journal article·2026-07Open access

Full-field experimental characterization of charging-induced swelling in lithium-ion pouch cells using surround digital image correlation

Christoph Pirker, Dirk Mohr, Thomas Tancogne-Dejean

Abstract

Lithium plating is a major degradation mechanism in lithium-ion cells influenced by local pressure, rate- and state-of-charge. In this work, heterogeneous plating in 4 Ah graphite/LiCoO2 pouch cells is investigated using surround three-dimensional digital image correlation (DIC), enabling full-field measurements of in-plane strain and thickness evolution on both faces during charging. Cells are charged using CC–CV protocols at 0.5C, 1.0C, and 1.5C under unconstrained conditions and constant compressive loads of 0.026 MPa and 1 MPa. Full-field thickness maps reveal an early onset of heterogeneous swelling with increasing charge rate, showing strain localization at cell edges and center. The maximum swelling overshoots during the CV/rest stages followed by partial relaxation, consistent with plating and stripping, whereas a plateau region of low-variance strain accompanies intercalation-dominated swelling. At 1.5C, strain relaxation is observed over essentially the full surface, indicating widespread plating, while most of the surface remain within the plateau regime at lower charge rates. Applying ∼1 MPa pressure reduces the plating-associated contribution, yielding thickness evolution close to the plateau strain at low charge rate. These results demonstrate that surround DIC provides a direct, high-throughput route to spatially resolve lithium plating in pouch cells and quantify how mechanical constraint mitigates plating-induced swelling. • Surround 3D DIC enables full-field thickness mapping in pouch cells during charging. • Heterogeneous swelling is observed with localization at the cell's edge and center. • CV/rest stages show swelling overshoot increasing with C-rate implying Li stripping. • Mechanically constrained charging shows lower swelling and hence reduced plating.
Source: openalex_inverted_index · Quality: baseline

Research context

OpenAlex topics: Advancements in Battery Materials · Advanced Battery Technologies Research · Advanced Sensor and Energy Harvesting Materials

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (38)

Show source-provided references
1. Assessing the transition towards battery electric vehicles: a multi-level perspective on drivers of, and barriers to, take up10.1016/j.tra.2017.10.004 ↗
2. Contestabile M, Offer GJ, Slade R, Jaeger F, Thoennes M. Battery electric vehicles, hydrogen fuel cells and biofuels. Which will be the winner? † n.d. https://doi.org/10.1039/c1ee01804c..
3. Electric vehicles batteries: requirements and challenges10.1016/j.joule.2020.01.013 ↗
4. The effects of non-uniform mechanical compression of lithium-ion cells on local current densities and lithium plating10.1149/1945-7111/ac33e1 ↗
5. Study of the influence of mechanical pressure on the performance and aging of lithium-ion battery cells10.1016/j.jpowsour.2019.227148 ↗
6. Understanding the dilation and dilation relaxation behavior of graphite-based lithium-ion cells10.1016/j.jpowsour.2016.03.078 ↗
7. Experimental investigation on reversible swelling mechanisms of lithium-ion batteries under a varying preload force10.3390/batteries9040218 ↗
8. Gas evolution during unwanted lithium plating in Li-Ion cells with EC-Based or EC-Free electrolytes10.1149/2.0711614jes ↗
9. Optimizing mechanical compression for cycle life and irreversible swelling of high energy and high power lithium-ion pouch cells10.1016/j.est.2023.109883 ↗
10. Modeling, validation, and analysis of swelling behaviors of lithium-ion batteries10.1016/j.est.2023.109499 ↗
11. Battery dimensional changes occurring during charge/discharge cycles—thin rectangular lithium ion and polymer cells10.1016/S0378-7753(03)00281-7 ↗
12. Rate dependence of swelling in lithium-ion cells10.1016/j.jpowsour.2014.05.039 ↗
13. High precision measurement of reversible swelling and electrochemical performance of flexibly compressed 5 Ah NMC622/graphite lithium-ion pouch cells10.1016/j.est.2022.106483 ↗
14. Huang W, Ye Y, Chen H, Vilá RA, Xiang A, Wang H, et al. Onboard early detection and mitigation of lithium plating in fast-charging batteries n.d. https://doi.org/10.1038/s41467-022-33486-4..
15. Investigation of temperature and pressure behaviour of constrained lithium ion cell under lithium plating conditions10.1149/1945-7111/aba550 ↗
16. Conformal pressure and fast-charging Li-Ion batteries10.1149/1945-7111/ac653f ↗
17. Yu
18. Lithium plating mechanism, detection, and mitigation in lithium-ion batteries10.1016/j.pecs.2021.100953 ↗
19. A look into the voltage plateau signal for detection and quantification of lithium plating in lithium-ion cells10.1016/j.jpowsour.2018.05.073 ↗
20. Nondestructive detection, characterization, and quantification of lithium plating in commercial lithium-ion batteries10.1016/j.jpowsour.2013.12.060 ↗
21. Lithium plating on graphite negative electrodes: innovative qualitative and quantitative investigation methods10.1149/2.0451514jes ↗
22. A new method for detecting lithium plating by measuring the cell thickness10.1016/j.jpowsour.2014.03.142 ↗
23. Hysteresis and current dependence of the graphite anode color in a lithium-ion cell and analysis of lithium plating at the cell edge10.1016/j.est.2017.10.015 ↗
24. State-of-Charge dependence of mechanical response of lithium-ion batteries: a result of internal stress10.1149/2.0051809jes ↗
25. Mechanism of inhomogeneous deformation and equal-stiffness design of large-format prismatic lithium-ion batteries10.1016/j.apenergy.2022.120494 ↗
26. Real-time displacement and strain mappings of lithium-ion batteries using three-dimensional digital image correlation10.1016/j.jpowsour.2014.07.184 ↗
27. In-situ measurements of mechanical and volume change of LiCoO2 lithium-ion batteries during repeated charge–discharge cycling by using digital image correlation10.1016/j.measurement.2016.09.023 ↗
28. Multiphysical field measurement and fusion for battery electric-thermal-contour performance analysis10.1016/j.apenergy.2020.114518 ↗
29. Optimum fast charging of lithium-ion pouch cells based on local volume expansion criteria10.1016/j.jpowsour.2018.04.095 ↗
30. Localized swelling inhomogeneity detection in lithium ion cells using multi-dimensional laser scanning10.1149/2.0011902jes ↗
31. Multi-directional laser scanning as innovative method to detect local cell damage during fast charging of lithium-ion cells10.1016/j.est.2016.09.002 ↗
32. Coupling X-ray computed tomography with digital volume correlation to study core collapse in lithium-ion batteries10.1039/D5EB00229J ↗
33. Quantifying bulk electrode strain and material displacement within lithium batteries via high-speed operando tomography and digital volume correlation
34. Lithiation-induced dilation mapping in a lithium-ion battery electrode by 3D X-ray microscopy and digital volume correlation10.1002/aenm.201300506 ↗
35. Using surround DIC to extract true stress–strain curve from uniaxial tension experiments
36. MLESAC: a new robust estimator with application to estimating image geometry10.1006/cviu.1999.0832 ↗
37. Lithium plating induced volume expansion overshoot of lithium-ion batteries: experimental analysis and modeling10.1016/j.jpowsour.2023.233946 ↗
38. Hysteresis and current dependence of the thickness change of lithium-ion cells with graphite anode10.1016/j.est.2017.04.006 ↗