journal article·2025-07Open access

Current interrupt method for calculating the electrochemical impedance in a solid oxide electrolysis stack

Nathanael Royer, Kerry Meinhardt, Dustin McLarty, Olga A. Marina

Abstract

In this work the time domain response of Solid Oxide Electrolysis Cells (SOEC) to a current interruption was transformed into the frequency domain using a carrier function Laplace transform , which is fit to the experimental data using a MATLAB Complex Nonlinear Least Squares (CNLS) solver to obtain the complete impedance spectrum. The hardware implementation, consisting principally of a high-speed switch and a fast-logging Analog to Digital Converter (ADC), was assembled and tested using a calibration module to assess the accuracy, repeatability , and speed of acquisition of the prototype device as compared against a calibrated commercial impedance spectrometer. Additionally, the current interrupt device and commercial Frequency Response Analyzer (FRA) were used to acquire the impedance spectra of a four cell SOEC stack with a large, 300 cm 2 , active cell area.
Source: openalex_inverted_index · Quality: baseline

Research context

OpenAlex topics: Advancements in Solid Oxide Fuel Cells · Solid-state spectroscopy and crystallography · Gas Sensing Nanomaterials and Sensors

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (47)

Show source-provided references
1. Barsoukov · 2005
2. Analysis and compensation of PEM fuel cell instabilities in low-frequency EIS measurements10.1109/TIM.2013.2297632 ↗
3. J. Harper, M. Rust, B. Sayers, and A. Savage, “High Frequency, High Current Impedance Spectroscopy: Experimental Protocols Enabling Measurement up to 1MHz at High Current Densities.”..
4. E. Barsoukov, S. H. Ryu, and H. Lee, “A novel impedance spectrometer based on carrier function Laplace-transform of the response to arbitrary excitation.” [Online]. Available: www.elsevier.com/locate/jelechem..
5. A fast and simple electrochemical impedance spectroscopy measurement technique and its application in portable, low-cost instrument for impedimetric biosensing10.1016/j.jelechem.2011.04.011 ↗
6. A new impedance spectrometer for the investigation of electrochemical systems10.1063/1.1143404 ↗
7. Time-domain based impedance measurement: strengths and drawbacks
8. Y · 2000
9. New approach for the calculation of impedance spectra out of time domain data10.1016/j.electacta.2011.07.096 ↗
10. Spectroscopy · 2017 · 3
11. “Evaluation of electrochemical impedance spectra by the distribution of relaxation times,”10.2109/jcersj2.16267 ↗
12. The distribution of relaxation times as basis for generalized time-domain models for Li-ion batteries10.1016/j.jpowsour.2012.07.100 ↗
13. In-situ electrochemical characterization methods for industrial-sized planar solid oxide fuel cells part I: methodology, qualification and detection of carbon deposition10.1016/j.electacta.2016.05.025 ↗
14. Evaluation and modeling of the cell resistance in anode-supported solid oxide fuel cells10.1149/1.2801372 ↗
15. Ye · 1989
16. AC impedance and coulostatic studies on electrochemical detection of 2-Mercaptobenzothiazole in a copper electroless plating Bath10.1149/1.2096090 ↗
17. Novel instrumentation in electrochemical impedance spectroscopy and a full description of an electrochemical system10.1351/pac200678051069 ↗
18. 2014
19. Digital Impedance for Faradaic Analysis Introduction to Digital Signal Analysis and Impedance Measurements for Electrochemical and Corrosion Systems.”.
20. The impact of flow distributors on the performance of solid oxide fuel cell - part II: electrochemical impedance measurements10.1016/j.jpowsour.2011.04.021 ↗
21. Online measurement of battery impedance using motor controller excitation10.1109/TVT.2013.2293597 ↗
22. Diard · 1998
23. Development and demonstration of measurement-time efficient methods for impedance spectroscopy of electrode and sensor arrays10.3390/s8031774 ↗
24. Limitations of the potential step technique to impedance measurements using discrete time fourier transform10.1021/ac0493929 ↗
25. Reflections on the history of electrochemical impedance spectroscopy10.1016/j.electacta.2005.02.107 ↗
26. Electrochemical parameter identification-An efficient method for fuel cell impedance characterisation10.1016/j.jpowsour.2008.04.071 ↗
27. Studies on LiFePO 4 as cathode material in Li-ion batteries10.1149/1.3505456 ↗
28. Cole impedance extractions from the step-response of a current excited fruit sample10.1016/j.compag.2013.07.017 ↗
29. Method using square-pulse excitation for high-impedance spectroscopy of anticorrosion coatings10.1109/TIM.2010.2060219 ↗
30. Quantitative analysis of time-domain supported electrochemical impedance spectroscopy data of Li-Ion batteries: reliable activation energy determination at low frequencies10.1149/2.0511607jes ↗
31. Development of galvanostatic fourier transform electrochemical impedance spectroscopy10.1021/ac303108n ↗
32. Electrochemical impedance spectroscopy in solid state ionics: recent advances
33. Some practical aspects of the numerical laplace transformation for impedance analyses of electrochemical systems10.1016/0022-0728(89)87122-0 ↗
34. Sierra · 1978
35. Takano · 2000
36. Time domain electrical impedance measurement method for ultrasound transducer
37. Low frequency impedance data by laplace transformation of coulostatically induced transients10.1016/S0013-4686(97)00298-3 ↗
38. Frequency domain transform and the COULOSTATIC technique10.1515/CORRREV.2002.20.1-2.69 ↗
39. Optimization of the perturbation signal for electrochemical impedance spectroscopy in the time domain10.1063/1.1144316 ↗
40. Fast impedance spectroscopy: general aspects and performance study for single ion channel measurements10.1063/1.1150447 ↗
41. Diagnosis of PEM fuel cells through current interruption10.1016/j.jpowsour.2007.06.072 ↗
42. Electrical test methods for on-line fuel cell ohmic resistance measurement10.1016/j.jpowsour.2006.02.086 ↗
43. Investigation of porous electrodes by current interruption10.1149/1.2048537 ↗
44. Study of PEFCs by AC impedance, current interrupt, and dew point measurements10.1149/1.1630589 ↗
45. F. Richter, C.-A. Schiller, W. Strunz, and N. Wagner, “Current interrupt techniques as a completion of eis: struggling against mutual induction in fuel cells research and time saving in barrier coatings characterization.” [Online]. Available: http://accessimpedance.iusi.bas.bg..
46. MATLAB R2020b, The MathWorks, Inc., Natick, Massachusetts, United States.
47. System identification : a new modelling approach for sofc single cells