Mechanical and tribological behavior of sol–gel TiO2–CdO films measured at the microscale levels
Source abstract
Abstract
In this work, we present a mechanical and tribological study at the microscale of sol–gel TiO2–CdO films, which are used in photocatalytic applications. The films were deposited as a good-quality polycrystalline material with majority of CdO or CdTiO3 phases depending on their Ti/Cd concentration ratios. Films with the majority of CdTiO3 phase presented the highest hardness and lowest plastic deformation during the indentation tests. The evolution of wear, friction coefficient, and roughness on the films was quantitatively studied by multiple-passes measurements on a depth-sensing instrumented indentation system. These measurements allowed us to observe the films’ wear mechanisms and correlate them with their microstructure and mechanical properties. To compare the crystal structure, mechanical properties and tribological behavior of these films, we also analyzed sol–gel CdO and TiO2 films deposited under similar conditions.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Metal and Thin Film Mechanics · ZnO doping and properties · Diamond and Carbon-based Materials Research
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (34)
Show source-provided references
1. Diliegros-godines CJ, Flores-Ruiz FJ, Castanedo-Pérez R, et al. (2016) Mechanical and tribological properties of the oxide thin films obtained by sol–gel method. In: Klein L (ed) Handbook of sol–gel science and technology. Springer International Publishing, Switzerland, pp 1–14. doi: 10.1007/978-3-319-19454-7_115-110.1007/978-3-319-19454-7_115-1 ↗
2. Chan CM, Cao GZ, Fong H et al. (2000) Nanoindentation and adhesion of sol–gel-derived hard coatings on polyester. J Mater Res 15:148–154. doi: 10.1557/JMR.2000.002510.1557/JMR.2000.0025 ↗
3. Chen X, Selloni A (2014) Introduction: titanium dioxide (TiO2) nanomaterials. Chem Rev 114:9281–9282. doi: 10.1021/cr500422r10.1021/cr500422r ↗
4. Giannakopoulou T, Todorova N, Giannouri M et al. (2014) Optical and photocatalytic properties of composite TiO2/ZnO thin films. Catal Today 230:174–180. doi: 10.1016/j.jallcom.2012.04.08910.1016/j.jallcom.2012.04.089 ↗
5. Islam S, Rahman RA, Othaman Z et al. (2013) Preparation and characterization of crack-free sol–gel based SiO2–TiO2 hybrid nanoparticle film. J Sol Gel Sci Technol 68:162–168. doi: 10.1007/s10971-013-3147-x10.1007/s10971-013-3147-x ↗
6. Wang Y, Wang SJ, Shu X et al. (2014) Preparation and property of sol-enhanced Ni–B–TiO2 nano-composite coatings. J Alloys Compd 617:472–478. doi: 10.1016/j.jallcom.2014.08.06010.1016/j.jallcom.2014.08.060 ↗
7. Celik E, Keskin I, Kayatekin I et al. (2007) Al2O3–TiO2 thin films on glass substrate by sol-gel technique. Mater Charact 58:349–357. doi: 10.1016/j.matchar.2006.05.01510.1016/j.matchar.2006.05.015 ↗
8. Abd El-Lateef HM, Khalaf MM (2015) Corrosion resistance of ZrO2–TiO2 nanocomposite multilayer thin films coated on carbon steel in hydrochloric acid solution. Mater Charact 108:29–41. doi: 10.1016/j.matchar.2015.08.01010.1016/j.matchar.2015.08.010 ↗
9. Wang Y, Tay SL, Wei S et al. (2015) Microstructure and properties of sol-enhanced Ni–Co–TiO2 nano-composite coatings on mild steel. J Alloys Compd 649:222–228. doi: 10.1016/j.jallcom.2015.07.14710.1016/j.jallcom.2015.07.147 ↗
10. de Anda Reyes ME, Torres Delgado G, Castanedo Pérez R et al. (2012) Optimization of the photocatalytic activity of CdO + CdTiO3 coupled oxide thin films obtained by sol–gel technique. J Photochem Photobiol A Chem 228:22–27. doi: 10.1016/j.jphotochem.2011.11.00710.1016/j.jphotochem.2011.11.007 ↗
11. Hernández-García FA, Torres-Delgado G, Castanedo-Pérez R, Zelaya-Ángel O (2015) Photodegradation of gaseous C6H6 using CdO + CdTiO3 and TiO2 thin films obtained by sol–gel technique. J Photochem Photobiol A Chem 310:52–59. doi: 10.1016/j.jphotochem.2015.05.02110.1016/j.jphotochem.2015.05.021 ↗
12. Zhang H, Banfield JF (2014) Structural characteristics and mechanical and thermodynamic properties of nanocrystalline TiO2. Chem Rev 114:9613–9644. doi: 10.1021/cr500072j10.1021/cr500072j ↗
13. Sobczyk-Guzenda A, Pietrzyk B, Jakubowski W et al. (2013) Mechanical, photocatalytic and microbiological properties of titanium dioxide thin films synthesized with the sol–gel and low temperature plasma deposition techniques. Mater Res Bull 48:4022–4031. doi: 10.1016/j.materresbull.2013.06.02410.1016/j.materresbull.2013.06.024 ↗
14. Fattakhova-Rohlfing D, Zaleska A, Bein T (2014) Three-dimensional titanium dioxide nanomaterials. Chem Rev 114:9487–9558. doi: 10.1021/cr500201c10.1021/cr500201c ↗
15. Yaghoubi H, Taghavinia N, Alamdari EK, Volinsky AA (2010) Nanomechanical properties of TiO2 granular thin films. ACS Appl Mater Interfaces 2:2629–2636. doi: 10.1021/am100455q10.1021/am100455q ↗
16. Jia Q, Zhang Y, Wu Z, Zhang P (2007) Tribological properties of anatase TiO2 sol–gel films controlled by mutually soluble dopants. Tribol Lett 26:19–24. doi: 10.1007/s11249-006-9177-610.1007/s11249-006-9177-6 ↗
17. Zhang W, Liu W, Wang C (2002) Tribological behavior of sol–gel TiO2 films on glass. Wear 253:377–384. doi: 10.1016/S0043-1648(02)00139-410.1016/S0043-1648(02)00139-4 ↗
18. Lackner JM, Waldhauser W, Ebner R et al. (2004) Pulsed laser deposition of titanium oxide coatings at room temperature-structural, mechanical and tribological properties. Surf Coat Technol 180–181:585–590. doi: 10.1016/j.surfcoat.2003.10.09910.1016/j.surfcoat.2003.10.099 ↗
19. Diliegros-Godines CJ, Flores-Ruiz FJ, Castanedo-Pérez R et al. (2015) Mechanical and tribological properties of CdO + SnO2 thin films prepared by sol–gel. J Sol Gel Sci Technol 74:114–120. doi: 10.1007/s10971-014-3584-110.1007/s10971-014-3584-1 ↗
20. Broitman E, Flores-Ruiz FJ (2015) Novel method for in situ and simultaneous nanofriction and nanowear characterization of materials. J Vac Sci Technol A 33:43201. doi: 10.1116/1.492158410.1116/1.4921584 ↗
21. Oliver WC, Pharr GM (2004) Measurement of hardness and elastic modulus by instrumented indentation: advances in understanding and refinements to methodology. J Mater Res 19:3–20. doi: 10.1557/jmr.2004.19.1.310.1557/jmr.2004.19.1.3 ↗
22. Broitman E (2017) Indentation hardness measurements at macro-, micro-, and nanoscale: a critical overview. Tribol Lett 65:23. doi: 10.1007/s11249-016-0805-510.1007/s11249-016-0805-5 ↗
23. Nečas D, Klapetek P (2012) Gwyddion: an open-source software for SPM data analysis. Cent Eur J Phys 10:181–188. doi: 10.2478/s11534-011-0096-210.2478/s11534-011-0096-2 ↗
24. Gao F, He J, Wu E et al. (2003) Hardness of covalent crystals. Phys Rev Lett 91:15502. doi: 10.1103/PhysRevLett.91.01550210.1103/PhysRevLett.91.015502 ↗
25. Matthews A, Franklin S, Holmberg K (2007) Tribological coatings: contact mechanisms and selection. J Phys D 40:5463–5475. doi: 10.1088/0022-3727/40/18/S0710.1088/0022-3727/40/18/S07 ↗
26. Rivera-Tello CD, Broitman E, Flores-Ruiz FJ et al. (2016) Mechanical properties and tribological behavior at micro and macro-scale of WC/WCN/W hierarchical multilayer coatings. Tribol Int 101:194–203. doi: 10.1016/j.triboint.2016.04.01710.1016/j.triboint.2016.04.017 ↗
27. Leyland A, Matthews A (2000) On the significance of the H/E ratio in wear control: a nanocomposite coating approach to optimised tribological behaviour. Wear 246:1–11. doi: 10.1016/S0043-1648(00)00488-910.1016/S0043-1648(00)00488-9 ↗
28. Charitidis C, Koumoulos E, Dragatogiannis D (2013) Nanotribological behavior of carbon based thin films: friction and lubricity mechanisms at the nanoscale. Lubricants 1:22–47. doi: 10.3390/lubricants102002210.3390/lubricants1020022 ↗
29. Flores-Ruiz FJ, Herrera-Gomez A, Camps E, Espinoza-Beltrán FJ (2015) Elastic heterogeneities at the nanoscale in DLC films grown by PLD. Mater Res Express 2:25009. doi: 10.1088/2053-1591/2/2/02500910.1088/2053-1591/2/2/025009 ↗
30. Fischer-Cripps AC (2011) Analysis of nanoindentation test data. In: Fischer-Cripps AC (ed) Nanoindentation. Springer, New York, NY, p 39–7510.1007/978-1-4419-9872-9_3 ↗
31. Gaillard Y, Rico VJ, Jimenez-Pique E, González-Elipe AR (2009) Nanoindentation of TiO2 thin films with different microstructures. J Phys D 42:145305. doi: 10.1088/0022-3727/42/14/14530510.1088/0022-3727/42/14/145305 ↗
32. Queener CA, Smith TC, Mitchell WL (1965) Transient wear of machine parts. Wear 8:391–400. doi: 10.1016/0043-1648(65)90170-510.1016/0043-1648(65)90170-5 ↗
33. Mortazavi V, Khonsari MM (2016) On the prediction of transient wear. J Tribol 138:41604. doi: 10.1115/1.403284310.1115/1.4032843 ↗
34. Archard JF (1953) Contact and rubbing of flat surfaces. J Appl Phys 24:981. doi: 10.1063/1.172144810.1063/1.1721448 ↗