Microstructure and tribological performance of NbC-Ni cermets modified by VC and Mo2C

Abstract The current study reports on the influence of the addition of 5–15 vol% VC or/and Mo 2 C carbide on the microstructure and mechanical properties of nickel bonded NbC cermets, which are compared to cobalt bonded NbC cermets. The NbC, Ni and secondary carbides powder mixtures were liquid phase sintered for 1 h at 1420 °C in vacuum. The fully densified cermets are composed of a cubic NbC grains matrix and an evenly distributed fcc Ni binder. NbC grain growth was significantly inhibited and a homogeneous NbC grain size distribution was obtained in the cermets with VC/Mo 2 C additions. The mechanical properties of the NbC-Ni matrix cermets are strongly dependent on the carbide and Ni binder content and are directly compared to their NbC-Co equivalents. The liquid phase sintered NbC-12 vol% Ni cermet had a modest Vickers hardness (HV 30 ) of 1077 ± 22 kg/mm 2 and an indentation toughness of 9.1 ± 0.5 MPa·m 1/2 . With the addition of 10–15 vol% VC, the hardness increased to 1359 ± 15 kg/mm 2 , whereas the toughness increased to 11.3 ± 0.1 MPa·m 1/2 . Addition of 5 and 10 vol% Mo 2 C into a NbC-12 vol% Ni mixtures generated the same values in HV 30 and K IC when compared to VC additions. A maximum flexural strength of 1899 ± 77 MPa was obtained in the cermet with 20 vol% Ni binder and 4 vol% VC + 4 vol% Mo 2 C addition, exhibiting a high fracture toughness of 15.0 ± 0.5 MPa·m 1/2 , but associated with a loss in hardness due to the high Ni content. The dry sliding wear behaviour was established at room temperature and 400 °C from 0.1 to 10 m/s.