007/s12665-012-2167-0 ↗
2. Mechanical characteristics of soft clay treated with fiber and cement10.1680/gein.12.00012 ↗
3. Factorial experimental approach for effective dosage rate of stabilizer: application for fine-grained soil treated with bottom ash10.1016/j.sandf.2014.04.017 ↗
4. Unconfined compressive strength and freeze-thaw resistance of fine-grained soil stabilised with bottom ash, lime and superplasticiser10.1080/14680629.2015.1021369 ↗
5. M. Ayeldeen, Y. Hara, M. Kitazume, A. Negm, A. Unconfined compressive strength of compacted disturbed cement-stabilized soft clay, Int. J. Geosynth. Ground Eng. 2 (4) (2016) 28, doi: 10.1007/s40891-016-0064-4.10.1007/s40891-016-0064-4 ↗
6. Response surface methodology for optimization of stabilizer dosage rates of marginal sand stabilized with Sludge Ash and fiber based on UCS performances10.1007/s12205-016-0724-x ↗
7. Effect of glass powder added grout for deep mixing of marginal sand with clay10.1007/s13369-017-2655-3 ↗
8. On the prediction of unconfined compressive strength of silty soil stabilized with bottom ash, jute and steel fibers via artificial intelligence10.12989/gae.2017.12.3.441 ↗
9. Performances of using geopolymers made with various stabilizers for deep mixing10.3390/ma12162542 ↗
10. Unconfined compressive strength and freeze-thaw resistance of sand modified with sludge ash and polypropylene fiber
11. Strength development in fine-grained paddy field soil by lime addition
12. On the viscous behavior of cement mixtures with clay, sand, lime and bottom ash for jet grouting10.1016/j.conbuildmat.2015.05.072 ↗
13. Ultrafine Portland cement grouting performance with or without additives10.1007/s12205-014-1445-7 ↗
14. Comparison of rheological models for jet grout cement mixtures with various stabilizers10.1016/j.conbuildmat.2016.09.129 ↗
15. Development of microfine cement grouts by pulverizing ordinary cements10.1016/j.cemconcomp.2012.01.009 ↗
16. A novel approach to prediction of rheological characteristics of jet grout cement mixtures via genetic expression programming10.1007/s00521-016-2360-2 ↗
17. A new prediction method for the rheological behavior of grout with bottom ash for jet grouting columns10.1016/j.sandf.2017.05.006 ↗
18. A novel groutability estimation model for ground improvement projects in sandy silt soil based on Bayesian framework10.1016/j.tust.2014.07.001 ↗
19. Zangana, Use of cement based grout with glass powder for deep mixing10.1016/j.conbuildmat.2017.01.070 ↗
20. Penetrability of microfine cement grouts: experimental investigation and fuzzy regression modeling10.1139/cgj-2013-0297 ↗
21. On the rheology of using geopolymer for grouting: a comparative study with cement-based grout included fly ash and cold bonded fly ash10.1016/j.conbuildmat.2018.11.140 ↗
22. Engineering properties of medium-to-fine sands injected with microfine cement grout10.1080/1064119X.2010.517715 ↗
23. Influence of grouting pressure on the behavior of an unsaturated soil-cement interface10.1061/(ASCE)GT.1943-5606.0000585 ↗
24. Dynamic properties of microfine cement grouted sands10.1016/j.soildyn.2012.05.017 ↗
25. Factors affecting engineering properties of microfine cement grouted sands10.1007/s10706-013-9631-9 ↗
26. Strength improvement of loose sandy soils through cement grouting10.1007/s40098-013-0073-3 ↗
27. Improvement of the strength of soils which comprises granular pumice by injection of cement under low pressure
28. UCS properties of superfine cement-grouted sAnd10.1061/(ASCE)MT.1943-5533.0001659 ↗
29. Penetrability prediction of microfine cement grout in granular soil using Artificial Intelligence techniques10.1016/j.tust.2017.11.023 ↗
30. Basic parameters governing the behaviour of cement-treated clays10.1016/j.sandf.2014.02.011 ↗
31. Trhlíková · 2013
32. On yield stresses and the influence of curing stresses on stress paths and strength measured in triaxial testing of stabilized soils10.1139/t06-096 ↗
33. Cementation of porous materials using calcite10.1680/geot.2002.52.5.313 ↗
34. Static properties of lightly cemented sand
35. The mechanics of cemented carbonate sands10.1680/geot.1993.43.1.53 ↗
36. Sustainable development and climate change initiatives10.1016/j.cemconres.2007.09.008 ↗
37. Shear wave velocity of zeolite-cement grouted sands10.1016/j.soildyn.2019.03.026 ↗
38. Unconfined compressive strength of loose sandy soils grouted with zeolite and cement10.1016/j.sandf.2019.03.012 ↗
39. Small strain shear modulus equations for zeolite-cement grouted sands10.1007/s10706-019-00964-4 ↗
40. Effect of natural zeolite and cement additive on the strength of sand10.1007/s10706-016-0060-4 ↗
41. Parameters controlling strength of zeolite–cement–sand mixture10.1080/19386362.2016.1186412 ↗
42. H. Mola-Abasi, A. Khajeh, S. Naderi Semsani, Porosity/(SiO 2 and Al 2 O 3 Particles) Ratio Controlling Compressive Strength of Zeolite-Cemented Sands, Geotech. Geol. Eng. 36 (2), 2018, 949–958. doi: org/10.1007/s10706-017-0367-9.10.1007/s10706-017-0367-9 ↗
43. Effect of the ratio between porosity and SiO2 and Al2O3 on tensile strength of zeolite-cemented sands10.1061/(ASCE)MT.1943-5533.0002197 ↗
44. Stress-strain behavior of loess soil stabilized with cement, zeolite and recycled polyester fiber10.1061/(ASCE)MT.1943-5533.0002952 ↗
45. Behavior of zeolite-cement grouted sand under triaxial compression test10.1016/j.jrmge.2019.06.010 ↗
46. Isotropic yielding in an artificially cemented soil cured under stress10.1680/geot.2003.53.5.493 ↗
47. Consolidation stress effects on the strength of stabilised Swedish soils10.1680/grim.2006.10.1.1 ↗
48. Yielding and shear behaviour of cement-treated dredged materials10.1016/j.enggeo.2008.07.007 ↗
49. One-dimensional consolidation behavior of cement-treated organic soil10.1139/t11-020 ↗
50. Influence of curing stress on one-dimensional yielding of cement-admixed Bangkok clay at high water content10.3208/sandf.51.351 ↗
51. Modeling compression behavior of cement-treated zinc-contaminated clayey soils10.1016/j.sandf.2014.09.007 ↗
52. Porosity/cement ratio controlling initial bulk modulus and incremental yield stress of an artificially cemented soil cured under stress10.1680/geolett.13.00081 ↗
53. On the mechanical behaviour of dredged submarine clayey sediments stabilized with lime or cement10.1139/cgj-2015-0086 ↗
54. Stress-dependent behavior of marine clay admixed with fly-ash-blended cement
55. ASTM D4253. Standard Test Methods for Maximum Index Density and Unit Weight of Soils Using a Vibratory Table, West Conshohocken, PA. (2016), https://doi.org/10.1520/D4253-16.10.1520/D4253-16 ↗
56. ASTM D4254. Standard Test Methods for Minimum Index Density and Unit Weight of Soils and Calculation of Relative Density, West Conshohocken, PA. (2016), https://doi.org/10.1520/D4254-16.10.1520/D4254-16 ↗
57. ASTM D854. Standard Test Methods for Specific Gravity of Soil Solids by Water Pycnometer, West Conshohocken, PA. (2014), https://doi.org/10.1520/D0854-14.10.1520/D0854-14 ↗
58. Effect of different superplasticisers on the physical and mechanical properties of cement grouts10.1016/j.conbuildmat.2013.09.050 ↗
59. Permeability and porosity improvement of grouted sand10.1080/19648189.2011.9693329 ↗
60. ASTM D4320/D4320M. Standard Test Method for Laboratory Preparation of Chemically Grouted Soil Specimens for Obtaining Design Strength Parameters, West Conshohocken, PA. (2009), https://doi.org/10.1520/D4320-09.
61. ASTM D4767. Standard Test Method for Consolidated Undrained Triaxial Compression Test for Cohesive Soils, West Conshohocken, PA. (2002), https://doi.org/10.1520/D4767-02.10.1520/D4767-02 ↗
62. ASTM D4219. (2008). “Standard Test Method for Unconfined Compressive Strength Index of Chemical-Grouted Soils, West Conshohocken, PA. (2008), https://doi.org/10.1520/D4219-08.10.1520/D4219-08 ↗
63. H. Xiao, F.H. Lee, K.G. Chin, (2014). "Yielding of cement-treated marine clay, Soils Found. 5410.1016/j.sandf.2014.04.021 ↗
64. (3) (2014) 488-501, https://doi.org/10.1016/j.sandf.2014.04.021.10.1016/j.sandf.2014.04.021 ↗
65. Lime treated clay: salient engineering properties and a conceptual model10.3208/sandf.42.5_79 ↗
66. Prediction of bearing capacity of circular footings on soft clay stabilized with granular soil10.1016/j.sandf.2012.01.002 ↗
67. Regression-based models for the prediction of unconfined compressive strength of artificially structured soil10.1007/s00366-017-0528-8 ↗
68. On the prediction of shear wave velocity at local site of strong ground motion stations an application using artificial intelligence10.1007/s10518-013-9425-8 ↗
69. Prediction of compression index using artificial neural network
70. Assessment of soil thermal conduction using artificial neural network models10.1016/j.coldregions.2019.102907 ↗
71. Prediction of recompression index using GMDH-type neural network based on geotechnical soil properties10.1016/j.sandf.2015.10.001 ↗
72. Dry unit weight of compacted soils prediction using GMDH-type neural network10.1140/epjp/i2017-11623-5 ↗
73. Compressibility indices of saturated clays by group method of data handling and genetic algorithms10.1007/s00521-016-2390-9 ↗
74. Pressuremeter modulus and limit pressure of clayey soils using GMDH-type neural network and genetic algorithms10.1007/s10706-017-0314-9 ↗
75. Elasticity modulus of clayey deposits estimation using group method of data handling type neural network10.1016/j.measurement.2018.02.068 ↗
76. Prediction of subgrade reaction modulus of clayey soils using group method of data handling
77. Prediction of zeolite-cemented sand tensile strength by GMDH type neural network10.1080/01694243.2018.1493020 ↗
78. Predicting the stress-strain behaviour of zeolite-cemented sand based on the unconfined compression test using GMDH type neural network10.1080/01694243.2019.1571659 ↗
79. Soil compaction parameters prediction using GMDH-type neural network and genetic algorithm10.1080/19648189.2017.1304269 ↗