journal article·2015-06

Resolidification of the mushy zone of multiphase and multicomponent alloys in a temperature gradient – Experiments and modeling

Andrea Löffler, Klemens Reuther, Hannes Engelhardt, Dongmei Liu, Markus Rettenmayr

Acta Materialia· Volume 91
Publisher page

Abstract

Abstract Resolidification of the mushy zone of multiphase and multicomponent alloys in a temperature gradient is investigated. Experiments of gradient annealing are conducted for a multiphase Cu-40 wt.%Al alloy and an Al-1 wt.%Mg-5 wt.%Si alloy with varying holding times, and the resulting microstructures are evaluated with respect to the evolution of phase fractions and concentration distributions. A numerical model that describes the macroscopic mass transport along the temperature gradient out of the mushy zone and that predicts the evolution of phase fractions and concentration distributions for multicomponent and multiphase alloys is put forward, and the calculation results are compared with the experimental observations. Full qualitative agreement is achieved between experiment and simulation. Effects in a resolidifying mushy zone of a multiphase alloy such as local solutal melting prior to resolidification that have so far not been documented in the literature are captured by the model.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Aluminum Alloy Microstructure Properties · High Temperature Alloys and Creep · High Entropy Alloys Studies

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (22)

Show source-provided references
1. Preparation of the initial solid–liquid interface and melt in directional solidification10.1016/S0022-0248(03)01041-8 ↗
2. Initial transients during solid/liquid phase transformations in a temperature gradient10.1016/j.jcrysgro.2007.03.001 ↗
3. Microstructure evolution during melting and resolidification in a temperature gradient10.1016/j.jcrysgro.2005.06.044 ↗
4. Influence of thermal stabilization on the solute concentration of the melt in directional solidification10.1016/j.jcrysgro.2010.09.053 ↗
5. Temperature gradient zone melting
6. Migration of a liquid zone through a solid10.1063/1.1729806 ↗
7. Temperature gradient zone melting-approach to steady-state10.1016/0022-0248(84)90151-9 ↗
8. In situ and real-time analysis of TGZM phenomena by synchrotron X-ray radiography10.1016/j.jcrysgro.2008.01.041 ↗
9. Chemically driven growth of tungsten grains during sintering in liquid nickel10.1016/0001-6160(79)90185-8 ↗
10. Observation of early melting stages of an Al–Cu alloy in a temperature gradient10.3139/146.110576 ↗
11. Influence of coarsening on dendrite arm spacing of aluminum–copper alloys
12. Thermal migration of liquid droplets through solids10.1063/1.1660741 ↗
13. Preparation of the initial solid–liquid interface and melt in directional solidification of Al-18at.%Ni peritectic alloy10.1016/j.jcrysgro.2010.05.018 ↗
14. An analysis of non-equilibrium peritectic reaction driven by solute diffusion under a temperature gradient10.1016/j.jcrysgro.2011.08.034 ↗
15. Combeau · Nucl. Eng. Des. · 2010 · 240 · 197510.1016/j.nucengdes.2010.04.004 ↗
16. Fischer · J. Alloys Compd. · 2012 · 540 · 8510.1016/j.jallcom.2012.06.075 ↗
17. An extended numerical procedure for predicting microstructure and microsegregation of multicomponent alloys10.1088/0965-0393/4/2/004 ↗
18. Rapid solidification of Al–Cu eutectic alloys by laser remelting10.1016/0001-6160(89)90203-4 ↗
19. Kovacova · Kovove Mater. · 1979 · 17 · 144
20. Einfluß von Phosphor und Natrium auf die Diffusion in flüssigen Aluminum-Silicium-Legierungen
21. Using directional solidification to determine solid/liquid equilibria in multicomponent phase diagrams10.1016/j.jcrysgro.2005.02.056 ↗
22. Influence of time-variant temperature gradients on resolidifying mushy zones10.1016/j.jcrysgro.2014.09.016 ↗