journal article·2016-01

Voltage equalization of an ultracapacitor module by cell grouping using number partitioning algorithm

E. Oyarbide, C. Bernal, P. Molina, L.A. Jiménez, R. Gálvez, A. Martínez

Publisher page

Abstract

Ultracapacitors are low voltage devices and therefore, for practical applications, they need to be used in modules of series-connected cells. Because of the inherent manufacturing tolerance of the capacitance parameter of each cell, and as the maximum voltage value cannot be exceeded, the module requires inter-cell voltage equalization. If the intended application suffers repeated fast charging/discharging cycles, active equalization circuits must be rated to full power, and thus the module becomes expensive. Previous work shows that a series connection of several sets of paralleled ultracapacitors minimizes the dispersion of equivalent capacitance values, and also the voltage differences between capacitors. Thus the overall life expectancy is improved. This paper proposes a method to distribute ultracapacitors with a number partitioning-based strategy to reduce the dispersion between equivalent submodule capacitances. Thereafter, the total amount of stored energy and/or the life expectancy of the device can be considerably improved.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Supercapacitor Materials and Fabrication · Advanced Battery Technologies Research · Electric and Hybrid Vehicle Technologies

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (16)

Show source-provided references
1. Ultracapacitor-based plug & play energy-recovery system for elevator retrofit
2. The ultracapacitor-based regenerative controlled electric drives with power-smoothing capability10.1109/TIE.2011.2181129 ↗
3. Constant-current regulator-based battery-supercapacitor hybrid architecture for high-rate pulsed load applications10.1016/j.jpowsour.2011.12.043 ↗
4. Power split strategies for hybrid energy storage systems for vehicular applications10.1016/j.jpowsour.2014.01.118 ↗
5. Evaluation of a hybrid energy storage module for pulsed power applications10.1109/TPS.2014.2298369 ↗
6. Supercapacitor energy storage for magnetic resonance imaging systems10.1109/TIE.2013.2282596 ↗
7. Renewable energy-powered membrane technology: supercapacitors for buffering resource fluctuations in a wind-powered membrane system for brackish water desalination10.1016/j.renene.2012.05.026 ↗
8. Application of explicit model predictive control to a hybrid battery ultracapacitor power source10.1016/j.jpowsour.2014.11.148 ↗
9. Stationary and on-board storage systems to enhance energy and cost efficiency of tramways10.1016/j.jpowsour.2014.04.070 ↗
10. Study of the ageing process of a supercapacitor module using direct method of characterization10.1109/TEC.2012.2186814 ↗
11. A supercapacitor stack-design and characteristics
12. “Ageing behaviour of electrochemical double layer capacitors. Part II. Lifetime simulation model for dynamic applications”10.1016/j.jpowsour.2007.07.059 ↗
13. A practical approach for ride through of super capacitor energy storage based ASD system
14. Research on combination of series and parallel with supercapacitor module
15. Multi-way number partitioning
16. Ageing behaviour of electrochemical double layer capacitors. Part I. Experimental study and ageing model10.1016/j.jpowsour.2007.07.021 ↗