journal article·2015-09

Microscopic, mechanical and thermal properties of spark plasma sintered ZrB2 based composite containing polycarbosilane derived SiC

S. Chakraborty, D. Debnath, A.R. Mallick, R.K. Gupta, A. Ranjan, P.K. Das, D. Ghosh

Publisher page

Abstract

ZrB2-SiCp (w/w 80:20) composites were spark plasma sintered at 1900, 2000 and 2100 degrees C with t(on) = 50 ms and t(off) = 5 ms conditions under 50 MPa pressure for 15 min. SiC was obtained by in situ pyrolysis of polycarbosilane during sintering. The FTIR spectra of semi-pyrolysed ZrB2-SiCp powder showed that pre-ceramic PCS polymeric bands such as Si-CH2-Si, Si-CH3 and Si-H weakened and few characteristic bands like Si-C, Si-O and C = C peaks appeared strong in the spectra. In ZrB2-SiCP composition, uniform distribution of ZrB2 and secondary SiC phases were found in the sintered sample. The interfaces between hexagonal ZrB2 and needle shaped SiC were found in high resolution bright field TEM images. The Vickers' micro-hardness, fracture toughness (measured by DCM) of ZrB2-SiCp composite sintered at 2000 degrees C achieved up to 16.22 GPa and 3.69 MPa root m, respectively. The critical energy release rate (G(IC)) value was 27.46 J.m(-2) implying that the composite resists fracture during indentation. Wear resistance coefficient and wear rate values of all the composites were found to be very low. Thermal conductivity values of all the composites varied from 78.09 to 57.20 W/m.K in 100 degrees C to 1000 degrees C range. (C) 2015 Elsevier Ltd. All rights reserved.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (30)

Show source-provided references
1. Ultra-high temperature ceramic materials for extreme environment applications10.1149/2.F04074IF ↗
2. Pierson · 1996 · 55
3. Refractory diborides of zirconium and hafnium10.1111/j.1551-2916.2007.01583.x ↗
4. Materials for ultrahigh temperature structural applications
5. UHTC composites for hypersonic applications
6. Enhanced densification and mechanical properties of ZrB2-SiC processed by a preceramic polymer coating route10.1016/j.scriptamat.2008.02.043 ↗
7. Combined effect of SiC chopped fibers and SiC whiskers on the toughening of ZrB210.1016/j.ceramint.2013.09.031 ↗
8. Synthesis, consolidation and characterization of monolithic and SiC whiskers reinforced HfB2 ceramics10.1016/j.jeurceramsoc.2012.10.004 ↗
9. Effects of polymer derived SiC interphase on the properties of C/ZrC composites10.1016/j.matdes.2014.01.039 ↗
10. Comprehensive chemistry of polycarbosilanes, polysilazanes and polycarbosilazanes as precursors of ceramics10.1021/cr00037a014 ↗
11. Conversion mechanisms of a polycarbosilane precursor into an SiC-based ceramic material10.1007/BF00544474 ↗
12. Improving high temperature properties of hot pressed ZrB2-20vol% SiC ceramic using high purity powders10.1016/j.ceramint.2012.06.018 ↗
13. Microstructure and densification of ZrB2-SiC composites prepared by spark plasma sintering10.1016/j.jeurceramsoc.2009.01.011 ↗
14. Hardness and toughness of hot pressed ZrB2-SiC composites consolidated under relatively low pressure10.1016/j.jallcom.2014.09.006 ↗
15. Fractographical assessment of densification mechanisms in hot pressed ZrB2-SiC composites10.1016/j.ceramint.2014.07.023 ↗
16. Mechanical, tribological and thermal properties of hot pressed ZrB2-SiC composite with SiC of different morphology10.1179/1743676114Y.0000000189 ↗
17. Hot-pressed A12O3-SiC(−C) composites with polycarbosilane as the precursor10.1016/j.matdes.2009.08.034 ↗
18. Liquid polycarbosilanes: synthesis and evaluation as precursors for SiC ceramic10.1002/pi.4889 ↗
19. Polymer-ceramic conversion of a highly branched liquid polycarbosilane for SiC-based ceramics10.1007/s10853-008-2539-8 ↗
20. A polysilazane precursor for Si-C-N-O matrix composites10.1016/0955-2219(95)00033-Q ↗
21. Low temperature fabrication of porous SiC ceramics by pre ceramic polymer reaction bonding10.1016/j.matlet.2004.11.003 ↗
22. Role of impurities on the spark plasma sintering of ZrCx-ZrB2 composites10.1016/j.jeurceramsoc.2007.07.013 ↗
23. Preparation of ZrB2-SiC composites by arc melting and their properties10.2109/jcersj2.116.431 ↗
24. Room-temperature dislocation activity during mechanical deformation of polycrystalline ultra high-temperature ceramics10.1016/j.scriptamat.2009.08.038 ↗
25. Mechanical behaviour of ceramics
26. Microstructure and high-temperature strength of textured and non-textured ZrB2 ceramics10.1088/1468-6996/15/1/014202 ↗
27. Formation of intragranular nano-structures in micro-sized ceramic composite materials10.1016/j.msea.2008.02.029 ↗
28. Densification, mechanical and tribological properties of ZrB2 by SPS: effect of pulsed current10.1016/j.ijrmhm.2014.09.004 ↗
29. Fracture toughness and toughening mechanisms in a (ZrB2-SiC) composite reinforced with boron nitride nanotubes and boron nitride nanoplatelets10.1016/j.scriptamat.2012.12.005 ↗
30. Thermal resistance of grain boundaries in alumina ceramics and refractories10.1111/j.1151-2916.2003.tb03285.x ↗