journal article·2014-05

Bond behavior of sand-coated deformed glass fiber reinforced polymer rebars

Weichen Xue, Qiaowen Zheng, Yu Yang, Zhiqing Fang

Publisher page

Abstract

Bond behavior of sand-coated deformed glass fiber reinforced polymer rebars was experimentally investigated in this study. A total of 84 specimens, including 30 beam specimens, 48 Losberg pullout specimens, and six RILEM/CEB/FIP pullout specimens, were constructed and tested under monotonic loading. Two failure modes including pullout failure and splitting failure were observed. The pullout failure occurred when the embedment length of specimens was less than 5 times glass fiber reinforced polymer rebar diameter, while the splitting failure occurred when embedment length was more than 5 times rebar diameter. The specimens with the embedment length of 5 times bar diameter failed either by glass fiber reinforced polymer rebars pulling out or by concrete splitting. The results also showed that bond strength of sand-coated deformed glass fiber reinforced polymer rebars was, on average, 59–127% that of the deformed steel rebars. With higher concrete strength, higher bond strength of sand-coated deformed glass fiber reinforced polymer rebars was obtained. When rebar diameter or embedment length increased, bond strength of sand-coated deformed glass fiber reinforced polymer rebars decreased. Based on these results, formulas for the bond strength and the development length of glass fiber reinforced polymer rebars were proposed, considering the effects of concrete strength, bar diameter, embedment length, and rebar outer surface.
Source: crossref · Quality: baseline

Research context

OpenAlex topics: Structural Behavior of Reinforced Concrete · Structural Load-Bearing Analysis · Geotechnical Engineering and Underground Structures

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

Affiliations

Department of Building Engineering, Tongji University, Shanghai, China

References (17)

Show source-provided references
1. Pleimann L · 1987
2. Pleimann LG. Strength, modulus of elasticity and bond of deformed FRP rods. In: Proceedings of the specialty conference on advanced composite materials in civil engineering structures , Material Engineering Division, American Society of Civil Engineers , Las Vegas, Nevada, United States, 31 January–1 February 1991, pp.99–110.
3. Faza SS · Transp Res Rec · 1991 · 1290 · 185
4. 10.1007/BF0247293410.1007/BF02472934 ↗
5. 10.1007/BF0247314910.1007/BF02473149 ↗
6. 10.1061/(ASCE)0733-9445(1996)122:3(247)10.1061/(ASCE)0733-9445(1996)122:3(247) ↗
7. 10.1016/S0950-0618(98)00027-010.1016/S0950-0618(98)00027-0 ↗
8. 10.1061/(ASCE)1090-0268(2004)8:2(173)10.1061/(ASCE)1090-0268(2004)8:2(173) ↗
9. 10.1061/(ASCE)1090-0268(2005)9:3(203)10.1061/(ASCE)1090-0268(2005)9:3(203) ↗
10. Wambeke BW · ACI Struct J · 2006 · 103 · 11
11. Xue WC · ACI Mater J · 2008 · 105 · 11
12. 10.1061/(ASCE)CC.1943-5614.000013910.1061/(ASCE)CC.1943-5614.0000139 ↗
13. 10.1061/(ASCE)CC.1943-5614.000027010.1061/(ASCE)CC.1943-5614.0000270 ↗
14. Aly R · ACI Struct J · 2006 · 103 · 857
15. American Concrete Institute Committee (ACI) · 2006
16. Japan Society of Civil Engineers (JSCE) · 1997
17. Liu H. Experimental and theory analytical study on concrete flexural members reinforced with fiber reinforced polymer bars . MS Thesis, University of Tongji, Shanghai, China, 2003.