Evolution of residual stress and damage in coated hard metal milling inserts over the complete tool life
Source abstract
Abstract
Abstract In coated hard metal milling inserts the main damage mechanisms are thermal fatigue induced by interrupted tool–workpiece contact and wear. Dependent on the magnitudes of thermal and mechanical loads in two applied test setups, either wear or thermal fatigue in the form of combcracks is induced. The evolution of residual stress and damage in the used milling inserts was documented over their complete lifetime. In a region of interest on the tool rake face a significant buildup of tensile residual stress was observed via a synchrotron based technique. A special preparation technique enabled position resolved measurements in this area by in-house X-ray diffraction facilities to study the evolution of residual stress over the entire tool lifetime. The onset of cracking was observed to happen in this region of interest by means of focused ion beam milling and scanning electron microscopy. The residual stress levels observed are comparable in used inserts at early stages of application, independent of the different cutting conditions and the applied characterization technique. At the end of tool life wear damage dominated inserts showed tensile residual stress, whereas thermal fatigue as the dominant damage mechanism resulted in compressive residual stresses.
Source: openaire · Quality: candidate unverified · Source record ↗
References (21)
Show source-provided references
1. Untersuchungen über den Einsatz von Hartmetallen beim Fräsen. Forschungsberichte des Landes Nordrhein-Westfalen Nr. 1146
2. Thermo-mechanical failure of cemented carbide tools in intermittent cutting
3. Schedler · 1988
4. Spatial correlation of tensile residual stress and thermal fatigue damage in coated cemented carbide milling inserts
5. Influence of some metallurgical parameters of cemented carbide on the sensitivity to thermal fatigue cracking at cutting edges
6. The influence of thermal cycling on tool life in peripheral milling10.1016/0020-7357(76)90009-3 ↗
7. Failure of cemented carbide tools in intermittent cutting10.1016/0141-6359(79)90041-2 ↗
8. X-ray diffraction analysis of three-dimensional residual stress fields reveals origins of thermal fatigue in uncoated and coated steel10.1016/j.scriptamat.2010.02.006 ↗
9. A new diffractometer for materials science and imaging at HASYLAB beamline G310.1016/S0168-9002(99)00144-8 ↗
10. Residual stress and damage in coated hardmetal milling inserts
11. ICDD Database Powder Diffraction File #00-051-0939.
12. Stress analysis of polycrystalline thin films and surface regions by X-ray diffraction10.1107/S0021889804029516 ↗
13. Bruker AXS · 2005
14. Spieß · 2005
15. Residual stress in WC–Co measured by neutron diffraction10.1016/0921-5093(95)10147-0 ↗
16. Equi-penetration grazing incidence X-Ray diffraction method (EP-GIXD) - stress depth profiling of ground silicon Nitride10.1016/j.actamat.2014.06.015 ↗
17. Interaction of heat checks in aluminum pressure casting dies and their effect on fatigue life
18. A study of the thermal fatigue crack propagation in WC–Co cemented carbide10.1179/pom.1975.18.35.006 ↗
19. Rother · 1992
20. The effect of droplets in arc evaporated TiAlTaN hard coatings on the wear behaviour10.1016/j.surfcoat.2014.01.010 ↗
21. Optimization of the cutting edge radius of PVD coated inserts in milling considering film fatigue failure mechanism10.1016/S0257-8972(00)00971-3 ↗