journal article·2010-05

Novel fine-grained hardmetals by use of multiphase powder precursors and reactive nitrogen sintering

D.S. Janisch, W. Lengauer, K. Rödiger, K. Dreyer, H. van den Berg

Publisher page

Abstract

Abstract Hardmetals typical of ISO class P which contain hexagonal WC together with fcc carbides and carbonitrides as hard phase constituents were prepared ranging from very low to very high carbonitride contents by a novel route. For this purpose specially designed multiphase hard phase powders containing both, WC and pre-alloyed fcc carbides were used. Green bodies were reactively sintered at various nitrogen pressures. During this step, not only carbonitride formation but also WC formation takes place. The sintered hardmetals were characterised by XRD, EBSD, SEM and LOM. They show sub-micron grain size of both, the WC and the fcc hard phase and thus substantially higher hardness (with only a small decrease in toughness) as compared to conventionally prepared bodies of the same overall composition. As a consequence, flank wear of cutting inserts is significantly reduced in milling of 4140 steel. Grain growth is retarded due to the pre-alloyed state of the powders and the interpenetration of hexagonal and fcc hard phases. The applied method, both, in laboratory and industrial scale, allows not only adjustment of the bulk properties of the hardmetals during sintering but in addition, if desired, tailoring the near-surface microstructure with respect to the formation of various types of a functional gradient.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (7)

Show source-provided references
1. Effects of addition carbides on the grain size of WC–Co alloy10.2497/jjspm.19.67 ↗
2. Microstructure development during sintering and heat-treatment of cemented carbides and cermets10.1016/S0254-0584(00)00441-7 ↗
3. Schwarzkopf M, Schintlmeister W, Schmid L. Stickstoffhaltige Hartmetalle zur Herstellung zähigkeitssteigernder Randzonen. In: 12th International Plansee seminar, Reutte (A), vol. 2; 1989. p. 803–33.
4. Tailoring hardness and toughness gradients in functional gradient hardmetals (FGHMs)10.1016/j.ijrmhm.2005.03.008 ↗
5. Functionally graded hardmetals10.1016/S0925-8388(02)00232-3 ↗
6. Synthesis of complex carbonitrides10.1007/s11106-006-0027-8 ↗
7. Sintering, characterisation, and analysis of functional gradient hardmetals10.1016/j.ijrmhm.2007.05.006 ↗