High-Speed Through Silicon Via(TSV) Filling Using Diallylamine Additive

High-speed copper electrodeposition is needed to optimize the TSV process with a high throughput. To inhibit electrodeposition on the top surface of the TSV, the ODT was microcontact-printed on the top surface. The ODT microcontact-printing effectively inhibits the copper electrodepositon on the top surface. With 1.0 ppm SDDACC, V-shapes were formed in the via cross sections and these shapes lead to bottom-up via filling. 9 Without microcontact-printing, and with 1.5 ppm SDDACC, V-shapes were again formed in the via cross sections and these shapes lead to bottom-up via filling. We succeeded in filling 10 μm diameter and 70 μm deep vias within 35 minutes without microcontact-printing. This was achieved by optimizing the SDDACC concentration with CVS measurements. The inhibition layer of the microcontact-printing does not speed up the TSV electrodeposition. The most important factor to speed up the TSV electrodeposition is optimization of the additives.