Constitutive modeling for high-temperature tensile deformation behavior of pure molybdenum considering strain effects
Source abstract
Abstract
Abstract In order to get a reliable constitutive equation for the accurate simulation, high temperature flow behavior of molybdenum sheet was investigated by performing uniaxial hot tensile tests in the temperature range of 993–1143 K at an interval of 50 K with strain rates ranging from 0.0005 to 0.02 s − 1 . The true stress–strain curves revealed the characteristics of strain hardening and followed by flow softening under lower strain rates at temperature over 1093 K, and the dominant role of work hardening at higher strain rates and lower temperatures. Considering the effects of strain rates and temperature incorporating strain on the flow behavior, the Arrhenius-type constitutive equation with material constants expressed by the polynomial fitting of strain was established, and the flow stress values predicted by the constitutive equation agreed well with the experimental results.
Source: openaire · Quality: candidate unverified · Source record ↗
References (17)
Show source-provided references
1. Molybdenum disulfide as a lubricant: a review of the fundamental knowledge10.1016/0043-1648(67)90187-1 ↗
2. Joining of molybdenum and its application10.1016/j.ijrmhm.2010.06.008 ↗
3. Development, preparation and characterization of uranium molybdenum alloys for dispersion fuel application10.1016/j.jallcom.2008.05.061 ↗
4. Electronic applications for P/M molybdenum
5. Progress of research and applications for Mo metal and its alloys
6. Measuring the fracture toughness of molybdenum-0.5 pct titanium-0.1 pct zirconium and oxide dispersion-strengthened molybdenum alloys using standard and subsized bend specimens10.1007/s11661-002-0242-y ↗
7. Microstructure and properties of hot-rolled 2.0wt.% MoSi2/rare earth oxide doped molybdenum alloys10.1016/j.ijrmhm.2011.10.008 ↗
8. Modeling of flow stress of 42CrMo steel under hot compression10.1016/j.msea.2007.11.119 ↗
9. Experimentally-based micromechanical modeling of dynamic response of molybdenum10.1016/S1359-6462(99)00041-X ↗
10. A unified constitutive model for strain-rate and temperature dependent behavior of molybdenum10.1016/S0167-6636(01)00076-X ↗
11. Work hardening and flow stress of ultrapure molybdenum single crystals10.1016/S0921-5093(01)01002-4 ↗
12. A comparative study of a back propagation artificial neural network and a Zerilli–Armstrong model for pure molybdenum during hot deformation10.1016/j.ijrmhm.2006.11.004 ↗
13. A temperature and rate-dependent micromechanical mode of molybdenum under neutron irradiation10.1016/j.mechmat.2010.12.005 ↗
14. Characterization of strengthening mechanism and hot deformation behavior of powder metallurgy molybdenum10.1016/j.matdes.2011.07.065 ↗
15. Yield strength of molybdenum, tantalum and tungsten at high strain rates and very high temperatures10.1016/j.jnucmat.2012.03.044 ↗
16. On the recrystallization behavior of technically pure molybdenum10.1016/j.ijrmhm.2010.03.006 ↗
17. Effect of strain rate upon plastic flow of steel10.1063/1.1707363 ↗