The effect of applied voltage on the behavior of Ni- gadolinium-doped ceria cathodes in SOECs using 2D comb-shaped patterned cells
Source abstract
Abstract
Solid oxide electrolysis cells (SOECs), which are used for steam or co-electrolysis of H 2 O and CO 2 , are a promising clean energy technology. For commercialization, it is essential to understand long-term degradation mechanisms. To address the complexity of the porous structure of commercial cells and the associated challenges, this study employs a two-dimensional comb-shaped patterned cell. These patterned electrodes reproduce the cross-sectional geometry of conventional cells while avoiding the complexity of porous microstructures. In this configuration, Ni metal was applied as the cathode, and electrolysis experiments were conducted under various applied voltages. The results indicate that the effect of applied voltage on delamination is nonlinear, as the delamination sites vary with voltage. At −0.22 V, slight delamination occurred at the tips of the Ni stripes; at −0.47 V delamination became more pronounced. At the higher voltage of −0.94 V, the Ni tips adhere more strongly to the substrate and GDC shows a pronounced tendency to diffuse onto the Ni surface, while delamination initiates from the center of the cathode. These results demonstrate that the interaction between Ni and GDC is strongly dependent on the applied voltage, providing insights into optimized operating strategies. • Effect of applied voltage on Ni–GDC electrode under SOEC mode was investigated. • Two-dimensional comb-patterned cells enabled real-time observation of Ni evolution. • Ni stripes delaminated from the GDC layer at low and moderate applied voltages. • Higher voltages enhanced interaction between Ni and GDC, and promoted GDC diffusion onto Ni surface.
Source: openalex_inverted_index · Quality: baseline
Research context
OpenAlex topics: Advancements in Solid Oxide Fuel Cells · Molten salt chemistry and electrochemical processes · High-Temperature Coating Behaviors
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (36)
Show source-provided references
1. Advances in SOEC electrodes, electrolytes, and stacks: a review of materials innovation and intellectual patent trends10.1016/j.mseb.2025.118621 ↗
2. Recent advances in solid oxide cell technology for electrolysis10.1126/science.aba6118 ↗
3. Status and outlook of solid oxide cells for hydrocarbon fuel conversion10.1002/cssc.202501131 ↗
4. Analysis of electrochemical degradation phenomena of a 60-cell SOC stack operated in reversible SOFC/SOEC cycling mode10.1016/j.apenergy.2025.125565 ↗
5. Time-dependence of microstructural evolution and performance degradation of Ni/YSZ electrode in Co-Electrolysis SOEC10.1149/11106.1509ecst ↗
6. Solid oxide electrolysis cells - interplay between operating conditions, fuel electrode overpotential and degradation10.1016/j.ssi.2022.116127 ↗
7. Ni-SDC nanoparticles decorated Ni-YSZ fuel electrode for SOEC: a comprehensive strategy to optimize performance, syngas composition and stability for H2O-CO2 co-electrolysis10.1016/j.fuel.2025.134600 ↗
8. Theoretical insights into the factors affecting the electrochemical performance of solid oxide electrolysis cells for CO2 reduction10.1016/j.jece.2025.115696 ↗
9. Ni migration in solid oxide cell electrodes: review and revised hypothesis10.1002/fuce.202100072 ↗
10. Wettability analysis of Ni/YSZ interface under operating conditions of solid oxide cells10.1016/j.jpowsour.2025.237867 ↗
11. Understanding the Ni migration in solid oxide cell: a coupled experimental and modeling approach10.1149/1945-7111/acc1a3 ↗
12. Electrochemical analysis of temperature-dependent degradation mechanisms in Ni/YSZ fuel electrodes during high-temperature co-electrolysis10.1016/j.electacta.2025.147919 ↗
13. Enhanced CO2 electrolysis with the modification of Ni–YSZ cathodes by SDC in microtubular solid oxide electrolysis cells10.1021/acs.energyfuels.2c02788 ↗
14. Advanced microstructure characterization and microstructural evolution of porous cermet electrodes in solid oxide cells: a comprehensive review10.1016/j.enrev.2024.100104 ↗
15. Review of factors affecting the performance degradation of Ni-YSZ fuel electrodes in solid oxide electrolyzer cells10.1016/j.jpowsour.2024.234651 ↗
16. Au-doped Ni/GDC as an improved cathode electrocatalyst for H2O electrolysis in SOECs10.1016/j.apcatb.2018.05.017 ↗
17. Electrochemical and degradation behaviour of single cells comprising Ni-GDC fuel electrode under high temperature steam- and co-electrolysis conditions10.1016/j.jpowsour.2022.232436 ↗
18. Electrochemical impedance analysis and degradation behavior of a Ni-GDC fuel electrode containing single cell in direct CO2 electrolysis10.1016/j.jcou.2023.102423 ↗
19. Effect of Gd-doped ceria infiltration into Ni-YSZ on reversible solid oxide cell operation10.1016/j.jpowsour.2022.232189 ↗
20. Nonstoichiometry of Ce0.9Gd0.1O1.95−x10.1016/S0167-2738(97)00519-5 ↗
21. Expansion behavior of Ce1 − y GdyO 2.0 − 0.5y − δ under various oxygen partial pressures evaluated by HTXRD10.1149/1.1580133 ↗
22. Ni-GDC and Ni-YSZ electrodes operated in solid oxide electrolysis and fuel cell modes10.1299/jtst.2021jtst0013 ↗
23. Electronic transport in single crystals of gddoped ceria10.1149/1.2408943 ↗
24. Performance and degradation of electrolyte-supported single cell composed of Mo-Au-Ni/GDC fuel electrode and LSCF oxygen electrode during high temperature steam electrolysis10.3390/en15082726 ↗
25. Influence of initial powder morphology on polarization characteristics of nickel/gadolinium-doped-ceria solid oxide fuel cells electrode10.1149/2.0181902jes ↗
26. Study on Ni-ceramic cathode degradation in H2O electrolysis using a two-dimensional patterned cell10.1016/j.ijhydene.2025.03.236 ↗
27. Degradation of Ni-YSZ electrodes in solid oxide cells: impact of polarization and initial microstructure on the Ni evolution10.1149/2.1261915jes ↗
28. A parameter study of solid oxide electrolysis cell degradation: microstructural changes of the fuel electrode10.1016/j.electacta.2018.04.170 ↗
29. Influence of polarization on the morphological changes of nickel in fuel electrodes of solid oxide cells10.1149/1945-7111/ab6f5b ↗
30. Degradation study by 3D reconstruction of a nickel-yttria stabilized zirconia cathode after high temperature steam electrolysis operation10.1016/j.jpowsour.2014.07.066 ↗
31. Microstructure alteration analysis of Ni/YSZ cermet by comb-shaped Ni patterned electrode10.1149/1945-7111/ad83f6 ↗
32. Guidance to solid state electrochemical impedance spectroscopy10.1016/j.electacta.2025.146892 ↗
33. A mini-review on three-electrode configuration for solid oxide cells10.1016/j.enrev.2024.100128 ↗
34. Redox-induced self-modification of cermet anodes of Ni–CeO2-Based oxide for solid oxide fuel cells10.1149/2.0551713jes ↗
35. Self-modification of Ni metal surfaces with CeO2 to suppress carbon deposition at solid oxide fuel cell anodes10.1002/fuce.201600180 ↗
36. Multiscale microstructural evolutions of nickel-gadolinium doped ceria in solid oxide fuel cell anode10.1016/j.jpowsour.2020.228710 ↗